The gases evolved during the sintering of BaTiO3 have been examined with a combined dilatometer and mass spectrometer (CDMS) apparatus. The CDMS acquires multiple mass/charge ratios in real time while simultaneously recording dilatometry data. To identify the chemical composition of the numerous recorded mass/charge ratios, cracking patterns, isotopic abundances and decomposition reactions from model compounds (BaCO3, BaSO4) were used. Three primary regions of gas evolution were identified. During the heating ramp and into the hold period at 1350°C, CO2 appears, and below approximately 500°C, this may arise from adsorbed or surface CO2. Sulphur dioxide was also observed, and its evolution occurred directly after the majority of the CO2 appeared and immediately preceded the onset of sintering. Above 1200°C, CO2 is the primary species observed in the gas phase. The implications of the high temperature chemistry on sintering and on microstructural development are discussed.
MargraveJ. L.: ‘The characterization of high-temperature vapors’; 1967, New York, John Wiley & Sons.
2.
HastieJ. H.: ‘High temperature vapors: science and technology’; 1975, New York, Academic Press.
3.
HastieJ. H., ed.: ‘Characterization of high temperature vapors and gases’, NBS Special Publication 561, Vol. 1; 1979, Washington, DC, U.S. Department of Commerce.
4.
SomorjaiG. A.: ‘Studies of the sublimation mechanism of solids’ in ‘Advances in high temperature chemistry’, (ed. EyringL.), Vol. 2, 203–234; 1969, New York, Academic Press.
5.
WorrelW. L.: ‘Dissociation of gaseous molecules on solids at high temperature’ in ‘Advances in high temperature chemistry’, (ed. EyringL.), Vol. 4, 71–105; 1971, New York, Academic Press.
6.
SchurwanzM., YunJ. W., KimC. S. and LombardoS. J.: ‘Evolved gas analysis during sintering of strontium titanate’, Adv. Appl. Ceram., 2012, 111, 443–449. doi: 10.1179/1743676111Y.0000000035
7.
JaffeB., CookW. R. and JaffeH.: ‘Piezoelectric ceramics’, 1971, Marietta, OH, Academic Press.
8.
BuchananR. C., ed.: ‘Ceramic materials for electronics’, 3rd ed., 2004, New York, Marcel Dekker.
9.
LópezM. D. C. B., FourlarisG., RandB. and RileyF. L.: ‘Characterization of barium titanate powders: barium carbonate identification’, J. Amer. Ceram. Soc., 1999, 82, 1777–1786. doi: 10.1111/j.1151-2916.1999.tb01999.x
10.
CabreraA. L., VargasF. and ZarateR. A.: ‘Adsorption of carbon dioxide by barium titanate: evidence of adsorption process mediated by a dipole-dipole interaction’, J. Phys. Chem. Solids., 1994, 55, 1303–1307. doi: 10.1016/0022-3697(94)90213-5
11.
MullensJ., Van WerdeK., VanhoylandG., NouwenR., Van BaelM. K. and Van PouckeL. C.: ‘The use of TGA-MS, TGA-FTIR, HT-XRD, and HT-DRIFT for the preparation and characterization of PbTiO3 and BaTiO3’, Thermochimica Acta, 2002, 392–393, 29–35. doi: 10.1016/S0040-6031(02)00067-9
12.
HérardC., FaivreA. and LamaîtreJ.: ‘Surface decontamination treatments of undoped BaTiO3—Part I: Powder and green body properties’, J. Europ. Ceram. Soc., 1995, 15, 135–143. doi: 10.1016/0955-2219(95)93059-C
13.
HérardC., FaivreA. and LamaîtreJ.: ‘Surface decontamination treatments of undoped BaTiO3—Part II: Influence on sintering’, J. Europ. Ceram. Soc., 1995, 15, 145–153. doi: 10.1016/0955-2219(95)93060-G
14.
FengK. and LombardoS. J.: ‘High-temperature reaction networks in graphite furnaces’, J. Mat. Sci., 2002, 37, 2747–2753. doi: 10.1023/A:1015829418994
15.
