In this study, variations of local heat transfer coefficient are obtained in subcooled flow boiling conditions for water/TiO2 nanofluid in a vertical and horizontal tube. The results for the base fluid are compared with the predictions of the well known Shah correlation and Gnielinski formula for laminar and turbulent flows for single-phase forced convection and also with Chen correlation for subcooled flow boiling. A good agreement between the results is realized. At the subcooled regime, heat transfer coefficient of nanofluid is less than that of the base fluid and it decreases by increasing nanoparticle concentration for both of the channels; however, addition of the nanopraticles into the fluid causes that the vapor volume fraction increases.
Eastman JA, Choi US, Li S, et al. Enhanced thermal conductivity through the development of nanofluids. In: Proceedings of the symposium on nanophase and nanocomposite materials II, Boston, MA, USA, 2–6 December, 1997, vol. 457, pp.3–11. Materials Research Society: Warrendale, PA.
2.
LiCHPetersonGP. Experimental investigation of temperature and volume fraction variations on the effective thermal conductivity of nanoparticle suspensions (nanofluids). J Appl Phys2006; 99: 084314–1–8.
3.
XuanYLiQ. Investigation on convective heat transfer and flow features of nanofluids. J Heat Transfer2003; 125: 151–155.
4.
BangCChangSH. Boiling heat transfer performance and phenomena of Al2O3–water nano-fluids from a plain surface in a pool. Int J Heat Mass Transfer2005; 48: 2407–2419.
5.
KimSJBangICBuongiornoJ. Surface wettability change during pool boiling of nanofluids and its effect on critical heat flux. Int J Heat Mass Transfer2007; 50: 4105–4116.
6.
Tu JP, Dinh N and Theofanous T. An experimental study of nanofluid boiling heat transfer. In: Proceedings of 6th international symposium on heat transfer, Beijing, China, 15–19 June 2004.
7.
Tu JP, Dinh N and Theofanous TG. Burnout in high heat flux boiling: the hydrodynamic and physic-chemical factors. In: 42nd AIAA aerospaces sciences meeting and exhibit, 5–6 January 2004, Reno, NV, USA.
8.
ParkKJJungD. Enhancement of nucleate boiling heat transfer using carbon nanotubes. Int J Heat Mass Transfer2007; 50: 4499–4502.
9.
WenDDingY. Experimental investigation into the pool boiling heat transfer of aqueous based γ-alumina nanofluids. J Nanopart Res2005; 7(2): 265–274.
10.
LvLCLiuZH. Boiling characteristics in small vertical tubes with closed bottom for nanofluids and nanoparticles-suspensions. Heat Mass Transfer2008; 45: 1–9.
11.
DasSKPutraNRoetzelW. Pool boiling characteristics of nanofluids. Int J Heat Mass Transfer2003; 46: 851–862.
12.
Kim SJ. Pool boiling heat transfer characteristics of nanofluids. MSc Thesis, Massachusetts institute of technology, USA, 2007.
13.
Li CH, Wang BX and Peng XF. Experimental investigations on boiling of nano-particle suspensions. In: Proceedings of the 5th international conference on boiling heat transfer conference, Montego Bay, Jamaica, 4–8 May 2003.
14.
LiuZHYangXFXiongJG. Boiling characteristics of carbon nanotube suspensions under sub-atmospheric pressures. Int J Therm Sci2010; 49(7): 1156–1164.
15.
KwarkSMKumarRMorenoG. Pool boiling characteristics of low concentration nanofluids. Int J Heat Mass Transfer2010; 53: 972–981.
16.
SuriyawongAWongwisesS. Nucleate pool boiling heat transfer characteristics of TiO2-water nanofluids at very low concentrations. Exp Therm Fluid Sci2010; 34(8): 992–999.
17.
Situ R, Tu JY, Yeoh GH, et al. Assessment of effect of bubble departure frequency in forced convection subcooled boiling. In: 16th Australasian fluid mechanics conference, Crown Plaza, Gold Coast, Australia, 2–7 December 2007.
18.
