Simulating and Characterizing Water Flows Inside Hydroentangling Orifices

Abstract

The hydroentangling technique uses cone-capillary orifice nozzles to direct high-energy water jets against loose fiber webs. This study simulates the effects of orifice configuration on the water-jet properties. An axisymmetric steady-state model is considered for this two-phase system. The turbulent water jet is simulated using a realizable k - ε model, and the behaviors of cone-up and cone-down geometries are investigated. The simulation reveals that the water jet produced by a cone-up orifice keeps contact with the walls all the way through the orifice and may undergo cavitation to reduce the water-jet intact length and damage to the orifice surface. In contrast, the cone-down geometry can form a constricted water jet that is enveloped by an air gap, which separates the water from the orifice surface and therefore prevents cavitation. The results are in excellent agreement with previous experimental studies.

Get full access to this article

View all access options for this article.

References

Chen, H.C. , and Patel, V.C. , Near-Wall Turbulence Models for Complex Flows Including Separation , AIAA J. 26 (6). 641-648 (1988).

Connoly, T.J. , and Parent, L.R. , Influence of Specific Energy on the Properties of Hydroentangled Nonwoven Fabrics, Tappi J. 76 (8), 135-141 (1993).

Fleissner, private communication.

FLUENT 5.5 Manual.

FLUENT (trademark of FLUENT Inc.) Navier-Stokes solver.

Ghassemieh, E. , Versteeg, H.K. , and Acar, M. , Investigation of Flow Characteristics and Geometrical Effects in Hydroentangling Jets, in "Proc. Intemational Nonwovens Technical Conference (INTC)," 2001.

Gorse, R.D. , Orifice Contraction Coefficient for Inviscid Incompressible Flow, Trans. ASME J. Fluids Eng. 107, 37 (1985).

Hiroyasu, H. , Arai, M. , and Shimizu, M. , Breakup Length of a Liquid Jet and Internal Flow in Nozzle, in "Proc. ICLASS-91," paper 26, 1991.

Kim, S.E. , Choudhury, D. , and Patel, B. , Computations of Complex Turbulent Flows Using the Commercial Code FLUENT 5.5 , in "Proc. ICASE/LaRC/AFOSR Symposium on Modeling Complex Turbulent Flows," Hampton, Virginia , 1997.

10.

Launder, B.E. , and Spalding, D.B. , "Lectures in Mathematical Models of Turbulence ," Academic Press, London, 1972.

11.

Lin, S.P. , and Reitz, R.D. , Drop and Spray Formation from a Liquid Jet, Ann. Rev. Fluid Mech. 30, 85-105 ( 1998).

12.

Mordechai, T. , The Outlook for Spunlaced Nonwovens, Nonwovens Ind. (11),30-36 (1998).

13.

Murphy, J. , Schmidt, D. , Wang, S.P. , and Corradini, M.L. , Multi-dimensional Modeling of Multiphase Flow Physics: High-speed Nozzle and Jet Flows—A Case Study, Nuclear Eng. Design 204, 177-190 (2001).

14.

Noelle, F. , Spunlace: Improvements Which Enhance Production Efficiencies and Reduce Operating Cost, Melliand Int. (2), 132-133 (2001).

15.

Patankar, S.V. , "Numerical Heat Transfer and Fluid Flow," Hemisphere, Washington D.C., 1980 .

16.

Schmidt, D.P. , Rutland, C.J. , Corradini, M.L. , Roosen, P. , and Genge, O. , Cavitation in Two Dimensional Asymmetric Nozzles, SAE Technical Series 1999-01-0518 , 1999.

17.

Schmidt, D.P. , Rutland, C.J. , and Corradini , M.L. , A Numerical Study of Cavitating Flow Through Various Nozzle Shapes, SAE paper 971597, 1997.

18.

Shih, T.-H. , Liou, W.W. , Shabbir , A. , and Zhu, J. , A New k - ε Eddy-Viscosity Model for High Reynolds Number Turbulent Flows—Model Development and Validation . Computers Fluids, 24 (3), 227-238 (1995).

19.

Soteriou, C. , Andrews, R. , and Smith, M. , Direct Injection Diesel Sprays and the Effect of Cavitation and Hydraulic Flip on Atomization, SAE paper no. 950080, pp. 27-51, 1995.

20.

Spikes, R.H. , and Pennington, G.A. , Discharge Coefficient of Small Submerged Orifices, Proc. Inst. Mech. Eng. 173 (2), 661-665 (1959).

21.

Versteeg, H.K. , and Malalasekera , W. , "An Introduction to Computational Fluid Dynamics: The Finite Volume Method," Longman, Malaysia TCP, 1995.

22.

Vuillaume, A. , Hydroentanglement of Nonwoven Fabrics—Jetlace , Aust. Textiles (1) ( 1991 ).

23.

Ward, D.T. , Spunlace Line Offers Energy Economy and Versatility, ITB Nonwovens Ind. Textiles (4), 39-42 ( 1997).

24.

Watzl, A. , Energy Consumption for Hydroentanglement Fleissner-Aquajet Spunlace Systems, Chem. Fibers Int. 47 (4), 153 (1997).

25.

White, C.F. , Hydroentanglement Technology Applied to Wet-formed and Other Precursor Webs, Tappi J. (6), 187-192 ( 1990).

26.

Yongliang, C. , and Heister, S.D. , Two-Phase Modeling of Cavitated Flows, Computers Fluids 24 (7) 799-809 (1995).