Active and Passive Cable Elements in Deployable/Retractable Masts

Abstract

This paper describes a new type of deployable masts for use in Space, based on the following elements. A deployable backbone, consisting of rods and/or plates, which can be folded or deployed freely. One or more active cable, following specially chosen routes along the mast, and running over small pulleys. The overall length of an active cable can vary between two extremes: a maximum length when the mast is fully folded; a minimum length when the mast is fully deployed. A set of passive cables joining pairs of points on the backbone. The passive cables are all slack when the backbone is partially folded and become taut when it is fully extended. A final, essential ingredient is structural prestress in the deployed state, so that all of the cables are in a state of pretension and therefore are able to carry any tensile or compressive force changes induced by external loads. An additional effect of this state of prestress is to remove backlash at the joints. Three deployable masts based on this approach are presented in the paper.

Get full access to this article

View all access options for this article.

References

Warden

R.M

and Jones

P.A.

, Carousel deployment mechanism for coilable lattice truss. Proc. 23rd Aerospace Mechanisms Symp., Marshall Space Flight Centre, Huntsville, Alabama, NASA-CP-3032, pp. 77–100 (1989).

Vorlicek

P.L.

, Gore

J.V.

, Plescia

C.T.

, Design and analysis considerations for deployment of Space mechanisms in a Space environment. Proc. 16th Aerospace Mechanisms Symp., J.F. Kennedy Space Centre, Florida, NASA-CP-2221, pp. 211–222 (1982).

De Kam

, EURECA application of the RARA solar array, Proc. Photovoltaic Generators in Space, Scheveningen, The Netherlands, ESA SP267, pp. 105–114 (1986).

Kwan

A.S.K.

, A pantographic deployable mast. Ph.D. dissertation, University of Cambridge (1991).

Kwan

A.S.K.

and Pellegrino

, The Pantographic Deployable Mast: design, structural performance and deployment tests. In: Bulson

P.S.

, Rapidly Assembled Structures, Computational Mechanics Publ. pp. 213–224 (1991).

Palombini

and Pellegrino

, Parameter estimation in experimental modal analysis: comparison of existing techiques and application to a deployable mast. CUED/DSTRUCT/TR139, Cambridge University (1991).

Calladine

C.R.

, Buckminster Fuller's “Tensegrity” structures and Clerk Maxwell's rules for the construction of stiff frames. Int. J. Solids Struct. 14, 161–172 (1978).

Okazaki

, Sato

, Obata

, Natori

, Miura

, Design consideration of mechanical and deployment properties of a coilable lattice mast. Proc. 15th Int. Symp. Space Technology and Science, Tokyo (1986).