This paper presents an experimental study of carbon monoxide (CO) formation and emissions in both grate drying bed incinerators and circulating fluidized bed (CFB) incinerators to simulate the two key parts of a combined grate and circulating fluidized bed (grate-CFB) incinerator in order to investigate pollutant emission control in municipal solid waste (MSW) combustion that occurs in a grate-CFB incinerator utilizing a patented technology. Polyvinyl chloride, polystyrene, kitchen waste, paper, textile, etc. were chosen to simulate the MSW. The effects of temperature, air staging, and moisture on the CO formation and emissions were analysed for both the grate drying bed combustion and the CFB combustion. In the grate drying bed, the low temperatures increased the carbon to CO conversion rate which also increased slightly with the moisture content. Industrial field tests in a commercial grate-CFB incinerator showed that the CO concentration at the grate drying bed exit was very high and decreased along furnace height. The carbon to CO conversion rates were 0-20% for the grate drying bed which exceeded the range of 0.8-16% measured in a grate drying bed exit of the commercial grate-CFB incinerator tests. In the commercial grate-CFB incinerator tests, at excess air ratios ranging from 1.5-2.0 or more, the CO emissions decreased to a low and stable level, whose corresponding carbon to CO conversion rates were far lower than 0-10%. The low CO emission is one of the factors enabling the polychlorinated dibenzodioxin/polychlorinated dibenzofuran emissions to satisfy the Chinese national regulations.
Bagci S. ( 2005) Effect of clay content on combustion reaction parameters . Energy Sources27: 579-588.
2.
Chen CH, Li QH, Zhang YG, Wang ZW, and Li DK ( 2008) Model for waste combustion in a grate-CFB incinerator . Journal of Tsinghua University (Science and Technology)48: 832-835. (in Chinese).
3.
Cheng HF, Zhang YG, Meng AH, and Li QH ( 2007) Municipal solid waste fueled power generation in China: A case study of waste-to-energy in Changchun city. Environmental Science and Technology41: 7509-7515.
4.
Cooke RB, Goodson MJ, and Hayhurst AN ( 2003) The combustion of solid wastes as studies in a fluidized bed. Process safety and environmental protection: Transactions of the institution of Chemical engineers, Part B81: 156-165.
5.
Cummins EJ, McDonnell KP, and Ward SM ( 2006) Dispersion modeling and measurement of emissions from the co-combustion of meat and bone meal with peat in fluidized bed. Bioresource Technology97: 903-913.
6.
Deng GF, Li QH, Zhang YG, Chen Y., and Wu ZS ( 2004) Structure and characteristic of 150t/d circulating fluidized-bed municipal waste incinerator. In: Proc. of the Nineteenth International Conference on Solid Waste Technology and Management, Philadelphia, PA, USA, 211-216, This proceedings is published by Widener University School of Engineering.
7.
Desroches-Ducarne E., Dolognier Christophe J., Marty E., Martin G., and Delfosse L. ( 1998) Modelling of gaseous pollutants emissions in circulating fluidised bed combustion of municipal refuse. Fuel77: 399-1410.
8.
Floyd H. ( 1987) Optimization of combustion conditions to minimize dioxin emissions. Waste Management & Research5: 311-326.
9.
Goh YR, Siddall RG, Nasserzadeh V., Zakaria R., Swithenbank J., Lawrence D., Garrod N., and Jones B. ( 1998) Mathematical modeling of the burning bed of a waste incinerator . Journal of the Institute of Energy71: 110-118.
10.
Gungor A., Eskin N. ( 2007) Analysis of environmental benefits of CFB combustors via one-dimensional model. Chemical Engineering Journal131: 301-317.
11.
Han J., Kim H., Cho S., and Shimizu T. ( 2008) Fluidized bed combustion of some woody biomass fuels. Energy Sources, Part A30: 1820-1829.
12.
Jangsawang W., Fungtammasan B., and Kerdsuwan S. ( 2005) Effects of operating parameters on the combustion of medical waste in a controlled air incinerator. Energy Conversion and Management46: 3137-3149.
13.
Koyuncu T., Pinar Y. ( 2007) The emissions from a space-heating biomass stove . Biomass and Bioenergy31: 73-79.
14.
Kuprianova T., Permchartb W., and Janvijitsakula K. (2005) Fluidized bed combustion of pre-dried Thai bagasse. Fuel Processing Technology86: 849-860.
15.
