The research dealt with the correlation between fatigue life of a CFRP laminate composite and the thermal analysis information obtained during the fatigue tests. This study was done for two different lamination sequences and three different loading frequencies. The damage progression was also evaluated by stiffness reduction and hysteresis loop areas increase measurements. The thermal energy, which is the amount of mechanical energy dissipated in the form of heat, evaluated in the first few load cycles was found to be a good parameter to predict fatigue life.
Reifsnider, K.L. and Williams, R.S. (1974). Determination of Fatigue-related Heat Emission in Composite Materials, Exp. Mech., 14: 479-485.
2.
Kharrazi, M.R. and Sarkani, S. (2001). Frequency-dependent Fatigue Damage Accumulation in Fibre-reinforced Plastics, J. Compos. Mater., 35/21: 1924-1953.
3.
Pye, C.J. and Addams, R.D. (1981). Heat Emission from Damaged Composite Materials and its Use in Nondestructive Testing, J. Phys. D: Appl. Phys., 14: 927-941.
4.
Steinberger, R., Valadas Leitão , T.I., Ladstätter, E., Pinter, G., Billinger, W. and Lang, R.W. (2006). Infrared Thermographic Techniques for Non-destructive Damage Characterization of Carbon Fibre Reinforced Polymers During Tensile Fatigue Testing, Int. J. Fatigue, 28: 1340-1347.
5.
Gamstedt, E.K. , Redon, O. and Brøndsted , P. (2002). Fatigue Dissipation and Failure in Unidirectional and Angle-Ply Glass Fibre/Carbon Fibre Hybrid Laminates, Key Eng. Mater., 221,222: 35-48.
6.
Adams, R.D., Walton, D., Flitcroft, J.E. and Short, D. ( 1975). Vibration Testing as a Nondestructive Test Tool for Composite Materials, Compos. Reliab., ASTM STP, 580: 159-175.
7.
Rittel, D. ( 1999). On the Conversion of Plastic Work to Heat During High Strain Rate Deformation of Glassy Polymers, Mech. Mater., 31: 131-139.
8.
Rittel, D. ( 2000). An Investigation of the Heat Generated During Cyclic Loading of Two Glassy Polymers. Part I: Experimental, Mech. Mater., 32: 131-147.
9.
Bakis, C.E. and Reifsnider, K.L. ( 1991). The Adiabatic Thermoelastic Effect in Laminated Fibre Composites, J. Compos. Mater., 25: 809-830.
10.
Pitarresi, G. , Found, M.S. and Patterson , E.A. (2005). An Investigation of the Influence of Macroscopic Heterogeneity on the Thermoelastic Response of Fibre Reinforced Plastics, Compos. Sci. Technol. , 65: 269-280.
11.
Pitarresi, G. and Patterson, E.A. (2003). A Review of the General Theory of Thermoelastic Stress Analysis, J. Strain Anal. Eng. , 38(5): 405-417.
12.
La Rosa, G. and Risitano, A. (1999). Thermographic Methodology for Rapid Determination of the Fatigue Limit of Materials and Mechanical Components , Int. J. Fatigue Mater. Struct. Components, 22: 65-73.
13.
Fargione, G. , Geraci, A., La Rosa, G. and Risitano, A. (2002). Rapid Determination of the Fatigue Curve by the Thermographic Method, Int. J. Fatigue , 24: 11-19.
14.
Meneghetti, G. (2007). Analysis of the Fatigue Strength of a Stainless Steel Based on the Energy Dissipation, Int. J. Fatigue, 27: 81-94.
15.
Ceschini, L. and Minak, G. (2008). Fatigue Behaviour of Low Temperature Carburized AISI 316L Austenitic Stainless Steel, Surf. Coat Technol., 202: 1778-1784.
16.
La Rosa, G., Perrone, S. and Quaresimin, M. (1998). Determinazione Della Resistenza a Fatica di Materiali Compositi con Tecniche Termografiche, Atti del XXVII Convegno Nazionale AIAS, 799-808 (in Italian).
17.
Swanson, S.R. , Cairns, D.S., Guyll, M.E. and Johnson, D. (1993). Compression Fatigue Response for Carbon Fibre with Conventional and Toughened Matrices with Damage, Trans. ASME J. Eng. Mater. Technol., 115: 116-121.
18.
Goglio, L. and Rossetto, M. ( 2004). Comparison of Fatigue Data Using the Maximum Likelihood Method, Eng. Frac. Mech., 71: 725-736.
19.
Nelson, W. ( 1982). Applied Life Data Analysis, John Wiley & Sons, Inc, New York.
20.
Minak, G., Ceschini, L., Boromei, I. and Ponte, M. ( 2010). Fatigue Properties of Friction Stir Welded Particulate Reinforced Aluminium Matrix Composites, Int. J. Fatigue, 32: 218-226.
21.
Barron, V., Buggy, M. and McKenna, N.H. ( 2001). Frequency Effects on the Fatigue Behaviour on Carbon Fibre Reinforced Polymer Laminates, J. Mater. Sci., 36(7): 1755-1761.
22.
Tsai, G.C., Doyle, J. and Sun, C.T. ( 1987). Frequency Effects on the Fatigue Life and Damage of Graphite/Epoxy , J. Compos. Mater., 21(1): 2-13.
