Improvement of the chemical recycling process of waste carbon fibre reinforced plastics using a mechanochemical process: Influence of process parameters

Abstract

We present the experimental results of an optimal recycling method for waste carbon fibre reinforced plastics (CFRPs) that is based on the application of a set of unit mechanochemical processes. The objectives of this study were to highlight the influence of process factors that are inherent in the chemical recycling process of waste CFRP. We investigated the influence of the soaking period, the application of a catalyst and impurities on the recycling process and recovery efficiency of the waste CFRP. Different combinations of the unit mechanochemical processes were investigated, and the effectiveness of the combination was analysed. The chemical recycling process was conducted using benzyl alcohol under ordinary pressure at initial solvent temperatures lower/equivalent to its flash point temperature. Experimental results showed that the solvent temperature increased up to boiling temperature levels when the mechanochemical process was initiated, thereby enhancing the mechanochemical process. The presence of impurities did not influence the recovery rate. Likewise, this experimental study highlighted the importance of accounting for the soaking period during the chemical recycling process: an extended soaking period resulted in a higher recovery rate, a lower portion of undissolved solids and recovered fibres of better quality. This research highlighted the significance of choosing the proper combination for the chemical recycling process as well as the benefits of recycling the waste CFRP with negligible application of the catalyst.

Keywords

Recovered carbon fibres waste carbon fibre reinforced plastic mechanochemical process chemical recycling solvent soaking period catalyst recovery rate

Get full access to this article

View all access options for this article.

References

Ambedkar

(2014) Ultrasonic Coal-wash for De-ashing and De-sulfurization. Experimental Investigation and Mechanistic Modeling (Springer Theses). Berlin: Springer.

Boldyreva

(2013) Mechanochemistry of inorganic and organic systems: What is similar, what is different? Chemical Society Reviews 42: 7719.

Catlin

Wang

(2013) Recycling gone bad: when the option to recycle increases resource consumption. Journal of Consumer Psychology 23: 122–127.

Ensminger

Bond

(2012) Ultrasonics : Fundamentals, Technologies, and Applications. Boca Raton, FL: CRC Press.

Ensminger

Stulen

(2009) Ultrasonics : Data, Equations, and their Practical Uses. Boca Raton, FL: CRC Press.

Harrison

(2017) Why achieving zero waste is such a challenge for restaurants. Available at: https://www.eater.com/2017/6/30/15888684/restaurant-zero-waste-oakland-brown-sugar-kitchen (accessed 8 July 2017).

Hedlund-åström

(2005) Model for end of life treatment of polymer composite materials. PhD Dissertation, Royal Institute of Technology, Sweden.

Hedlund-åström

Luttropp

(2006) Metal inserts and hazardous content in light weight composite structures in the context of recycling. In: 13th international conference on life cycle engineering (eds Duflou

Dewulf

), Leuven, Belgium, 31 May-2 June 2006, pp.503–506. Leuven: Katholieke Universiteit Leuven.

Hsiao

Jamali

Glynos

et al . (2017) Rheological state diagrams for rough colloids in shear flow. Physical Review Letters 119: 158001.

10.

Iwaya

Tokuno

Sasaki

et al . (2008) Recycling of fiber reinforced plastics using depolymerization by solvothermal reaction with catalyst. Journal of Materials Science 43: 2452–2456.

11.

Kamimura

Yamada

Kuratani

et al . (2008) DMAP as an effective catalyst to accelerate the solubilization of waste fiber-reinforced plastics. ChemSusChem 1: 845–850.

12.

Khmelyev

Shalunov

Khmelyev

et al . (2015) Ultrasound. Apparatus and technology (Russian). Biysk: Altai State Technical University Press.

13.

Korea Institute of Ocean Science and Technology (2010) Recycling Technologies for Marine Debris - Treatment System for Waste FRP Vessel (Korean). Seoul: KIOST and Ministry of Land, Infrastructure and Transport.

14.

Langton

Vaughan

(1957) The ultrasonic degradation of polystyrene at a frequency of 1 Mc/s. British Journal of Applied Physics 8: 289.

15.

Lee

Yoon

(2013) Developing advanced total recycling method of FRP boats. Journal of the Korean Society for Marine Environment & Energy 16: 53–59.

16.

Liu

Zhang

Guo

et al . (2017) Mild chemical recycling of aerospace fiber/epoxy composite wastes and utilization of the decomposed resin. Polymer Degradation and Stability 139: 20–27.

17.

Louisnard

González-García

(2011) Ultrasound cavitation. In: Feng

Barbosa-Canovas

Weiss

(eds) Ultrasound Technologies for Food and Bioprocessing. New York: Springer.

18.

Markovic

Fowler

Tung

(2004). Preparation and comprehensive characterization of a calcium hydroxyapatite reference material. Journal of Research of the National Institute of Standards and Technology 109: 553–568.

