An experimental investigation of exhaust waste heat recycling by thermoelectric generators under different thermal conditions for internal combustion engines
Restricted accessResearch articleFirst published online October, 2018
An experimental investigation of exhaust waste heat recycling by thermoelectric generators under different thermal conditions for internal combustion engines
Almost 70% of heat power produced by pistons in internal combustion engines is lost due to exhaust and cooling. In the course of the heating process, 25% of useful energy transfers to the exit shaft. There have been a lot of studies on recycling waste heat of internal combustion engines, especially on cooling and exhaust systems. A thermoelectric generator is an important way to recycle waste energy in exhaust systems of internal combustion engines. In this study, an air-cooled thermoelectric generator was designed to recycle waste heat energy in exhaust systems of internal combustion engines and its performance was tested. Waste heat recycling tests were conducted by measuring voltage, current, and power values under different thermal conditions depending on the change in load resistance. The results obtained were compared with the results of analyses and experiments. Maximum voltage value at RI = 45Ω load resistance was obtained as 11.03 V (experiment) and 11.22 V (analysis), and maximum current value at RI = 5Ω load resistance as 0.42 A (experiment) at Th = 250°C, ΔT = 40°C.
YangJ. Potential applications of thermoelectric waste heat recovery in the automotive industry. In: 24th International conference on thermoelectrics, Clemson, SC, 19–23 June 2005, pp.155–159. New York: IEEE.
2.
AnderssonBS.Company perspectives in vehicle tribology: Volvo. In: 17th Leeds-Lyon symposium on tribology (ed DowsonDTaylorCMGodetM), Amsterdam, 1991, pp.503–506. Oxford: Elsevier Ltd.
3.
MahliaTMISaidurRMemonLAet al. A review on fuel economy standard for motor vehicles with the implementation possibilities in Malaysia. Renew Sustain Energy Rev2010; 14: 3092–3099.
4.
PriestMTaylorCM.Automobile engine tribology: approaching the surface. Wear2000; 241: 193–203.
5.
ConklinJCSzybistJP.A highly efficient six-stroke internal combustion engine cycle with water injection for in-cylinder exhaust heat recovery. Energy2010; 35: 1658–1664.
6.
DolzVNovellaRGarciaAet al. HD Diesel engine equipped with a bottoming Rankine cycle as a waste heat recovery system. Part 1. Study and analysis of the waste heat energy. Appl Therm Eng2012; 36: 269–278.
7.
WangTZhangYZhangJet al. Analysis of recoverable exhaust energy from a light-duty gasoline engine. Appl Therm Eng2013; 53: 414–419.
8.
MoriMYamagamiTOdaNet al. Current possibilities of thermoelectric technology relative to fuel economy. SAE paper 2009-01-0170, 2009.
9.
HussainQEBrighamDRMaranvilleCW.Thermoelectric exhaust heat recovery for hybrid vehicles. SAE paper 2009-01-1327, 2009.
10.
StobartRWeerasingheR.Heat recovery and bottoming cycles for SI and CI engines: a perspective. SAE paper 2006-01-0662, 2006.
11.
StobartRKWijewardaneAAllenC.The potential for thermo-electric devices in passenger vehicle applications. SAE paper 2010-01-0833, 2010.
12.
HeremansJP.Thermoelectric materials and energy conversion cycles for mobile applications. Basic Research Needs to Assure a Secure Energy Future - DOE Report from the Basic Energy Sciences Advisory Committee, February2003.
13.
ZhangXChauKTChanCC.Overview of thermoelectric generation for hybrid vehicles. J Asian Electr Veh2008; 6: 1119–1246.
14.
ZhangXChauKT.An automotive thermoelectric–photovoltaic hybrid energy system using maximum power point tracking. Energy Convers Manage2011; 52: 641–647.
15.
SaidurRRahimNAHasanuzzamanM.A review on compressed-air energy use and energy savings. Renew Sustain Energy Rev2010; 14: 1135–1153.
16.
ChenMRosendahlLACondraTJet al. Numerical modelling of thermoelectric generators with varying material properties in a circuit simulator. IEEE Trans Energy Convers2009; 24: 112–124.
17.
AhıskaRDislitasSOmerG.A new method and computer-controlled system for measuring the time constant of real thermoelectric modules. Energy Convers Manage2012; 53: 314–321.
18.
NuwayhidRYShihadehAGhaddarN.Development and testing of a domestic woodstove thermoelectric generator with natural convection cooling. Energy Convers Manage2005; 46: 1631–1643.
19.
RoweDMMinG.Evaluation of thermoelectric modules for power generation. J Power Sources1998; 73: 193–198.
20.
HunSHYunHKSeoYKet al. Performance measurement and analysis of a thermoelectric power generator. In: 12th IEEE intersociety conference on thermal and thermomechanical phenomena in electronic systems (ITherm), Las Vegas, NV, 2–5 June 2010. New York: IEEE.
21.
BirkholzUGrobEStohrerUet al. Conversion of waste exhaust heat in automobiles using FeSi2 thermoelements. In: Proceedings of the 7th international conference on thermoelectric energy conversion, Arlington, VA, 1988, pp.124–128. New York: IEEE.
22.
BassJCCampanaRJElsnerNB. Thermoelectric generator for diesel engines. In: Proceedings of the 1990 coatings for advanced heat engines workshop, Castine, ME, August1990. US Department of Energy.
23.
BassJCCampanaRJElsnerNB. Thermoelectric generator for diesel trucks. In: Proceedings of the 10th international conference on thermoelectrics (ed RoweDM), Cardiff, UK, 1991. Cardiff, UK: Babrow Press.
24.
BassJCElsnerNBLeavittFA. Performance of the 1 kW thermoelectric generator for diesel engines. In: Proceedings of the 13th international conference on thermoelectrics (ed MathiprakisamB), New York, 1995.
25.
BassJC.Thermoelectric generator for motor vehicle. Patent 5,625,245, USA, 1997.
26.
BassJCElsnerNBLeavitA.Method for fabricating a thermoelectric module with gapless egg crate. Patent 5,856,210, USA, 1999.
27.
KobayashiMIkomaKFuruyaKet al. Thermoelectric generation and related properties of conventional type modüle based on Si-Ge alloys. In: Proceedings of the 15th international conference on thermoelectrics, Pasadena, CA, 26–29 March 1996.
28.
IkomaKMunkiyoMFuruyaKet al. Thermoelectric generator for gasoline engine using Bi2Te3 modules. J Jpn Inst Met1999; 63: 1475–1478.
29.
MartinsJBritoPFGoncalvesLMet al. Thermoelectric exhaust energy recovery with temperature control through heat pipes. SAE Int2011; 315: 1–19.
30.
AlexanderDSStevenRADanielJI.Motorcycle waste heat energy harvesting. Proc SPIE2008; 6930: 775783.
31.
YamashitaO.Effect of temperature dependence of electrical resistivity on the cooling performance of a single thermoelectric element. Appl Energy2008; 85: 1002–1014.
32.
YamashitaO.Effect of linear and non-linear components in the temperature dependence of thermoelectric properties on the cooling performance. Appl Energy2009; 86: 1745–1756.
33.
MontecuccoASiviterJKnoxAR.The effect of temperature mismatch on thermoelectric generators electrically connected in series and parallel. Appl Energy2014; 123: 47–54.
