Abstract
This paper presents the results of experimental and analytical studies on the behaviour of sandwich beams fabricated with layered cores and glass fiber-reinforced polymer (GFRP) composite facings. The GFRP facings were fabricated using a unidirectional fiberglass fabric and epoxy resin, and the cores were fabricated using a thin non-woven continuous-strand polyester fiber mat with a thickness of 4.1 mm. A total of 30 sandwich beams with the width of 50 mm were prepared tested with five varying core configurations including cores made with one, two, or three layers of the fiber mat core and with or without the inclusion of intermediate GFRP layers. The specimens were tested up to failure under four-point bending at two different spans to characterize flexural and shear properties of the specimens. Two types of failure were observed, namely crushing of the compression facesheet and core shear. The load-deflection, load-strain, and moment-curvature behaviour were analyzed and using the results the flexural stiffness, shear stiffness, and core shear modulus were calculated. An analytical model was also developed to predict load-deflection behaviour and failure loading of sandwich specimens with varying core layouts. After verification, the analytical model was used for a parametric study of cases not considered in the experimental study, including additional GFRP and fiber mat core layers. It was shown that additional fiber mat core layers and the inclusion of intermediate GFRP layers can increase the strength and overall stiffness of a sandwich beam, while additional GFRP layers can only increase the overall stiffness of the system. The analytical model can be used to optimize the configuration of layered sandwich composites for cost effective rehabilitation techniques of culverts, pipelines, and other curved-shape structures where a thin, flexible core is needed to accommodate the curvature of the existing structure.
Get full access to this article
View all access options for this article.