A short process of direct cold rolling of continuous casting billets following solution treatment is proposed, and the effect of cold-rolled reduction on the microstructure evolution and corrosion resistance of lean duplex stainless steel (LDSS) 2101 is investigated. The results show that when the cold-rolled reduction increased to 50%, the strain-induced martensite (SIM) engulfed the austenite along the annealing twin boundaries (TBs). Furthermore, the galvanic corrosion of the martensite and matrix combined with the decreasing fraction of the low-Σ CSL boundaries results in a significant reduction in corrosion resistance at 50% cold-rolled reduction. Additionally, the majority of metastable pits were generated within the ferrite grains and at the α/γ phase boundaries.
LuoH, WangX, DongC, . Effect of cold rolled reduction on the corrosion behaviour of UNS S31803 duplex stainless steel in simulated concrete pore solution. Corros Sci. 2017;124:178–192. doi:10.1016/j.corsci.2017.05.021
2.
Rodríguez-GarcíaJ, RuizA.New insights into the nondestructive evaluation of thermally aged at 475°C duplex stainless steels: a comparative study between 2507 and 2101 duplex stainless steels. J Mater Eng Perform. 2022;31(3):13. doi:10.1007/s11665-022-06746-z
3.
FalodunOE, MtsweniEB, OkeSR, . Influence of solution heat treatment on microstructure and mechanical properties of a Hot-rolled 2205 duplex stainless steel. J Mater Eng Perform. 2021;30:7185–7194. doi:10.1007/s11665-021-05904-z
4.
MoallemiM, Zarei-HanzakiA, EskandariM, . Comprehensive deformation analysis of a newly designed Ni-free duplex stainless steel with enhanced plasticity by optimizing austenite stability. Metall Mater Trans A. 2017;48(8):3675. doi:10.1007/s11661-017-4122-x
5.
SilvaR, VacchiGS, KugelmeierCL, . New insights into the hardening and pitting corrosion mechanisms of thermally aged duplex stainless steel at 475°C: a comparative study between 2205 and 2101 steels. J Mater Sci Technol. 2022;98:123–135. doi:10.1016/j.jmst.2021.04.046
6.
HaHY, JoHH, LeeJJ, . Effect of combined addition of N and C on high-temperature deformation behavior of LDSS 2101 type lean duplex stainless steels. Mater Today Commun. 2021;29:102749. doi:10.1016/j.mtcomm.2021.102749
7.
ChoiJY, JiJH, HwangSW, . TRIP aided deformation of a near-Ni-free, Mn-N bearing duplex stainless steel. Mater Sci Eng A. 2012;535:32–39. doi:10.1016/j.msea.2011.12.037
8.
ToorIH, HyunPJ, KwonHS.Development of high Mn-N duplex stainless steel for automobile structural components. Corros Sci. 2008;50(2):404–410. doi:10.1016/j.corsci.2007.07.004
9.
ByunTS.On the stress dependence of partial dislocation separation and deformation microstructure in austenitic stainless steels. Acta Mater. 2003;51:3063–3071. doi:10.1016/S1359-6454(03)00117-4
10.
ZhangHW, HeiZK, LiuG, . Formation of nanostructured surface layer on AISI 304 stainless steel by means of surface mechanical attrition treatment. Acta Mater. 2003;51:1871–1881. doi:10.1016/S1359-6454(02)00594-3
11.
YvellK, GrehkTM, HedströmP, . Microstructure development in a high-nickel austenitic stainless steel using EBSD during in situ tensile deformation. Mater Charact. 2018;135:228–237. doi:10.1016/j.matchar.2017.11.046
12.
TianY, LinS, Peter KoJY, . Micromechanics and microstructure evolution during in situ uniaxial tensile loading of TRIP-assisted duplex stainless steels. Mater Sci Eng, A. 2018;734:281–290. doi:10.1016/j.msea.2018.07.040
13.
