To detect the fault of the doubly-fed induction generator (DFIG), in this paper, a fault detection method of novel sliding mode observer is proposed, without a velocity sensor. In addition to better elimination of chattering for the new sliding mode observer, at the same time, it has better stability and faster convergence speed than the traditional sliding mode observer. Firstly, the sliding mode observer is built according to the mathematical model of the DFIG. Then, the rotor current and the rotational speed are estimated. After comparing the actual rotor current value with the observed value, the self-detection of the fault for the DFIG is realized. Secondly, three faults of grid voltage sags failure, DFIG inter-turn stator fault and rotor current sensor fault are given respectively. After that the Simulink simulation model is built under different fault conditions. It is proved by simulation that this sliding mode observer can well detect faults occurring at different positions. Additionally, it can also be proved that the sliding mode observer has the characteristics of fast response and good stability.
BoulkrouneBGalvez-CarrilloMKinnaertM (2013) Combined signal and model-based sensor fault diagnosis for a doubly fed induction generator. IEEE Transactions on Control Systems Technology21(5): 1771–783.
2.
ChengFZPengYYLiYQ, et al. (2017) Current-based fault detection and identification for wind turbine drivetrain gearboxes. IEEE Transactions on Industry Applications53(2): 878–887.
3.
ChengFZWangJQuLY, et al. (2018) Rotor current-based fault diagnosis for DFIG wind turbine drivetrain gearboxes using frequency analysis and a deep classifier. IEEE Transactions on Industry Applications54(2): 1062–1071.
4.
DridSTadjineMNait-SaidMS (2007), Robust backstepping vector control for the doubly fed induction motor. IET Control Theory & Applications1(4): 861–868.
5.
FanWYanP (2018) A novel disturbance observer design method for time delay systems with application to nano manipulations. In: Proceedings of the 2018 International Conference on Advanced Mechatronic Systems, Zhengzhou, China, 30 August–2 September 2018, pp. 353–358. New York, USA: IEEE Computer Society.
6.
GuoQZhangYCellerBG, et al. (2017) State-constrained control of single-rod electrohydraulic actuator with parametric uncertainty and load disturbance. IEEE Transactions on Control Systems Technology1(8): 1–8.
7.
GuoQZuoZDingZ (2020) Parametric adaptive control of single-rod electrohydraulic system with block-strict-feedback model. Automatica113(3): 1–9.
8.
HeTWuZ (2020) Multirate iterative learning disturbance observer with robustness to frequency deviation for high precision attitude stabilization of flexible spacecraft subject to complex disturbances. Aerospace Science and Technology96(1): 1–14.
9.
IrhoumahMPuscaRLefevreE, et al. (2019) Detection of the stator winding inter-turn faults in asynchronous and synchronous machines through the correlation between harmonics of the voltage of two magnetic flux sensors. IEEE Transactions on Industry Applications55(3): 2682–2689.
10.
JiangSDLiuJ (2014) Passive control of doubly-fed wind turbines under grid voltage drop failure. Systems Engineering-Theory & Practice34(2): 478–484.
11.
KarimiSGaillardAPourePSaadateS (2009) Current sensor fault-tolerant control for WECS with DFIG. IEEE Transactions on Industrial Electronics56(11): 4660–4670.
12.
KhedriMShamsi NejadMAYousefi KiaM, et al. (2013) Hybrid modelling of doubly fed induction generators with inter-turn stator fault and its detection method using wavelet analysis, IET Generation, Transmission & Distribution7(9): 982–990.
13.
LopezJEGubíaESanchisP, et al. (2008) Wind turbines based on doubly fed induction generator under asymmetrical voltage dips. IEEE Transactions on Energy Conversion23(1): 321–330.
14.
LopezJSanchisPRoboamXMarroyoL (2007) Dynamic behavior of the doubly fed induction generator during three-phase voltage dips. IEEE Transactions on Energy Conversion22(3): 709–717.
15.
MaHZZhangZYZhangZXQianYY (2011) Research on fault diagnosis of stator interturn short circuit of doubly-fed asynchronous generator. Electric Machines and Control15(11): 50–54.
16.
MaJLiuQWuJF, et al. (2009) Flexible power control of rotor-side converter for doubly-fed induction generator under unbalanced voltage. Electric Power Automation Equipment39(2): 196–203.
17.
MojallalALotfifardS (2018) DFIG wind generators fault diagnosis considering parameter and measurement uncertaintie. IEEE Transactions on Sustainable Energy9(2): 792–804.
18.
OuyangJXXiongXFZhangHY (2011) Characteristics of DFIG-based wind generation under grid short circuit. Proceedings of the CSEE31(22): 17–25.
19.
ReigosaDDGuerreroJMDiezABBrizF (2017) Rotor temperature estimation in doubly-fed induction machines using rotating high-frequency signal injection. IEEE Transactions on Industry Applications53(4): 3652–3662.
20.
ShahDNandiSNetiP (2009) Stator-interturn-fault detection of doubly fed induction generators using rotor-current and search-coil-voltage signature analysis. IEEE Transactions on Industry Applications45(5): 1831–1842.
21.
ShenYXYangXFZhaoZP (2017) Sensor fault diagnosis of wind power system. Control Theory & Applications34(3): 321–328.
22.
ShuilongHXuhongSZhansiJ (2009) Detection and location of stator winding interturn fault at different slots of DFIG. IEEE Access50(5): 1831–1842.
23.
StojcicGPasanbegovicKWolbankTM (2014) Detecting faults in doubly fed induction generator by rotor side transient current measurement. IEEE Transactions on Industry Applications50(5): 3494–3502.
24.
WeiSRLiZMFuY, et al. (2018) Fault diagnosis of interturn short circuit in stator windings of offshore doubly-fed machines considering the difference of current estimation. Proceedings of the CSEE38(13): 3169–3977.
25.
XueZYXiahouKSLiMS, et al. (2019) Diagnosis of multiple open-circuit switch faults based on long short-term memory network for DFIG-based wind turbine systems. IEEE Journal of Emerging and Selected Topics in Power Electronics: 1–1. DOI: 10.1109/JESTPE.2019.2908981.
