Influence of gripping method on tensile properties of unidirectional thermoplastic CFRP – Round-robin activity for international standardization in Japan

Abstract

For unidirectional thermoplastic composite materials, it is preferable to use tab-less specimens in tensile tests owing to the low adhesive performance between specimens and tabs, as well as considerable warpage in laminates due to compression molding. In this study, round-robin tests are performed for unidirectional laminates in the 0° and 90° directions by two types of thermoplastic composites – carbon/polyamide 6 and carbon/polypropylene. The purpose of the round-robin test is to examine the difference between tab-bonded and tab-less specimens. Statistical analyses determined the degree to which tab-less specimens influenced their evaluation of the mechanical performance. In addition, from the detailed experiments, precisely controlled gripping force, fine roughness of grip surfaces, and a few inserted abrasive papers had significant impact on the 0° tensile strength of tab-less specimens. Based on the results, 0° tab-less strength of the proposed gripping method was shown to be almost equal to that of tab-bonded specimens recommended by the present tensile test standard.

Keywords

Carbon fiber-reinforced thermoplastic composites tensile properties standardization mechanical testing

Get full access to this article

View all access options for this article.

References

Sims

. Standards for advanced polymer matrix composites. Mater Des 1991; 12: 81–89.

Maheri

. An improved method for testing unidirectional FRP composites in tension. Compos Struct 1995; 33: 27–34.

Wisnom

Atkinsion

. Reduction in tensile and flexural strength of unidirectional glass fibre-epoxy with increasing specimen size. Compos Struct 1997; 38: 405–411.

Wisnom

Khan

Hallett

. Size effects in unnotched tensile strength of unidirectional and quasi-isotropic carbon/epoxy composites. Compos Struct 2008; 84: 21–28.

Hojo M, Sawada Y and Miyairi H. Effects of tab design and gripping condition on tensile properties of unidirectional CFRP in fiber and transverse direction. In: ECCM – compos test and stand, Amsterdam, 8–10 September 1992.

Hojo

Sawada

Miyairi

. Influence of clamping method on tensile properties of unidirectional CFRP in 0° and 90° directions – round robin activity for international standardization in Japan. Composites 1994; 25: 786–796.

Cunningham

Schoulz

Toth

Effect of end tab design on tension specimen stress concentrateons. In: Vinson

Taya

(eds). Recent advances in composites in the United States and Japan 1985; Vol. 864 West Conshohocken, PA: ASTM International, pp. 253–262.

Fujishima M, Yamazaki T, Ichikawa M, et al. Effectiveness of sandpaper tab at the CFRP tensile test. In: JSCM-28 symposium, Akita, 23–24 October 2003..

ISO 527-5. Plastics – determination of tensile properties – part 5 test conditions for unidirectional fiber-reinforced plastic composites (MOD), Geneva, Switzerland: ISO, 2009.

10.

Matsuo T, Hojo M and Kageyama K. Influence of gripping condition and matrix type on tensile properties of unidirectional carbon fiber reinforced thermoplastic composites. In: ICCM-21 conference, Xi'an, 20–25 August 2017.

11.

Tencate, Cetex TC910 & TC960 Technical data, http://www.tencate.com/.