Surface analysis of stationary shoulder friction stir processed AZ31B magnesium alloy

Abstract

We propose a stationary shoulder friction stir process (SSFSP) to produce a smooth surface finish. The use of a stationary shoulder tool contributes to reducing the heat input during friction stir processing (FSP). Hence, a stationary shoulder tool is advantageous for FSP in heat sensitive alloys like magnesium. The present short communication investigates the surface finish of AZ31B magnesium alloy processed by SSFSP without using additional cooling. Surface analysis of the processed region was carried out by 2D and 3D surface mapping using digital microscopy. The surface mapping indicated that there was very little flash generation on the processed zone, while 3D mapping quantified the surface roughness in the longitudinal as well as transverse directions of the processing zone.

Keywords

Stationary shoulder friction stir processing magnesium alloy surface finish

Get full access to this article

View all access options for this article.

References

, Feng

, Chen

, Recent advances in friction stir welding/processing of aluminum alloys: microstructural evolution and mechanical properties. Crit Rev Solid State Mater Sci. 2018;43(4):269–333.

Mishra

, Ma

ZY.

Friction stir welding and processing. Mater Sci Eng R Rep. 2005;50(1):1–78.

Patel

, Badheka

, Kumar

Influence of friction stir processed parameters on superplasticity of Al-Zn-Mg-Cu alloy. Mater Manuf Process. 2016;31(12):1573–1582.

Gao

, Cui

, Liu

, Application and exploration of friction stir welding/processing in plastics industry. Mater Sci Technol. 2017;33(10):1145–1158.

Gerlich

AP.

Critical assessment 25: friction stir processing, potential and problems. Mater Sci Technol. 2017;33(10):1139–1144.

Alavi Nia

, Omidvar

, Nourbakhsh

SH.

Effects of an overlapping multi-pass friction stir process and rapid cooling on the mechanical properties and microstructure of AZ31 magnesium alloy. Mater Des. 2014;58(Supplement C):298–304.

Chai

, Zhang

, Li

YY.

Effect of rotation speeds on microstructures and tensile properties of submerged friction stir processed AZ31 magnesium alloy. Mater Res Innov. 2014;18:152–156.

Darras

, Kishta

Submerged friction stir processing of AZ31 magnesium alloy. Mater Des. 2013;47(Supplement C):133–137.

, Meng

, Liu

, Formation and mechanical properties of stationary shoulder friction stir welded 6005A-T6 aluminum alloy. Mater Des. 2014;62:113–117.

10.

, Liu

Effects of tool rotation speed on microstructures and mechanical properties of AA2219-T6 welded by the external non-rotational shoulder assisted friction stir welding. Mater Des. 2013;43:299–306.

11.

Barbini

, Carstensen

, dos Santos

JF.

Influence of a non-rotating shoulder on heat generation, microstructure and mechanical properties of dissimilar AA2024/AA7050 FSW joints. J Mater Sci Technol. 2018;34(1):119–127.

12.

, Niu

, Yan SR , Improving microstructural and tensile properties of AZ31B magnesium alloy joints by stationary shoulder friction stir welding. J Manuf Process. 2019;37:159–167.

13.

Patel

, Li

, Xu

Stationary shoulder tool in friction stir processing: a novel low heat input tooling system for magnesium alloy. Mater Manuf Process. 2019;34:177–182. doi:10.1080/10426914.2018.1544716.