Design of surface micro texture in the cutter-chip contact area of a cemented carbide cutter

Abstract

Placing micro textures on a cutter surface can enhance the cutter-chip and cutter-workpiece contact, improving the cutter performance and machined surface quality. However, both the proper placement of micro textures and careful modeling of their density function are required for optimizing the cutting performance. In this study, a ball end milling cutter was utilized to demonstrate how these can be achieved. Initially, the theoretical cutter-chip contact length of the was calculated based on the chip curl theory and the theoretical cutter-chip contact area was obtained by combining the theories of cutter contact area and micro texture placement. Then, a mathematical model describing the micro texture distribution was established using a uniform density function, which allowed the determination of the specific distribution model for the micro textures. Finally, both simulations and experiments were used to validate the accuracy of the theoretical solution for the cutter-chip contact area and the uniformity of the micro texture density function. The results showed that the theoretical cutter-chip contact area and the uniform micro texture density mathematical model are consistent with the simulation and experimental results. The results reported in this paper provide a theoretical basis for the accurate preparation of micro textures.