Effect of Insulation Location on Initial Transient Thermal Response of Building Walls

Abstract

The effect of insulation location on the heat transfer characteristics of building wall elements under initial transient conditions is studied. Thermal performance with an insulation layer placed on the inside of a wall is compared to that when the insulation layer is placed on the outside. The investigation is carried out for the climatic conditions of Riyadh, Saudi Arabia, during representative days for July and January using a finite-volume implicit procedure. The initial temperature distribution across the wall is assumed to be uniform and equal to the daily mean external air temperature. The numerical model is validated against a semi-analytic solution developed for a simple test case. The results of model application under the present conditions show that placing the insulation on the inside gives an instantaneous load that is about 20% of the value for outside insulation during the first few hours in the initial transient process. Besides, the duration of the transient process which leads to steady periodic state, and thus, the period of thermal discomfort due to radiation exchange is much shorter for the inside insulation. The average heat transmission over the first 24 hours of air-conditioning operation with the inside insulation is about one-third of that with the outside insulation. The dynamic R-values are averaged over the first 24 hours and compared for various wall orientations, seasons and insulation locations. It is recommended that for spaces where the air-conditioning system is switched on and off intermittently, the insulation should be placed on the inside.

Keywords

thermal insulation building walls heat transmission finite volume

Get full access to this article

View all access options for this article.

References

Ozisik, M.N. Heat Conduction. New York: John Wiley & Sons, 2nd Edition (1993).

Zaki, G.M. and Hassan, K.

“Thermal Performance of Composite Building Components with Periodic Solar Insolation and Ambient Temperature.”

Solar & Wind Technology, 3, No. 2 (1986), 103–109.

Eben Saleh, M.A.

“Impact of Thermal Insulation Location on Buildings in Hot Dry Climates.”

Solar & Wind Technology, 7, No. 4 (1990), 393–406.

Eben Saleh, M.A.

“Thermal Insulation of Buildings in a Newly Built Environment of a Hot Dry Climate: The Saudi Arabian Experience.”

Int. J. Ambient Energy, 11, No. 3 (1990), 157–168.

Al-Nafeez, I. and Rogers, J.S.

“Thermal Performance of External Insulation in Continuous Use Buildings in Hot Arid Climates.”

Housing Science, 14, No. 3 (1990), 161–179.

Chen, H.-T. and Lin, J.-Y.

“Application of the Hybrid Method to Transient Heat Conduction in One-Dimensional Composite Layers.”

Computers & Structures, 39, No. 5 (1991), 451–458.

Al-Mujahid, A. and Zedan, M.F.

“Transient Heat Conduction Response of a Composite Plane Wall.”

Warme und Stoffubertragung, 26 (1991), 1–7.

Zedan, M.F. and Mujahid, A.M.

“An Efficient Solution for Heat Transfer in Composite Walls with Periodic Ambient Temperature and Solar Radiation.”

Int. J. Ambient Energy, 14, No. 2 (1993), 83–98.

Ghrab-Marcos, N.

“Energy and Financial Considerations Related to Wall Design for a Conditioned Cell in Tunisian Conditions.”

Renewable Energy, 1, No. 1 (1991), 145–159.

10.

Burch, D.M. , Seem, J.E. , Walton, G.N. and Licitra, B.A.

“Dynamic Evaluation of Thermal Bridges in a Typical Office Building.”

ASHRAE Trans., 98, Pt. 1 (1992), 291–304.

11.

Al-Ragib, E. and Zubair, S.M.

“Transient Heat Transfer through Insulated Walls.”

Energy(Oxford), 20, No. 7 (1995), 687–694.

12.

Al-Sanea, S.A.

“Evaluation of Heat Transfer Characteristics of Building Wall Elements.”

J. King Saud Univ., 12, Eng. Sci. No. 2 (2000), 285–313.

13.

Lindfors, A. , Christoffersson, A. , Roberts, R. and Anderlind, G.

“Model Based Frequency Domain Estimation of the Thermal Properties of Building Insulation.”

J. Thermal Insul. and Bldg. Envs, 18, January (1995), 229–260.

14.

Norlen, U.

“A State-Space Model for Estimation of Thermal Parameters of a Homogeneous Slab.”

J. Thermal Insul. and Bldg. Envs, 18, April (1995), 327–349.

15.

Kossecka, E. and Kosny, J.

“Equivalent Wall as a Dynamic Model for a Complex Thermal Structure.”

J. Thermal Insul. and Bldg. Envs, 20, January (1997), 249–268.

16.

Kossecka, E.

“Relationships between Structure Factors, Response Factors, and Z-Transfer Function Coefficients for Multilayer Walls.”

ASHRAE Trans., 104 (1A), (1998), 68–77.

17.

Bojic, M.Lj. and Loveday, D.L.

“The Influence on Building Thermal Behavior of the Insulation/Masonry Distribution in a Three-Layered Construction.”

Energy and Buildings, 26, No. 2 (1997), 153–157.

18.

Kossecka, E. and Kosny, J.

“The Effect of Insulation and Mass Distribution in Exterior Walls on the Dynamic Thermal Performance of Whole Buildings.”

Conference Proceedings: “Thermal Performance of the Exterior Envelopes of Buildings VII,”

December 6–10, 1998, Clearwater Beach, Florida, 721–731.

19.

Al-Sanea, S.A. and Zedan, M.F. “Effect of Insulation Location on Thermal Performance of Building Walls under Steady Periodic Conditions.” Accepted for publication in Int. J. Ambient Energy, (2001).

20.

ASHRAE , Handbook of Fundamentals, American Society of Heating, Refrigerating and Air-Conditioning Engineers, Inc., Atlanta (1993).

21.

Garg, H.P. Treatise on Solar Energy, Volume 1: Fundamentals of Solar Energy. Chichester: John Wiley & Sons (1982), Chapter 3.

22.

Chu, H.-S. , Chen, C.-K. and Weng, C.-I.

“Applications of Fourier Series Technique to Transient Heat Transfer Problem.”

Chem. Eng. Commun., 16 (1982), 215–225.

23.

Croy, D.E. and Dougherty, D.A. Handbook of Thermal Insulation Applications. NewJersey: Noyes Publications (1984).

24.

Private communication, Meteorological and Environmental Protection Agency, Riyadh, Saudi Arabia (1997).