The Influence of Static Factors on Seating Comfort of Motorcycles: An Initial Investigation

Abstract

Objective:

The aim of the current study is to examine the influence of static factors on overall seating comfort in motorcycles and validate the use of static lab-based setups for evaluating seating comfort in motorcycles.

Background:

Seating comfort in automobiles has two factors, static and dynamic. Research on seating comfort of passenger cars has shown that when the magnitude of vibration reaching the seat is low, comfort is largely determined by static factors. Studies have also validated the use of static lab-based setups for research on seating comfort in passenger cars. Static lab-based setups are easy to develop, provide a controlled environment, and efficient for experimental research. The riding posture, mass distribution, and dynamics of a motorcycle differ from a passenger car and warrant further investigation to extend the results from the research on passenger cars.

Method:

The study compares subjective rating of seating comfort and objective measurement of seat interface pressure in two test conditions: a static lab-based setup and actual driving on a flat test track where the magnitude of vibration reaching the seat is low. The vibration at the seat is measured for the driving trial. A group of 18 male volunteers from TVS Motor Company participated in the study, and two motorcycles from the economy/executive segment of India are used in the study. The subjective ratings are analyzed statistically using analysis of variance (ANOVA) and Pearson’s correlation. The vibration data are analyzed as per ISO 2631-1 to calculate the frequency-weighted acceleration, a_w.

Results:

The results show that there is no significant difference between the two test conditions either in the objective measurements or in the subjective rating of comfort. There is also a statistically significant correlation between the subjective ratings of seating comfort in static lab-based setup and actual riding (r = .77, p < .01, n = 36). The mean a_w at the seat while driving in the test track used in this study is 0.2 m/s².

Conclusion:

Static factors have a significant influence on seating comfort in motorcycles. When the vibration reaching the seat is low (a_w ≤ 0.2 m/s²), seating comfort is largely determined by the static factors. The use of static lab-based setups for evaluating static factors of seating comfort in motorcycles is validated.

Application:

The results of this study enable further research to understand the human criterion for seating comfort in motorcycles using static lab-based setups which are easier to develop and provide controlled environment that is essential for any research.

Keywords

seating comfort static factors dynamic factors motorcycle ergonomics automobile ergonomics subjective evaluation rating scales

Get full access to this article

View all access options for this article.

References

Balasubramanian

Jagannath

(2014). Detecting motorcycle rider local physical fatigue and discomfort using surface electromyography and seat interface pressure. Transportation Research Part F: Traffic Psychology and Behaviour, 22, 150–158.

Chen

H. C.

Chen

W. C.

Liu

Y. P.

Chen

C. Y.

Pan

Y. T.

(2009). Whole body vibration exposure experienced by motorcycle riders—An evaluation in accordance to ISO2631-1 and ISO261-5 Standards. International Journal of Industrial Ergonomics, 39, 708–718.

de Looze

M. P.

Kuijt-Evers

L. F. M.

van Dieen

. (2003). Sitting comfort and discomfort and the relationships with objective measures. Ergonomics, 46, 985–997.

Ebe

Griffin

M. J.

(2000). Qualitative models of seat discomfort including static and dynamic factors. Ergonomics, 43, 771–790.

International Organization for Standardization. (1997). Mechanical vibration and shock: Evaluation of human exposure to whole body vibration—Part 1: General requirements (ISO 2631-1). Geneva, Switzerland: Author.

Karmegam

Ismail

M. Y.

Sapuan

S. M.

Ismail

Shamsul

B. T.

Shuib

Seetha

(2009). A study on motorcyclists riding discomfort in Malaysia. Journal of Engineering. e-trans, 4, 39–46.

Kolich

(2000). Ergonomic modeling and evaluation of automobile seat comfort. Doctoral thesis, University of Windsor, Windsor, Ontario, Canada.

Koyano

Kimishima

Nakayama

(2003). Quantification of static seating comfort of motorcycle seats. JSAE Review, 24, 99–104.

Kulkarni

Ranjan

Chitodkar

Gurjar

Ghaisas

C. V.

Mannikar

A. V.

(2011). SIZE INDIA—Anthropometric size measurement of Indian driving population. Symposium on International Automotive Technology (SAE Paper, 2011-26). Retrieved from https://www.sae.org/publications/technical-papers/content/2011-26-0108/

10.

Kyung

Nussbaum

M. A.

(2008). Driver sitting comfort and discomfort (part II): Relationships with and prediction from interface pressure. International Journal of Industrial Ergonomics, 38, 526–538.

11.

Kyung

Nussbaum

M. A.

Reeves

K. B.

(2008). Driver sitting comfort and discomfort (part I): Use of subjective rating scales in discriminating car seats and correspondence among ratings. International Journal of Industrial Ergonomics, 38, 516–525.

12.

Mansfield

N. J.

Mackrill

Rimell

A. N.

MacMull

S. J.

(2014). Combined effects of long-term sitting and whole-body vibration on discomfort onset for vehicle occupants. ISRN Automotive Engineering, 2014, 852607.

13.

Poushter

(2016). Car, bike or motorcycle? Depends on where you live. Pew Research Center. Retrieved from http://www.pewresearch.org/fact-tank/2015/04/16/car-bike-or-motorcycle-depends-on-where-you-live/#

14.

Richards

L. C.

(1980). On psychology of passenger comfort. In Oborne

D. J.

Levins

J. A.

(Eds.), Human factors in transport research. New York, NY: Academic Press.

15.

Robertson

S. A.

(1985). An assessment of the ergonomic problems of motorcycle riders with special reference to the riding position and seat height. Master’s thesis, Loughborough University, Loughborough, UK.

16.

Sai Praveen

Ray

G. G

. (2015a, August). Reliability and validity of seat interface pressure to quantify seating comfort in motorcycles. Proceedings of the 19th Triennial Congress of the IEA, Melbourne, Victoria, Australia. Retrieved from https://www.iea.cc/congress/2015/227.pdf

17.

Sai Praveen

Ray

G. G

. (2015b, August). A study on motorcycle usage and comfort in urban India. Proceedings of the 19th Triennial Congress of the IEA, Melbourne, Victoria, Australia. Retrieved from https://www.iea.cc/congress/2015/1635.pdf

18.

Sai Praveen

Ray

G. G

. (2017). Development of a Motorcycle Seating Comfort Questionnaire. Human Factors, 59, 1249–1262. doi:10.1177/0018720817735929

19.

Sai Praveen

Ray

G. G

. (2018a). Influence of driving duration on static factors of seating comfort in motorcycles. In Bagnara

Tartaglia

Albolino

Alexander

Fujita

(Eds.), Proceedings of the 20th Congress of the International Ergonomics Association (Advances in intelligent systems and computing, Vol. 824). Cham, Switzerland: Springer.

20.

Sai Praveen

Ray

G. G

. (2018b). Validity of using lab based set-ups for evaluation of static factors in seating comfort of motorcycles. In Bagnara

Tartaglia

Albolino

Alexander

Fujita

(Eds.), Proceedings of the 20th Congress of the International Ergonomics Association (Advances in intelligent systems and computing, Vol. 824). Cham, Switzerland: Springer.

21.

Zenk

Mergl

Hartung

Sabbah

Bubb

(2006). Objectifying the comfort of car seats. In SAE Conference 2006 (SAE paper #. 2006-01-1299). Retrieved from https://www.sae.org/publications/technical-papers/content/2006-01-1299/

22.

Zhang

Helander

M. G.

Drury

C. G.

(1996). Identifying factors of comfort and discomfort in sitting, human factors. International Journal of Industrial Ergonomics, 38, 377–389.