FengK. and LombardoS. J.: ‘Kinetic analysis from dilatometry and mass spectrometry measurements of the decomposition and sintering of calcium carbonate’, J. Ceram. Proc. Res., 2002, 3, 101–108.
16.
MossM.: ‘Combined dilatometry and mass spectrometry of sintering and evolved gases of barium titanate and zirconium diboride with sintering additives’, 2012, M. S. Thesis, University of Missouri, Columbia, MO.
17.
TurlierP.: ‘BaTiO3 synthesis and some of its properties’, Chim. Mod., 1959, 4, 135–136.
18.
MalyshL. A., GaisinL. G., VolkovaM. F., ProkhorovA. G. and TkachevK. V.: ‘Reduction of recycled barium sulfate’, Russ. J. Appl. Chem., 2002, 75, 14–17. doi: 10.1023/A:1015592117853
19.
KresseR., BaudisU., JägerP., RiechersH. H., WagnerH. and WolfH. U.: ‘Barium and barium compounds’ in ‘Ullmann's encyclopedia of industrial chemistry’, (ed. H. Pelc), 1–21; 2007, Hoboken, NJ, John Wiley & Sons, http://dx.doi.org/10.1002/14356007.a03_325.pub2, (retrieved April 17, 2012).
20.
KubotaN., SekimotoT. and ShimizuK.: ‘Precipitation of BaCO3 in a semi-batch reactor with double-tube gas injection nozzle’, J. Cryst. Grow., 1990, 102, 434–440. doi: 10.1016/0022-0248(90)90402-7
21.
PerryD. L., ed.: ‘Inorganic compound data’ in ‘Handbook of inorganic compounds’, (ed. D. L. Perry), 2nd ed., 51; 2011, Boca Raton, FL, CRC Press.
22.
SöhnelO. and NovotnyP.: ‘Densities of aqueous solutions of inorganic substances’ in ‘Handbook of chemistry and physics’, (ed. W. M. Haynes), 92 ed., 5-190–195, 2011, Boca Raton, FL, CRC Press.
23.
PatnaikP.: ‘Handbook of inorganic chemical compounds’, 119; 2003, New York, McGraw-Hill.
24.
ReckE. and RichardsM.: ‘TiO2 manufacture and life cycle analysis’, Pig. Res. Tech., 1999, 28, 149–157. doi: 10.1108/03699429910271297
25.
CourseyJ. S., SchwabD. J., TsaiJ. J. and DragosetR. A.: ‘Atomic weights and isotopic compositions’, National Institute of Standards and Technology, Gaithersburg MD, http://www.nist.gov/pml/data/comp.cfm, (retrieved October 13, 2015).
26.
SteinS. E.: ‘Mass spectra’, in ‘NIST chemistry WebBook, NIST standard reference database number 69’ (ed. LinstromP. J. and MallardW. G.), Gaithersburg, MD, National Institute of Standards and Technology, http://webbook.nist.gov, (retrieved October 13, 2015).
27.
LeeS., RandallC. A. and LiuZ. K.: ‘Modified phase diagram for the barium oxide-titanium oxide system for the ferroelectric barium titanate’, J. Amer. Ceram. Soc., 2007, 90, 2589–2594. doi: 10.1111/j.1551-2916.2007.01794.x
28.
LeeS., RandallC. A. and LiuZ. K.: ‘Comprehensive linkage of defects and phase equilibria through ferroelectric transition behavior in BaTiO3-based dielectrics: Part 2: Defect modeling under low oxygen partial pressure conditions’, J. Amer. Ceram. Soc., 2008, 91, 1753–1761. doi: 10.1111/j.1551-2916.2008.02372.x
29.
LeeS., RandallC. A. and LiuZ. K.: ‘Factors limiting equilibrium in fabricating a simple ferroelectric oxide: BaTiO3’, J. Amer. Ceram. Soc., 2009, 92, 222–228. doi: 10.1111/j.1551-2916.2008.02859.x
30.
BakerE. H.: ‘A phase diagram for barium oxide–carbon dioxide in the eutectic region’, Nature, 1965, 206, 1250–1251. doi: 10.1038/2061250a0
