Many mechanisms and processes can cause deterioration and ultimately failure of water distribution pipes during in-service operation, amongst these is damage caused by metal fatigue. This paper summarises an attempt at formalising a novel methodology suitable for estimating the number of years taken for a through thickness fatigue crack to form in this complex scenario. The devised method is based on the so-called modified Wöhler curve method and can be applied to estimate fatigue damage of water pipes independently from the degree of multiaxiality and non-proportionality of the load history. The computational approach of the proposed fatigue life estimation technique makes full use of an incremental procedure: fatigue damage is evaluated year by year by assuming that all variable involved in the process can change over time. The detrimental effect of corrosion pits is directly accounted for by treating them as conventional notches whose size increases with time. Finally, by taking as reference information the number of years for a blowout hole to form, the proposed approach is used to show how the lifetime of grey cast iron pipes can be remarkably shortened by fatigue.
SkipworthPEngelhardtMCashmanA. Whole life costing for water distribution network management, London: Thomas Telford Publishing, 2002.
2.
Boxall JB, O’Hagan A, Pooladsaz S, et al. Pipe level estimation of burst rates in water distribution mains. In: Proceedings of 8th conference on computing and control for the water industry: Water management for the 21st century, 5–7 September 2005, Exeter, UK.
3.
BoxallJBO’HaganAPooladsazS. Estimation of burst rates in water distribution mains. Proc Inst Civil Eng Water Manage2007; 160(WM2): 73–82.
4.
BoxallJBO'HaganAPooladsazS. Estimation of burst rates in water distribution mains. Water Manage2007; 160: 73–82.
5.
Rajani B and Tesfamariam S. Estimating time to failure of ageing cast iron water mains under uncertainties. In: Proceedings of 8th conference on computing and control in the water industry: Water management for the 21st century, 5–7 September 2005, Exeter, UK, pp.1–7.
6.
KleinerYBalvantR. Comprehensive review of structural deterioration of water mains: Statistical methods. Urban Water2001; 3: 131–150.
7.
Makar MJ. Failure analysis for grey cast iron water pipes. In: 1999 AWWA distribution system symposium, Reno, NV, USA, 19–21 September 1999.
8.
MakarMJ. A preliminary analysis of failures in grey cast iron water pipes. Eng Failure Anal2000; 7(1): 43–53.
9.
RajaniBZhanCKuraokaS. Pipe-soil interaction analysis of jointed water mains. Can Geotech J1966; 33(3): 393–404.
10.
Rajani BB and Kleiner Y. Fatigue failure of large-diameter cast iron mains. In: Water distribution system analysis 2010 - WDSA2010, Tucson, AZ, USA, 12–15 September 2010, pp.1–13.
11.
MakarJMMcDonaldSE. The mechanical behaviour of spun-cast grey iron pipe. J Mater Civil Eng2007; 19(10): 826–833.
12.
MakarJMRajaniB. Grey cast iron water pipe metallurgy. J Mater Civil Eng2000; 12(3): 245–253.
13.
Makar JM, Desnoyers R and McDonald SE. Failure modes and mechanisms in gray cast iron pipe. In: Proceedings of underground infrastructure research: Municipal, industrial and environmental applications, Kitchener, Ontario, Canada, 10–13 June 2001, pp.1–10.
14.
Kleiner Y, Sadiq R and Rajani B. Modeling failure risk in buried pipes using fuzzy Markov deterioration process. In: ASCE international conference on pipeline engineering and construction, San Diego, USA, 2–4 August 2004.
15.
MohebbiHJessonDAMulheronMJ. Characterisation of the fatigue properties of cast irons used in the water industry and the effect on pipe strength and performance. J Phys: Conf Ser2009; 181: 012039–012039.
16.
Bardet JP, Ballantyne D, Bell GEC, et al. Expert review of water system pipeline breaks in the city of Los Angeles during Summer 2009. Report to the Steering Committee on Water Pipeline Breaks of the City of Los Angeles, 9 April 2010.
RajaniBMakarJ. A methodology to estimate remaining service life of grey cast iron water mains. Can J Civil Eng2000; 27: 1259–1272.
19.
MohebbiMLiCQ. Experimental investigation on corrosion of cast iron pipes. Int J Corrosion2011. Article ID: 506501.
20.
Makar JM and Desnoyers R. Three dimensional mapping of corrosion pits in cast iron pipe using the remote field effect. In: Proceedings of underground infrastructure research: Municipal, industrial and environmental applications, Kitchener, Ontario, 10–13 June 2001, pp.1–10.
21.
AhammedMMelchersRE. Reliability of underground pipelines subject to corrosion. J Transport Eng1994; 120(6): 989–1002.
22.
ShreirLL. Corrosion, New York, NY: John Wiley & Sons, Inc, 1963.
23.
LaQueFLThe corrosion resistance of ductile iron. In: SzeligaMJ (ed.). Corrosion of ductile corrosion of ductile iron piping, Houston, Texas, USA: NACE International, 1995, pp. 127–135. . ISBN 1-877914-99-1.
24.
Rajani B, Makar J, McDonald S, et al. Investigation of grey cast iron water mains to develop a methodology for estimating service life. American Water Works Association Research Foundation, Denver, CO, USA, 2000.
25.
BeckTRChanSG. Experimental observations and analysis of hydrodynamic effects on growth of small pits. Corrosion1981; 37(11): 665–671.
26.
EfirdKDFlow effects on corrosion. In: Winston RevieR (ed.). Uhlig’s corrosion handbook, New York, NY: John Wiley & Sons, 2011, pp. 203–214.
27.
WhartonJAWoodRJK. Influence of flow conditions on the corrosion of AISI 304L stainless steel. Wear2004; 256: 525–536.
28.
