Several liner-type treatments (three different rectangular grooves covered by three different low porosity wire-mesh screens) on the trailing edge of a flat plate have been investigated in the anechoic wind-tunnel of Université de Sherbrooke. Far-field acoustic directivity measurements have been achieved at Reynolds numbers based on the plate length from 7.3 × 10 5 to 1.7 × 10 6 , yielding radiation maps of all possible liner combinations that are then compared to the reference solid flat plate and to the plate with inserts alone. Noise from the flat plate corresponds to dipolar trailing-edge scattering with an extra shallow hump attributed to the unsteady flow recirculation behind the thick plate. When grooves are added, the latter contribution is amplified and additional cavity noise is observed with several tones and humps. The tones are shown to be resonance between high order modified Rossiter modes and cavity depthwise modes. The hump is a combination of drag dipoles and cavity monopoles from the groove row. The addition of screens always reduces the amplification of the dipolar edge scattering but exhibits very different non-linear responses for the cavity noise. The combination screen with the smallest cells and the insert with the shallowest cavities (corresponding to the same type of treatment applied previously on the Controlled-Diffusion airfoil) yields the lowest levels overall, while the screen with intermediate cell size almost always triggers noise amplification and the screen with a coarse mesh has an intermediate behavior. At high frequencies, the previously reported roughness noise is also observed.