A Unified Micromechanical Model for the Mechanical Properties of Two Constituent Composite Materials. Part IV: Rubber-Elastic Behavior

Abstract

This series of papers reports a new, general, and unified micromechanical model for estimating the three-dimensional mechanical properties of a composite made from two constituent materials, i.e., continuous fiber and matrix. The present paper addresses the application of the model to rubber-based composites, with a focus on prediction of the entire stress-strain response characteristic of a composite having an elastomer matrix constituent material. For this purpose, an accurate constitutive theory has been developed for any incompressible rubber-like material. Its incremental stress-strain relationship at any given level is simply correlated by a load-dependent compliance matrix, similar to Hooke's law. The theory is consistent in that when the involved material parameters, i.e., the load-dependent Young's modulus and Poisson's ratio, are determined using a single type of test data such as uniaxial tension data, it is then able to predict precisely the material responses to other types of deformation conditions. Combining the incremental theory with the unified model developed in Parts I and II, an analysis procedure for the overall properties of elastomer-based composites follows. As an application, an interlock weft-knitted polyester-fiber fabric-reinforced polyurethane elastomer composite is investigated. Favorable correlation has been found between the theoretical and experimental results.

Keywords

rubber-like material hyper-elasticity constitutive relationship rubberbased composite textile composite mechanical property micromechanical approach unified model stress-strain response

References

1. Huang, Z. M. , A Unified Micromechanical Model for the Mechanical Properties of Two Constituent Composite Materials. Part I: Elastic Behaviour, submitted to J. Thermoplastic Composite Materials.

2. Huang, Z. M. , A Unified Micromechanical Model for the Mechanical Properties of Two Constituent Composite Materials. Part II: Plastic Behaviour, submitted to J. Thermoplastic Composite Materials.

3. Huang, Z. M. , A Unified Micromechanical Model for the Mechanical Properties of Two Constituent Composite Materials. Part III: Strength Behaviour, submitted to J. Thermoplastic Composite Materials.

4. Adkins, J. E. and Rivlin, R. S. , 1995, Large Elastic Deformation of Isotropic Materials X: Reinforcements by Inextensible Cords, Phil. Trans. Royal Soc. London, (A), Vol. 248, pp. 201-223.

5. Pinkin, A. C. and Roger, T. G. , 1971, Plane Deformation of Incompressible Fiber-Reinforced Materials, J. Appl. Mech., Vol. 38, pp. 634-640.

6. Spencer, A. J. M. , 1972, Deformation of Fiber Reinforced Materials, Clarendon Press, Oxford.

7. Pipkin, A. C. , 1974, Finite Deformations of Ideal Fiber-Reinforced Composites, in Mechanics of Composite Materials, G. P. Sendeckyj ed., Academic Press, New York, pp. 251-308.

8. Hahn, H. T. , 1973, Nonlinear Behavior of Laminated Composites, J. Comp. Materials, Vol. 7, pp. 257-271.

9. Hahn, H. T. and Tsai, S. W. , 1973, Nonlinear Elastic Behavior of Unidirectional Composite Laminae, J. Comnp. Materials, Vol. 7, pp. 102-118.

10.

10. Jones, R. S. and Morgan, H. S. , 1977. Analysis of Nonlinear Stress-Strain Behavior of Fiber-Reinforced Composite Materials, AIAA J., Vol. 15, pp. 1669-1676.

11.

11. Luo, S. Y. and Chou, T. W. , 1988, Finite Deformation and Nonlinear Elastic Behavior of Flexible Composites. J. Appl. Mech., Vol. 55, pp. 149-155.

12.

12. Luo, S. Y. and Chou, T. W. , 1990, Finite Deformation of Flexible Composites, Proc. Royal Soc. London, (A), Vol. 429, pp. 569-586, pp. 149-155.

13.

13. Chou, T. W. , 1992, Microstructural Design of Fiber Composites, Ch. 9, Nonlinear Elastic Finite Deformation of Flexible Composites, Cambridge University Press, Cambridge, pp. 475-525.

14.

14. Treloar, L. R. G. , 1975, The Physics of Rubber Elasticity, 3rd ed., Clarendon Press, Oxford.

15.

15. Ogden, R. W. , 1984, Non-linear Elastic Deformations, Wiley, New York.

16.

16. ABAQUS-Theory Manual, Version 5.5; Example Manual, Version 5.5, p. 2.2.3-1-2.2.3-1; Hibbitt, Karlsson & Sorensen, Inc., 1995.

17.

17. Peng, S. H. and Chang, W. J. , 1997, A Compressible Approach in Finite Element Analysis of Rubber-Elastic Materials, Comp. & Struc., Vol. 62, No. 3, pp. 573-593.

18.

18. Treloar, L. R. G. , 1944, Stress-Strain Data for Vulcanised Rubber under Various Types of Deformation, Trans. Faraday Soc., Vol. 40, pp. 59-70.

19.

19. Huang, Z. M. , Ramakrishna, S. , Dinner, H. P. , and Tay, A. A. O. , 1999, Characterization of a Knitted Fabric Reinforced Elastomer Composite, J. Reinf. Plast. & Comp., Vol. 18, pp. 118-137.