19.

Marsh

(2013) End-of-life boat disposal-a looming issue. Reinforced Plastics 57: 24–27.

20.

Mavropoulos

(2016) International solid waste association blog: Waste industry must prepare for 4th industrial revolution. Available at: https://waste-management-world.com/a/iswa-blog-waste-industry-must-prepare-for-4th-industrial-revolution (accessed 20 June 2017).

21.

Morin

Loppinet-Serani

Cansell

et al . (2012). Near- and supercritical solvolysis of carbon fibre reinforced polymers (CFRPs) for recycling carbon fibers as a valuable resource: State of the art. The Journal of Supercritical Fluids 66: 232–240.

22.

Nakagawa

Kasuga

Aoyagi

et al . (2014) CFRP recycling technology using depolymerization under ordinary pressure. In: 29th technical conference of the American Society for Composites (eds Kim

Whisler

Chen

Bisagni

Kawai

Krueger

), California, 8–10 September 2014, pp. 929-947. Red Hook, NY: Curran.

23.

Naugolnykh

(2009) Nonlinear acoustics: from research in physics to application (historical incidents). Acoustical Physics 55: 338.

24.

Nzioka

Kim

(2017) Mechanochemical-enhanced chemical depolymerisation of glass-based fibre reinforced plastics from end-of-life-boats and ships. In: 3rd international conference on engineering and natural sciences (ed Çınar

), Budapest, p.315. ICENS.

25.

Nzioka

Kim

(2018) Surface analysis of glass fibres using XPS and AFM: Case study of glass fibres recovered from the glass fibre reinforced polymer using chemical recycling. Journal of Physics: Conference Series 953: 012012.

26.

Okajima

Hiramatsu

Shimamura

et al . (2014) Chemical recycling of carbon fiber reinforced plastic using supercritical methanol. Journal of Supercritical Fluids 91: 68–76.

27.

Okajima

Sako

(2017) Recycling of carbon fiber-reinforced plastic using supercritical and subcritical fluids. Journal of Material Cycles and Waste Management 19, 15–20.

28.

Oliveux

Le Gal

Salle

Bailleul

(2011) Recycling by solvolysis thermosetting composite materials of sustainable surface transport. AIP Conference Proceedings 1315: 209.

29.

Pan

Zhan

et al . (2017) Effect of CO2 curing on demolition recycled fine aggregates enhanced by calcium hydroxide pre-soaking. Construction and Building Materials 154(Supplement C): 810–818.

30.

Reddy

Basha

Sravan Kumar

et al . (2004) Distribution, enrichment and accumulation of heavy metals in coastal sediments of Alang–Sosiya ship scrapping yard, India. Marine Pollution Bulletin 48: 1055–1059.

31.

Shibata

Nakagawa

Quitain

et al . (2013) CFRP recycling using depolymerization of acid anhydride cured epoxy resin. In: 19th international conference on composite materials, Montreal (ed Hoa

), 28 July–2 August 2013, pp. 8301–8308. Red Hook, NY: Curran.

32.

Shutilov

(1980) Basics of Ultrasound Physics (Russian). Leningrad: Leningrad University Press.

33.

Sun

Guo

Memon

et al . (2015) Recycling of carbon fibers from carbon fiber reinforced polymer using electrochemical method. Composites Part A: Applied Science and Manufacturing 78: 10–17.

34.

Trudel

(2016) The behavioral economics of recycling. Available at: https://hbr.org/2016/10/the-behavioral-economics-of-recycling (accessed 20 June 2017).

35.

Webster

(2017) Imagine what the circular economy would do for us. Available at: http://www.recyclingwasteworld.co.uk/opinion/imagine-what-the-circular-economy-could-do-for-us/155977/ (accessed 21 July 2018).

36.

Wei

Weavers

(2016) Combining COMSOL modeling with acoustic pressure maps to design sono-reactors, Ultrasonics Sonochemistry 31: 490–498.

37.

Witten

Kraus

Kühnel

(2016) Composites Market Report 2016. Frankfurt: Federation of Reinforced Plastics.

38.

Young

Fan

(2010) Working towards a zero waste environment in Taiwan. Waste Management & Research 28, 236–244.

39.

Yuyan

Guohua

Linghui

(2009) Recycling of carbon fibre reinforced composites using water in subcritical conditions. Materials Science and Engineering: A 520: 179–183.

40.

Zarembo

Shklovskaya-Kordi

(1960) On the question of the propagation velocity of the ultrasound waves with finite amplitudes in liquids (Russian). Acoustic Journal 6: 47–51.

41.

Zhao

Shitian

et al . (2014) Methods for recovering carbon fiber from carbon-fiber-reinforced polymer (CFRP) composites. Patent № WO/2014/179939, PCT.