PengHDingGJiangW. Heat transfer characteristics of refrigerant-based nanofluid flow boiling inside a horizontal smooth tube. Int J Refrig2009; 32(6): 1259–1270.
19.
KimSJMcKrellTBuongiornoJ. Subcooled flow boiling heat transfer of dilute alumina, zinc oxide, and diamond nanofluids at atmospheric pressure. Nucl Eng Des2010; 240: 1186–1194.
20.
YouSMKimJHKimKH. Effect of nanoparticles on critical heat flux of water in pool boiling heat transfer. Appl Phys Lett2003; 83: 3374–3376.
21.
Witharana S. Boiling of refrigerants on enhanced surfaces and boiling of nanofluids. PhD Thesis, The Royal Institute of Technology, Sweden, 2003.
22.
DasSKPutraNRoetzelW. Pool boiling characteristics of nano-fluids. Int J Heat Mass Transfer2003; 46: 851–862.
23.
ZhouDW. Heat transfer enhancement of copper nanofluid with acoustic cavitation. Int J Heat Mass Transfer2004; 47(14–16): 3109–3117.
24.
VassalloPKumarRAmicoSD. Pool boiling heat transfer experiments in silica–water nano-fluids. Int J Heat Mass Transfer2004; 47: 407–411.
25.
DingYChenHWangL. Heat transfer intensification using nanofluids. KONA2007; 25(25): 23–38.
26.
PrakashNGAnoopKBDasSK. Mechanism of enhancement/deterioration of boiling heat transfer using stable nanoparticles suspensions over vertical tubes. J Appl Phys2007; 102: 074317-1–7–074317-1–7.
27.
ShiMHShuaiMQChenZQ. Study on pool boiling heat transfer of nano-particle suspensions on plate surface. J Enhanced Heat Transfer2007; 14(3): 223–231.
28.
Truong BH. Determination of pool boiling critical heat flux enhancement in nanofluids. Undergraduate Thesis, MIT, USA, May 2007.
29.
ChopkarMDasAKMannaI. Pool boiling heat transfer characteristics of ZrO2–water nanofluids from a flat surface in a pool. Heat Mass Transfer2007; 44: 999–1004.
30.
PrakashNGAnoopKBSateeshG. Effect of surface orientation on pool boiling heat transfer of nanoparticle suspensions. Int J Multiphase Flow2008; 34: 145–160.
31.
TrisaksriVWongwisesS. Nucleate pool boiling heat transfer of TiO2-R141b nanofluids. Int J Heat Mass Transfer2009; 52(5–6): 1582–1588.
32.
HendersonKParkYGLiuL. Flow-boiling heat transfer of R-134a-based nanofluids in a horizontal tube. Int J Heat Mass Transfer2010; 53: 944–951.
33.
Shah RK. Thermal entry length solutions for the circular tube and parallel plates. In: Proceedings of the 3rd national heat and mass transfer conference, Indian Institute of Technology, Bombay, I (Paper HMT-11-75), 11–13 December, 1975.
34.
GnielinskiV. New equations for heat and mass transfer in turbulent pipe and channel flow. Int Chem Eng1976; 16: 359–368.
35.
ChenJC. Correlation for boiling heat transfer to saturated fluids in convective flow. Ind Eng Chem Process Des Dev1966; 5(3): 322–329.
36.
Torikai K, Hori M, Akiyama M, et al. Boiling heat transfer and burnout mechanism in boiling-water cooled reactor. In: Third United Nations international conference on the peaceful uses of atomic energy, Geneva, Switzerland, 31 August–9 September 1964, paper no. 28, p.580.
37.
SnyderNWRobinTT. Mass-transfer model in subcooled nucleate boiling. J Heat Transfer1969; 91: 404–412.
38.
PhanHTCaneyNMartyP. Surface wettability control by nanocoating: the effects on pool boiling heat transfer and nucleation mechanism. Int J Heat Mass Transfer2009; 52: 5459–5471.
39.
AhnHSKimMH. The effect of micro/nanoscale structures on CHF enhancement. Nucl Eng Technol2011; 43: 205–216.
