Three-Dimensional Fracture Analysis and Experimental Investigation of Model Unidirectional Discontinuous Tow Composite Laminates

Abstract

The purpose of this work is to perform analytical modeling and experimentally produce idealized composites reinforced with discontinuous fiber tows to evaluate the theoretical upper limits of tensile strength as compared to continuous fiber composites. The idealized composite represents a staggered mosaic of prepreg tape strips of equal width and length. Three-dimensional analysis was performed to evaluate the energy release rate of the possible damage accumulation modes, such as vertical splits and delaminations emanating from tape strip ends. Realistic estimates of the failure strain of the discontinued tow composites was obtained by comparing the calculated energy release rates to the critical Mode II energy release for axial cracking in the material system. The predicted failure strain as a function of the strip geometry was also in good correlation with the experimental results.

References

1. Scala, E. and Schuster, D.M. (1968). Single and multi fiber interactions in discontinuously reinforced composites. AIAA Journal, 6: 527-532.

2. Papthanasiou, T.D. (1995). A micro-mechanical investigation of empirical models for the effective properties of aligned short-fiber composites. Advanced Composite Letters, 4(1): 5-11.

3. Piggott, M.R. , Ko, M. and Chuang, H.Y. (1993). Aligned short-fiber reinforced thermosets-experiments and analysis lend little support for established theory. Composites Science and Technology, 48: 291-300.

4. Sun, C.T. and Wu, J.K. (1984). Stress distribution of aligned short-fiber composites under axial load. Journal of Reinforced Plastics and Composites, 3: 130-144.

5. Aboudi, J. (1983). The effective moduli of short-fiber composites. Int. J. Solids and Structures, 19(8): 696-707.

6. Takao, Y. , Taya, M. and Chou, T.W. (1982). Effects of fiber-end cracks on the stiffness of aligned short-fiber composites. International Journal of Solids and Structures, 18(8): 723-728.

7. Fukuda, H. and Chou, T.W. (1982). A probabilistic theory of the strength of short-fiber composites with variable fiber length and orientation. Journal of Material Science, 17: 1003-1011.

8. Whitney, J.M. Stiffness enhancement in aligned, short-fiber composites: a computational and experimental investigation. Journal of Reinforced Plastics, 16(8): 714-730.

9. Rondeau, R. , Reeve, S. and Bond, G. (1999). The effect of tow and filament groups on the properties of discontinuous fiber composites. 44th International SAMPE Symposium and Exhibition, Long Beach, CA.

10.

10. Iarve, E.V. (1996). Spline variational three-dimensional stress analysis of laminated composite plates with open holes. International Journal of Solids Structures, 44(14): 2095-2118.

11.

11. Pagano, N.J. and Kim, R. (2000). Secondary cracking (t- or h-cracks) in unidirectional composites. In: Proceedings of 15th Technical Conference of American Society of Composites. College Station, TX.