OlsonGB, CohenM.A general mechanism of martensitic nucleation: part I. General concepts and the FCC → HCP transformation. Metall Trans A. 1976;7(12):1897–1904. doi:10.1007/BF02659822
14.
ChenL, JiaQ, HaoS, . The effect of strain-induced martensite transformation on strain partitioning and damage evolution in a duplex stainless steel with metastable austenite. Mater Sci Eng, A. 2021;814:141173. doi:10.1016/j.msea.2021.141173
15.
HaoS, ChenL, ZouZ, . Microstructural evolution and cyclic softening/hardening response of a TRIP-assisted duplex stainless steel. Mater Sci Eng, A. 2021;811(2):141026. doi:10.1016/j.msea.2021.141026
16.
NakadaN, HidetoshiI, YoshikazuM, . Deformation-induced martensitic transformation behavior in cold-rolled and cold-drawn type 316 stainless steels. Acta Mater. 2010;58:895–903. doi:10.1016/j.actamat.2009.10.004
17.
YinL, LiuY, QianS, . Synergistic effect of cold work and hydrogen charging on the pitting susceptibility of 2205 duplex stainless steel. Electrochim Acta. 2019;328:135081. doi:10.1016/j.electacta.2019.135081
18.
QuitzkeC, SchroderC, UllrichC, . Evaluation of strain-induced martensite formation and mechanical properties in N-alloyed austenitic stainless steels by in situ tensile tests. Mater Sci Eng, A. 2021;808:140930. doi:10.1016/j.msea.2021.140930
19.
BibhanshuN, GussevMN, ByunTS.Two-step deformation-induced martensitic transformation in additively manufactured high-Si stainless steel. Mater Sci Eng, A. 2022;861:144341. doi:10.1016/j.msea.2022.144341
WatanabeT, AraiKI, YoshimiK, . Texture and grain boundary character distribution (GBCD) in rapidly solidified and annealed Fe 6.5 mass% Si ribbons. Philos Mag Lett. 1989;59(2):47–52. doi:10.1080/09500838908214776
22.
KobayashiS, KobayashiR, WatanabeT.Control of grain boundary connectivity based on fractal analysis for improvement of intergranular corrosion resistance in SUS316L austenitic stainless steel. Acta Mater. 2016;102:397–405. doi:10.1016/j.actamat.2015.08.075
23.
WatanabeT.Grain boundary engineering: historical perspective and future prospects. J Mater Sci. 2011;46(12):4095–4115. doi:10.1007/s10853-011-5393-z
24.
WatanabeT, SadahiroT.The control of brittleness and development of desirable mechanical properties in polycrystalline systems by grain boundary engineering. Acta Mater. 1999;47:4171–4185. doi:10.1016/S1359-6454(99)00275-X
25.
MishraS, NarasimhanK, SamajdarI.Deformation twinning in AISI 316L austenitic stainless steel: role of strain and strain path. Met Sci J. 2007;23(9):1118–1126. doi:10.1179/174328407X213242
26.
MarinaO, BelyakovA, . Development of nanocrystalline 304L stainless steel by large strain cold working. Metals (Basel). 2015;5(2):656–668. doi:10.3390/met5020656
27.
CaoCN.On the impedance plane displays for irreversible electrode reactions based on the stability conditions of the steady-state-I. One state variable besides electrode potential. Electrochim Acta. 1990;35(5):831–836. doi:10.1016/0013-4686(90)90077-D
28.
Garfias-MesiasL, SykesJM, TuckCS.The effect of phase compositions on the pitting corrosion of 25 Cr duplex stainless steel in chloride solutions. Corros Sci. 1996;38(8):1319–1330. doi:10.1016/0010-938X(96)00022-4
29.
DengB, WangZY, JiangYM, . Effect of thermal cycles on the corrosion and mechanical properties of UNS S31803 duplex stainless steel. Corros Sci. 2009;51:2969–2975. doi:10.1016/j.corsci.2009.08.015
