Abstract
Objectives
To determine the quality of sclerosant foam produced with an automated preparation system with multiple combinations of sclerosing agents, gases, and device settings.
Methods
Single-use mixing capsules filled with air or O2/CO2 and polidocanol (0.25, 1, or 3%) or sodium tetradecyl sulfate (0.2 or 1%) were coupled to a customized magnetic stirrer. Stirring speed and time were adjusted between 1500 and 4000 r/min and 30 and 60 s, respectively, and characteristics of the foam produced were measured: half-life, bubble diameter, and gas-to-liquid ratio.
Results
With optimized device settings, the following foam characteristics were obtained: half-life range, 1.4 ± 0.9 to 5.2 ± 0.6 min; bubble diameter, 84 ± 14 to 119 ± 6 µm; and gas-to-liquid ratio, 5:1–7:1. Sodium tetradecyl sulfate foam was quicker to form than polidocanol but faster to degrade. Foams with low sclerosant concentrations and O2/CO2 required higher speed and longer time.
Conclusions
Suitable foam characteristics could be obtained with all combinations of sclerosing agent, concentration, and gas.
Get full access to this article
View all access options for this article.