JimenezJ. Cascades in wall-bounded turbulence. Annu Rev Fluid Mech2012; 44: 47–45.
29.
AdrianRJMarusevicI. Coherent structures in flow over hydraulic engineering surfaces. J Hydraul Res2012; 50(5): 451–464.
30.
Sarohia V. Experimental and analytical investigation of oscillations in flows over cavities. PhD Thesis, California Institute of Technology, USA, 1975.
31.
FaureTMAdrianosPLusseyranF. Visualization of the flow inside an open cavity at medium range Reynolds numbers. Exp Fluids2007; 42(2): 169–184.
32.
GarrisonBRogersC. An experimental study of enhanced fluid transfer mechanism between a channel and a cavity. Phys Fluids1994; 6: 421–423.
33.
StrangEFernandoH. Shear-induced mixing and transport from a rectangular cavity. J Fluids Mech2004; 520: 23–49.
34.
TaniguchiYEvansJW. Some measurements of the penetration of turbulence into small cavities. Int J Heat Mass Transfer1993; 36(4): 961–965.
35.
JuvinallRCMarshekKM. Fundamentals of machine component design, New York, NY: John Wiley & Sons, 1991.
36.
PetersonRENotch sensitivity. In: SinesGWaismanJL (eds). Metal fatigue, New York, NY: McGraw Hill, 1959, pp. 293–306.
37.
Lee Y-L, Pan J, Hathaway RB, et al. Fatigue testing and analysis. Oxford, UK: Elsevier Butterworth–Heinemann, 2005.
38.
HeywoodRE. Designing against fatigue, London: Chapman and Hall, 1962.
39.
PilkeyWDPilkeyDF. Peterson’s stress concentration factors, 3rd ed. New York, NY: John Wiley and Sons, 2008.
40.
Iurzolla E. Il calcolo dei recipienti in pressione. Cortina, Padova, Italy, 1981.
41.
SusmelL. Multiaxial notch fatigue: From nominal to local stress-strain quantities, Cambridge, UK: Woodhead & CRC, 2009.
42.
WahabMASakanoM. Corrosion and biaxial fatigue of welded structures. J Mater Process Technol2003; 143–144: 410–415.
43.
Socie DF and Marquis GB. Multiaxial fatigue. SAE, 2000.
44.
Rajani B. Investigation of grey cast iron water mains to develop a methodology for estimating service life. AWWA Research Foundation & American Water Work Association, USA, 2000.
45.
MillerKJO’DonnellWJ. The fatigue limit and its elimination. Fatigue Fract Eng Mater Struct1999; 22: 545–557.
46.
HaibachE. Betriebsfestigkeit—Verfahren und Daten zur Bauteilberechnung, Düsseldorf, Germany: VDI-Verlag GmbH, 1989.
47.
LinC-KYangC-HWangJ-H. Corrosion fatigue of austempered ductile iron. J Mater Sci2003; 38(8): 1667–1672.
48.
SusmelLLazzarinP. A bi-parametric modified Wöhler curve for high cycle multiaxial fatigue assessment. Fatigue Fract Eng Mater Struct2002; 25: 63–78.
49.
LazzarinPSusmelL. A stress-based method to predict lifetime under multiaxial fatigue loadings. Fatigue Fract Eng Mater Struct2003; 26: 1171–1187.
50.
SusmelL. A simple and efficient numerical algorithm to determine the orientation of the critical plane in multiaxial fatigue problems. Int J Fatigue2010; 32: 1875–1883.
51.
SusmelLTovoR. Estimating fatigue damage under variable amplitude multiaxial fatigue loading. Fatigue Fract Eng Mater Struct2011; 34: 1053–1077.
52.
SusmelL. Multiaxial fatigue limits and material sensitivity to non-zero mean stresses normal to the critical planes. Fatigue Fract Eng Mater Struct2008; 31: 295–309.
53.
Matsuishi M and Endo T. Fatigue of metals subjected to varying stress. The Japan Society of Mechanical Engineers, Fukuoka, Japan, 1968.
54.
PalmgrenA. Die Lebensdauer von Kugellagern. Verfahrenstechnik1924; 68: 339–341.
55.
MinerMA. Cumulative damage in fatigue. J Appl Mech1945; 67: AI59–AI64.
56.
SonsinoCM. Fatigue testing under variable amplitude loading. Int J Fatigue2007; 29(6): 1080–1089.
57.
StephensRIFatemiAStephensRR. Metal fatigue in engineering, 2nd ed. New York, NY: Wiley, 2000.
58.
SchijveJ. Fatigue of structures and materials, Netherlands: Kluwer, 2001.
59.
SusmelLTaylorD. Taking full advantage of nominal stresses to design notched components against variable amplitude multiaxial fatigue. Key Eng Mater2012; 488–489: 747–750.
60.
SusmelLTaylorD. Two methods for predicting the multiaxial fatigue limits of sharp notches. Fatigue Fract Eng Mater Struct2003; 26: 821–833.
61.
SusmelL. A unifying approach to estimate the high-cycle fatigue strength of notched components subjected to both uniaxial and multiaxial cyclic loadings. Fatigue Fract Eng Mater Struct2004; 27: 391–411.
62.
SusmelLTaylorD. The modified Wöhler curve method applied along with the theory of critical distances to estimate finite life of notched components subjected to complex multiaxial loading paths. Fatigue Fract Eng Mater Struct2008; 31(12): 1047–1064.
63.
SusmelLTaylorD. A critical distance/plane method to estimate finite life of notched components under variable amplitude uniaxial/multiaxial fatigue loading. Int J Fatigue2012; 38: 7–24.
64.
SusmelLTaylorD. The theory of critical distances to estimate lifetime of notched components subjected to variable amplitude uniaxial fatigue loading. Int J Fatigue2011; 33: 900–911.
