Energy Conversion in Shape Memory Alloy Heat Engine Part II: Simulation

Abstract

In this paper, a theoretical model proposed in Part I (Zhu et al., 2001a) is used to simulate the behavior of a twin crank NiTi SMA spring based heat engine, which has been experimentally studied by Iwanaga et al. (1988). The simulation results are compared favorably with the measurements. It is found that (1) output torque and heat efficiency decrease as rotation speed increase; (2) both output torque and output power increase with the increase of hot water temperature; (3) at high rotation speed, higher water temperature improves the heat efficiency. On the contrary, at low rotation speed, lower water temperature is more efficient; (4) the effects of initial spring length may not be monotonic as reported. According to the simulation, output torque, output power and heat efficiency increase with the decrease of spring length only in the low rotation speed case. At high rotation speed, the result might be on the contrary.

Get full access to this article

View all access options for this article.

References

Funakubo, H. (1987). Shape memory alloys. Gorden and Breach Science Publishers.

Iwanaga, H. , Tobushi, H. and Ito, H. (1988). Basic research on output power characteristics of a shape memory alloy heat engine. JSME Int. J., Series I, 31: 634-637.

Zhu, J. J. , Liang, N. G. , Liew, K. M. and Huang, W. M. (2001a). Energy conversion in shape memory alloy heat engine. Part I: Theory. J. Intell. Mater. Syst. Struct., 12: 127-132.

Zhu, J. J. , Liang, N. G. , Huang, W. M. , Liew, K. M. and Liu, Z. H. (2001b). A thermodynamic constitutive model for stress induced phase transformation in shape memory alloys. Int. J. Solids Struct. (in press).