Simulation and optimization of mandrel-heating process for composite shells using internal heat-curing method

Abstract

Internal heat-curing is a new method involving heating a mandrel inside a composite shell with steam to make a composite cure. High-quality composite shells can be efficiently molded using this method. However, the mandrel temperature does not change as expected during heating, and the temperature difference on the mandrel is large. In order to analyze the reasons for these problems, a mandrel-heating process in which an internal heat-curing method is applied to the composite shell is studied. A numerical simulation of the mandrel-heating process for a slender cylinder-shaped pipe is carried out, and the mandrel structure is optimized according to the simulation results. Temperature tests on the mandrel show that the uniformity of the optimized mandrel temperature is improved. The research in this article provides a basis for the temperature control and structural design of mandrels and their inner channels. Heating at the expected temperature is achieved, ensuring the quality of the formed composite shell.

Keywords

composite shell internal heat-curing finite element method mandrel structure optimization

Get full access to this article

View all access options for this article.

References

Srinivasan

Asaithambi

Ganesan

. Wear mechanism of glass fiber reinforced epoxy composites under dry sliding using fuzzy clustering technique. J Reinf Plast Compos 2009; 28: 1349–1358.

Liang

Garg

Chandrashekhara

Flanigan

Kapila

. Cure characterization of pultruded soy-based composites. J Reinf Plast Compos 2005; 24: 1509–1520.

Qiao

You

Wang

. The research of in-situ modeling process for fiber winding composite shell. J Mater Sci Technol 2009; 17: 191–194.

Wang

Cao

Yang

. Numerical simulation of liquid-solid two-phase flow field in discharge gap of high-speed small hole EDM drilling. J Adv Mater Res 2008; 53–54: 409–414.

Alobaid

Strohle

Epple

. Dynamic simulation of a supercritical once-through heat recovery steam generator during load changes and start-up procedures. J Appl Energy 1986; 86: 1274–1282.

Zhang

Tan

Xia

. Numerical analysis of the issue of the wet-steam condensation and flow in 2D cascade. J Turbine Technol 2007; 49: 298–300.

Fard

Esfahany

Talaie

. Numerical study of convective heat transfer of nanofluids in a circular tube two-phase model versus single-phase model. Int Commun Heat Mass Transfer 2010; 37(1): 91–97.

Wang

. Finite element method. Beijing: Tsinghua University Press, 2003.

Peng

Wang

Zou

Zhang

Chen

. Numerical simulation of three-dimensional two-phase flow in hydrocyclone. J Comput Appl Chem 2006; 8: 728–732.

10.

Wang

Zhao

. Research of thermal response simulation and mold structure optimization for rapid heat cycle molding processes, respectively, with steam heating and electric heating. J Mater Des 2010; 31: 382–395.