Effects of powder material and process parameters on the roll compaction,sintering and cold rolling of titanium sponge

Abstract

Roll compaction is a powder metallurgy process that has the potential for cost reduction in the production of titanium parts. In this study, experiments were carried out to investigate the effects of powder type and size on the roll compaction and subsequent sintering and cold rolling behaviour of titanium powder. Powders used ranged in upper sieve sizes from 0.15 to 3 mm. Strip density was found to increase with decreasing powder size while thickness decreased. Following sintering in the range of 800–1200°C, cold rolling was performed with various levels of thickness reduction. Average (across the width) densities of up to 88% were achieved, with higher density regions in the middle of the strips reaching up to 99%. Roll force was measured during cold rolling and found to increase with increasing final (post-cold rolling) density and also with increasing roll gap reduction amounts.