The effect of the near-surface deformed layer on the corrosion behaviour of AA2198-T851 Al–Cu–Li alloy has been investigated using microscopy and electrochemical techniques. This shows that a deformed layer developed by rolling was more active but only exhibited superficial attack compared to a mechanically polished surface, which produced severe localised corrosion associated with the presence of hexagonal T1 particles. The rolled surface became increasingly corrosion resistant with time, but when coupled, galvanically enhanced severe localised corrosion sites developed on the surface over time.
AfsethANordlienJScamansGEffect of heat treatment on filiform corrosion of aluminium alloy AA3005. Corros Sci. 2001; 43: 2093–2109. [cited 2015 Nov 23]. Available from: http://www.sciencedirect.com/science/article/pii/S0010938X01000142. doi: 10.1016/S0010-938X(01)00014-2
3.
WangJZhouXThompsonGEDelamination of near-surface layer on cold rolled AlFeSi alloy during sheet forming. Mater Charact. 2015; 99: 109–117. doi: 10.1016/j.matchar.2014.11.011
4.
WangJZhouXThompsonGEMicrostructure evolution in the near-surface region during homogenization of a twin-roll cast AlFeMnSi alloy. Metall Mater Trans A Phys Metall Mater Sci. 2016; 47: 4268–4275. doi: 10.1007/s11661-016-3568-6
5.
LiuYHashimotoTZhouXInfluence of near-surface deformed layers on filiform corrosion of AA3104 aluminium alloy. Surf Interface Anal. 2013; 45: 1553–1557. doi: 10.1002/sia.5232
6.
SeongJYangFScheltensFInfluence of the altered surface layer on the corrosion of AA5083. J Electrochem Soc. 2015; 162: C209–C218. doi: 10.1149/2.0321506jes
7.
LiuYZhouXThompsonGEPrecipitation and corrosion behaviour of nano-structured near-surface layers on an AA6111 aluminium alloy. J Phys Conf Ser. 2006; 26: 103–106. doi: 10.1088/1742-6596/26/1/024
8.
ZhaoZFrankelGS.The effect of temper on the first breakdown in AA7075. Corros Sci. 2007; 49: 3089–3111. doi: 10.1016/j.corsci.2007.02.004
9.
ForsythPJE.Sequence of corrosion attack of machining induced flow zone produced on some Al alloys that leads to rapid intergranular penetration. Mater Sci Technol. 1998; 14: 151–160. doi: 10.1179/mst.1998.14.2.151
10.
WangS-SYangFFrankelGS.Effect of altered surface layer on localized corrosion of aluminum alloy 2024. J Electrochem Soc. 2017; 164: C317–C323. doi: 10.1149/2.1541706jes
11.
ZhaoZFrankelGS.On the first breakdown in AA7075-T6. Corros Sci. 2007; 49: 3064–3088. doi: 10.1016/j.corsci.2007.02.001
AmbatRDavenportAJAfsethAElectrochemical behavior of the active surface layer on rolled aluminum alloy sheet. J Electrochem Soc. 2004; 151: B53–B58. doi: 10.1149/1.1635828
ShimizuKBrownGMKobayashiKThe early stages of high temperature oxidation of an Al-0.5 wt% Mg alloy. Corros Sci. 1998; 40: 557–575. doi: 10.1016/S0010-938X(97)00153-4
17.
DasSMoralesATRiahiARRole of plastic deformation on elevated temperature tribological behavior of an Al-Mg alloy (AA5083): A friction mapping approach. Metall Mater Trans A Phys Metall Mater Sci. 2011; 42: 2384–2401. doi: 10.1007/s11661-011-0649-4
18.
FieldDJScamansGMButlerEP.The high temperature oxidation of Al-4.2 wt pct Mg alloy. Metall Trans A. 1987; 18: 463–472. doi: 10.1007/BF02648807
19.
ZhouXLiuYThompsonGENear-surface deformed layers on rolled aluminum alloys. Metall Mater Trans A Phys Metall Mater Sci. 2011; 42: 1373–1385. doi: 10.1007/s11661-010-0538-2
20.
DonatusUBerbelLOCostaI.Qualitative use of potentiodynamic polarization and anodic hydrogen evolution in the assessment of corrosion susceptibility in AA2198-T851 Al – Cu – Li alloy. Mater Corros. 2018: 1–14.
21.
DonatusUde ViveirosBVGde AlencarMCCorrelation between corrosion resistance, anodic hydrogen evolution and microhardness in friction stir weldment of AA2198 alloy. Mater Charact. 2018; 144: 99–112. doi: 10.1016/j.matchar.2018.07.004
22.
