Search results: Sage Journals

Restricted accessResearch articleFirst published February, 2020

Two-Dimensional Temperature Measurement in a High-Temperature and High-Pressure Combustor Using Computed Tomography Tunable Diode Laser Absorption Spectroscopy (CT-TDLAS) with a Wide-Scanning Laser at 1335–1375 nm

Zhenzhen Wang, Wangzheng Zhou, Takahiro Kamimoto [...]

Applied Spectroscopy

Restricted accessResearch articleFirst published December, 2000

Transient two-dimensional temperature measurement of open flames by dual-spectral image analysis

Y. Huang, Y. Yan

Transactions of the Institute of Measurement and Control

Restricted accessResearch articleFirst published July, 2008

Two-Dimensional Temperature Measurements in Flames Using Filtered Rayleigh Scattering at 254 nm

Johan Zetterberg, Zhongshan Li, Mikael Afzelius [...]

Applied Spectroscopy

Restricted accessResearch articleFirst published September, 1996

Two-Dimensional Gas-Phase Temperature Measurements Using Fluorescence Lifetime Imaging

Tuqiang Ni, Lynn A. Melton

Applied Spectroscopy

Restricted accessResearch articleFirst published January, 2016

Simultaneous two-dimensional measurement of fuel–air ratio and temperature in a direct-injection spark-ignition engine using a new tracer-pair laser-induced fluorescence technique

Susanne Lind, Lars Zigan, Johannes Trost [...]

International Journal of Engine Research

Restricted accessResearch articleFirst published January, 2023

In-cylinder thermographic PIV combined with phosphor thermometry using ZnO:Zn

Andreas Kopf, Valerio Frattina, Michele Bardi [...]

International Journal of Engine Research

Restricted accessResearch articleFirst published July, 1991

Temperature in Rubber Moldings during Injection Molding Cycle: Simulation and Experimentation

A.I. Isayev, Toru Hosaki

Journal of Elastomers & Plastics

Restricted accessResearch articleFirst published August, 2002

Transient response of an erodable heat flux gauge using finite element analysis

D R Buttsworth

Proceedings of the Institution of Mechanical Engineers,Part D: Journal of Automobile Engineering

Free accessResearch articleFirst published November, 2018

Thermal compensation using the hybrid metrology approach compared to traditional scaling

David Ross-Pinnock, Glen Mullineux

Proceedings of the Institution of Mechanical Engineers,Part B: Journal of Engineering Manufacture

Restricted accessResearch articleFirst published July, 1999

The Contribution to Residual Stress by Differential Resin Shrinkage

Siamak Motahhari, John Cameron

Journal of Reinforced Plastics and Composites

Restricted accessResearch articleFirst published February, 2020

Two-Dimensional Temperature Measurement in a High-Temperature and High-Pressure Combustor Using Computed Tomography Tunable Diode Laser Absorption Spectroscopy (CT-TDLAS) with a Wide-Scanning Laser at 1335–1375 nm

Zhenzhen Wang, Wangzheng Zhou, Takahiro Kamimoto [...]

Applied Spectroscopy

Restricted accessResearch articleFirst published December, 2000

Transient two-dimensional temperature measurement of open flames by dual-spectral image analysis

Y. Huang, Y. Yan

Transactions of the Institute of Measurement and Control

Restricted accessResearch articleFirst published July, 2008

Two-Dimensional Temperature Measurements in Flames Using Filtered Rayleigh Scattering at 254 nm

Johan Zetterberg, Zhongshan Li, Mikael Afzelius [...]

Applied Spectroscopy

Restricted accessResearch articleFirst published September, 1996

Two-Dimensional Gas-Phase Temperature Measurements Using Fluorescence Lifetime Imaging

Tuqiang Ni, Lynn A. Melton

Applied Spectroscopy

Restricted accessResearch articleFirst published January, 2016

Simultaneous two-dimensional measurement of fuel–air ratio and temperature in a direct-injection spark-ignition engine using a new tracer-pair laser-induced fluorescence technique

Susanne Lind, Lars Zigan, Johannes Trost [...]

International Journal of Engine Research

Restricted accessResearch articleFirst published January, 2023

In-cylinder thermographic PIV combined with phosphor thermometry using ZnO:Zn

Andreas Kopf, Valerio Frattina, Michele Bardi [...]

International Journal of Engine Research

Restricted accessResearch articleFirst published July, 1991

Temperature in Rubber Moldings during Injection Molding Cycle: Simulation and Experimentation

A.I. Isayev, Toru Hosaki

Journal of Elastomers & Plastics

Restricted accessResearch articleFirst published August, 2002

Transient response of an erodable heat flux gauge using finite element analysis

D R Buttsworth

Proceedings of the Institution of Mechanical Engineers,Part D: Journal of Automobile Engineering

Free accessResearch articleFirst published November, 2018

Thermal compensation using the hybrid metrology approach compared to traditional scaling

David Ross-Pinnock, Glen Mullineux

Proceedings of the Institution of Mechanical Engineers,Part B: Journal of Engineering Manufacture

Restricted accessResearch articleFirst published July, 1999

The Contribution to Residual Stress by Differential Resin Shrinkage

Siamak Motahhari, John Cameron

Journal of Reinforced Plastics and Composites