A Novel Fiber Optic System for Measuring the Dynamic Structural Behavior of Parachutes

Abstract

A novel approach has been developed for real-time characterization of a parachute during inflation. Two techniques were applied to measure static and dynamic stresses in a parachute canopy fabric material and suspension lines: the modal power distribution (MPD) technique and the fiber Bragg grating (FBG) technique. Several tests were conducted under various loading conditions, using a bi-axial tensile tester. The MPD technique was used to measure the transverse stresses in the parachute canopy fabric material and was applied using two experimental set-ups: one using a CCD camera and the other using a photo-detector. The FBG technique was used to measure the axial stresses in the parachute canopy fabric material. The tests were performed using the spectrum analyzer set-up with the bi-axial machine. Finally, a drop test was performed on the parachute canopy fabric material using the MPD technique with the photo-detector set-up.

Get full access to this article

View all access options for this article.

References

1. R. H. Croll , P. C. Klimas , R. E. Tate and D. F. Wolf , “Summary of Parachute Wind Tunnel Testing Methods at Sandia National Laboratories,” Paper No. 81-1931, AIAA 7th Aerodyn. & Balloon Tech. Conf., San Diego, CA, Oct. 21-23, 1981.

2. C. K. Lee , “Experimental Investigation of Full-Scale and Model Parachute Opening,” Paper No. 84-0820, AIAA 8th Aerodyn. & Balloon Tech. Conf., Hyannis, MA, pp. 215-223, April 2-4, 1984.

3. D. S. Jorgersen and D. J. Cokrell , “Aerodynamics and Performance of Cruciform Parachute Canopies,” Paper No. 81-1919, AIAA 7th Aerodyn. & Balloon Tech. Conf., San Diego, CA, Oct. 21-23, 1981.

4. W. Garrard , K.S. Wu and K. K. Muramoto , “Steady State Stresses in Ribbon Parachute Canopies,” Paper No. 84-0816, AIAA 8th Aerodyn. & Balloon Tech. Conf., Hyannis, MA, pp. 191-199, April 2-4, 1984.

5. W. Garrard , M. L. Konicke , K.S. Wu and K. K. Muramoto , “Measured and Calculated Stress in a Ribbon Parachute Canopy,” J. Aircraft, Vol. 24, No. 2, pp. 65-72, 1987.

6. W. L. Garrard and T. A. Konicke , “Stress Measurements in Bias-Constructed Parachute Canopies During Inflation and at Steady State,” J. Aircraft, Vol. 18, No. 10, pp. 881-886, Oct. 1981.

7. M. A. El-Sherif , “Smart Composites with Embedded Sensors for in-situ Monitoring and Diagnostic Systems,” Mat. Tech., Vol. 9, No. 7/8, pp. 141-144, July/Aug. 1994.

8. J. Radhakrishnan and M. A. El-Sherif , “Analysis on Spatial Intensity Modulation for Fiber-Optic Sensor Applications,” J. Optical Fiber Technology, Vol. 2, No. 1, pp. 114-126, Jan. 1996.