SongYShanDChenRCorrosion characterization of Mg-8Li alloy in NaCl solution. Corros Sci. 2009; 51: 1087–1094. doi: 10.1016/j.corsci.2009.03.011
AnikMCeliktenG.Analysis of the electrochemical reaction behavior of alloy AZ91 by EIS technique in H3PO4/KOH buffered K2SO4 solutions. Corros Sci. 2007; 49: 1878–1894. doi: 10.1016/j.corsci.2006.10.016
OguzieEELiJLiuYThe effect of Cu addition on the electrochemical corrosion and passivation behavior of stainless steels. Electrochim Acta. 2010; 55: 5028–5035. doi: 10.1016/j.electacta.2010.04.015
29.
BursteinGTCindereyRJ.The potential of freshly generated metal surfaces determined from the guillotined electrode-A new technique. Corros Sci. 1991; 32: 1195–1211. doi: 10.1016/0010-938X(91)90132-9
30.
CaoF-HZhangZSuJ-XElectrochemical impedance spectroscopy analysis on aluminum alloys in EXCO solution. Mater Corros. 2005; 56: 318–324. doi: 10.1002/maco.200403844
31.
ZucchiFFrignaniAGrassiVOrgano-silane coatings for AZ31 magnesium alloy corrosion protection. Mater Chem Phys. 2008; 110: 263–268. doi: 10.1016/j.matchemphys.2008.02.015
32.
LaurentCSceniniFMonettaTThe contribution of hydrogen evolution processes during corrosion of aluminium and aluminium alloys investigated by potentiodynamic polarisation coupled with real-time hydrogen measurement. Npj Mater Degrad. 2017; 1: 6. doi: 10.1038/s41529-017-0011-4
33.
HuangR-SLinC-JIsaacsHS.A difference-imaging technique used to study streaking corrosion of aluminum alloys AA7075 and AA8006 in chloride solution. Electrochem Solid-State Lett. 2006; 9: B11–B14. doi: 10.1149/1.2140503
34.
DonatusUTeradaMOspinaCROn the AA2198-T851 alloy microstructure and its correlation with localized corrosion behaviour. Corros Sci. 2018; 131: 300–309. doi: 10.1016/j.corsci.2017.12.001
35.
de Sousa AraujoJVDonatusUQueirozFMOn the severe localized corrosion susceptibility of the AA2198-T851 alloy. Corros Sci. 2018; 133: 132–140. doi: 10.1016/j.corsci.2018.01.028
DonatusUThompsonGEElabarDFeatures in aluminium alloy grains and their effects on anodizing and corrosion. Surf Coatings Technol. 2015; 277: 91–98. doi: 10.1016/j.surfcoat.2015.07.034
38.
DonatusUThompsonGEZhouXGrain distinct stratified nanolayers in aluminium alloys. Mater Chem Phys. 2017; 188: 109–114. doi: 10.1016/j.matchemphys.2016.12.021
39.
DonatusUThompsonGEOmotoyinboJACorrosion pathways in aluminium alloys. Trans Nonferrous Met Soc China. 2017; 27: 55–62. doi: 10.1016/S1003-6326(17)60006-2
40.
ZhangXZhouXHashimotoTCorrosion behaviour of 2A97-T6 Al-Cu-Li alloy: the influence of non-uniform precipitation. Corros Sci. 2018; 132: 1–8. doi: 10.1016/j.corsci.2017.12.010
41.
MaZYZhouXLiaoYLocalised corrosion in AA 2099-T83 aluminium-lithium alloy: the role of grain orientation. Corros Sci. 2015; 107: 41–48. doi: 10.1016/j.corsci.2016.02.018
42.
LuoCAlbuSPZhouXContinuous and discontinuous localized corrosion of a 2xxx aluminium-copper-lithium alloy in sodium chloride solution. J Alloys Compd. 2016; 658: 61–70. doi: 10.1016/j.jallcom.2015.10.185
43.
LuoCZhangXZhouXCharacterization of localized corrosion in an Al-Cu-Li Alloy. J Mater Eng Perform. 2016; 25: 1811–1819. doi: 10.1007/s11665-016-2010-y
44.
ProtonVAlexisJAndrieuEThe influence of artificial ageing on the corrosion behaviour of a 2050 aluminium-copper-lithium alloy. Corros Sci. 2014; 80: 494–502. doi: 10.1016/j.corsci.2013.11.060
45.
ProtonVAlexisJAndrieuECharacterisation and understanding of the corrosion behaviour of the nugget in a 2050 aluminium alloy Friction Stir Welding joint. Corros Sci. 2013; 73: 130–142. doi: 10.1016/j.corsci.2013.04.001
46.
ProtonVAlexisJAndrieuEInfluence of post-welding heat treatment on the corrosion behavior of a 2050-T3 aluminum-copper-lithium alloy friction stir welding joint. J Electrochem Soc. 2011; 158: C139–C147. doi: 10.1149/1.3562206