Kwong PCW, Chao CYH, Wang JH, Cheung CW, and Kendall G. ( 2007) Co-combustion performance of coal with rice husks and bamboo. Atmospheric Environment41: 7462-7472.
16.
Li, Q.H. ( 2008) Study on Combustion and Pollutant Emission of Municipal Solid Waste in Combined Grate and Fluidized Bed Incinerator. PhD thesis, Tsinghua University. (in Chinese).
17.
Li QH, Zhang YG, Chen CH, Dang WD, and Meng AH ( 2008) Experimental study of moisture impact on municipal solid waste incineration. Proceedings of the CSEE28(8): 58-64. (in Chinese).
18.
Li QH, Zhang YG, Chen MQ, Meng AH, and Chen CH ( 2009) Study on drying and combustion process in grate-CFB incinerator . Science of China, Series E: Technology and Science52: 1153-1160.
19.
Mearz L., Dominguez A., Kornhauserb I., and Rojas F. ( 2003) A thermochemical concept-based equation to estimate waste combustion enthalpy from elemental composition. Fuel82: 1499-1507.
20.
Okasha F. ( 2007) Staged combustion of rice straw in a fluidized bed. Experimental Thermal and Fluid Science32: 52-59.
21.
Rasul MG ( 2001) Spouted bed combustion of wood charcoal: performance comparison of three different designs. Fuel80: 2189-2191.
22.
Roesler JF, Yetter RA, and Dryer FL ( 1995) Kinetic interactions of CO, NOx, and HCl emissions in postcombustion gases. Combustion and Flame100: 495-504.
23.
Saito M., Amagai K., Ogiwara G., and Arai M. ( 2001) Combustion characteristics of waste material containing high moisture. Fuel80: 1201-1209.
24.
Shimizu T., Franke HJ, Hori S., Takano Y., Tonsho M., Inagaki M., and Tanaka M. ( 2001) Porous bed material -An approach to reduce both unburnt gas emission and NOx emission from a bubbling fluidized bed waste incinerator . Journal of the Japanese Institute of Energy80: 342-348.
25.
Suksankraisorn K., Patumsawad S., Vallikul P., Funqtammasan B., and Accary A. ( 2004) Co-combustion of municipal solid waste and Thai lignite in a fluidized bed. Energy Conversion and Management45: 947-962.
26.
Thipse SS, Sheng C., Booty MR, Magee RS, and Dreizin EL ( 2001) Synthetic fuel for imitation of municipal solid waste in experimental studies of waste incineration. Chemosphere44: 1071-1077.
27.
Wang H., Dlugogorski DZ, and Kennedy EM ( 2003) Role of inherent water in low-temperature oxidation of coal. Combustion Science and Technology175: 253-270.
28.
Wang Z., Richter H., Howard JB, Jordan J., Carlson J., and Levendis Y. ( 2004) Laboratory investigation of the products of the incomplete combustion of waste plastics and techniques for their minimization . Industrial & Engineering Chemistry Research43: 2873-2886.
29.
Weber R., Sakurai T., Ueno S., and Nishino J. ( 2002) Correlation of PCDD/PCDF and CO values in a MSW incinerator - indication of memory effects in the high temperature/cooling section. Chemosphere49: 127-134.
30.
Wei XL, Schnell U., Han XH, and Hein KR ( 2004) Interactions of CO, HCl, and SOx in pulverised coal flames . Fuel83: 1227-1233.
31.
Wey MY, Ou WY, Liu ZS, Tseng HH, Yang WY, and Chiang BC ( 2001) Pollutants in incineration flue gas. Journal of Hazardous Materials82: 247-262.
32.
Yang YB, Swithenbank J. ( 2008) Mathematical modeling of particle mixing effect on the combustion of municipal solid wastes in a packed-bed furnace. Waste Management28: 1290-1300.
33.
Yang YB, Yamauchi H., Nasserzadeh V., and Swithenbank J. ( 2003) Effects of fuel devolatilisation on the combustion of wood chips and incineration of simulated municipal solid wastes in a packed bed. Fuel82: 2205-2221.
34.
Zhang YG, Wang ZM, Li QH, Zhang T., and Tian FS ( 2005) Hot test study on stoker circulating bed MSW incineration . Thermal Power Generation8: 19-24. (in Chinese).
35.
Zhang YG, Chen MQ, Meng AH, Li QH, and Chen YX ( 2007) Experimental study on drying of typical MSW under incinerator-like conditions. Science in China Series E: Technological Sciences50: 636-643.
