Research on electromagnetic torque and fault parameter identification of pumped storage machine under power generation state based on optimized network parameter method 1

Abstract

Because of the complex and frequent multi-operation conditions of pumped storage machine and the difficulty of its numerical analysis, an optimized network parameter method (ONPM) is given to identify the second harmonic electromagnetic torque of large salient-pole generators. Different from the former research which only considers the positive and negative sequence components, the second harmonic electromagnetic torque of pumped storage machine under power generation state is identified in neutral point grounded system, which are displayed by the lumped parameters. Then, in order to test the validity of the theoretical analysis among power generation salient-pole generators, the finite element model of 300 MVA pumped storage machine under power generation is established. Through the comparison and analysis of the finite element result data with the actual experimental data in the steady state of no-load test and short-circuit test, the correctness of the finite element model is completely verified. Finally, in the case of small current asymmetry and large current asymmetry, the second harmonic electromagnetic torques obtained by ONPM and finite element method (FEM) are found respectively, and their relative errors are elaborately displayed. The results display that ONPM can accurately identify the electromagnetic torque parameters which indicate the specific operation and fault state of pumped storage machine under power generation state. This fault parameter identification has practical significance for monitoring and improving the operation state and stability of large salient-pole generator.

Keywords

Electromagnetic torque fault parameter identification finite element method (FEM)neutral point grounded system optimized network parameter method (ONPM)pumped storage machine under power generation state

Get full access to this article

View all access options for this article.

References

and Yang

, A hybrid calculation method of electromagnetic vibration for electrical machines considering high-frequency current harmonics, IEEE Transactions on Industrial Electronics 69(10) (2022), 10385–10395, doi:10.3906/10385-10395.

Diao

Zhao

Liu

, Permanent magnet assisted synchronous reluctance motor with asymmetric rotor for high torque performance, CES Transactions on Electrical Machines and Systems 7(2) (2023), 179–186.

Pang

Tong

, Design of rotor magnetic barrier structure of built-in permanent magnet motor based on Taguchi method, CES Transactions on Electrical Machines and Systems 7(2) (2023), 193–201.

Balasubramanian

Bhuiyan

N.A.

Javied

, Design and optimization of interior permanent magnet (IPM) motor for electric vehicle applications, CES Transactions on Electrical Machines and Systems 7(2) (2023), 202–209.

Zhao

, Torque improvement of spoke-type permanent magnet motor with auxiliary stator using harmonic current control strategy, CES Transactions on Electrical Machines and Systems 7(2) (2023), 210–217.

and Jing

, Multi-objective optimization analysis of auxiliary flux modulator magnetic gear with unequal magnetic poles, CES Transactions on Electrical Machines and Systems 7(4) (2023), 372–378, doi:10.30941/CESTEMS.2023.00040.

Zhao

Zhang

and Wei

, An integrated approach of a field-circuit coupling model and multi-physics finite-element simulation for analysing transient electromagnetic vibration of pump motors, IET Electric Power Applications 16(9) (2022), 1030–1056.

Ding

Zhao

, Electromagnetic vibration characteristics of high-frequency transformer under DC bias with different winding structures, Processes 11(4) (2023), 1185.

Tengfei

Huijuan

Qian

and Zhenyang

, Multi-physics and multi-objective optimisation design of interior permanent magnet synchronous motor for electric vehicles, IET Electric Power Applications 14(11) (2020), 2243–2254.

10.

Zhiyan

Ming

Jing

Jie

and Cunxiang

, An analytical method for calculating the cogging torque of a consequent pole hybrid excitation synchronous machine based on spatial 3D field simplification, Energies 15 (2022), 878, doi:10.3390/en15030878.

11.

Wenfei

Kai

Wei

Mingjin

Zhiheng

and Jiapeng

, A new high-speed dual-stator flux switching permanent magnet machine with distributed winding, IEEE Transactions on Magnetics 58(2) (2022).

12.

Wang

Yang

, Research on electromagnetic vibration characteristics of a permanent magnet synchronous motor based on multi-physical field coupling, Energies 16(9) (2023), 3916.

13.

Sun

Fan

, Low electromagnetic vibration design of double-layer interior permanent magnet machines for electric vehicle, Energy Reports 7 (2021), 147–156.

14.

Samraj

D.B.

and Perumal

M.P.

, Compatibility of electrical generators for harvesting extended power from wind energy conversion system, Measurement & Control 52 (2019), 1240–1251, doi:10.1177/0020294019858183.

15.

Zhou

H.S.

and Meng

G.W.

, Analytical calculation of magnetic field and cogging torque in surface-mounted permanent-magnet machines accounting for any eccentric rotor shape, IEEE Transactions on Industrial Electronics 62(6) (2015), 3438–3447, doi:10.1109/TIE.2014.2369458.

16.

Shin

K.H.

Park

H.I.

and Cho

H.W.

, Analytical calculation and experimental verification of cogging torque and optimal point in permanent magnet synchronous motors, IEEE Transactions on Magnetics 53(6) (2017), doi:10.1109/TMAG.2017.2667643.

17.

Yanping

Honghao

and Xu

, Finite-element calculation of 3-D transient electromagnetic field in end region and eddy-current loss decrease in stator end clamping plate of large hydrogenerator, IEEE Transactions on Industrial Electronics 62(12) (2015), 7331–7338.

18.

Wang

Tan

, Vibration tendency prediction approach for hydropower generator fused with multiscale dominant ingredient chaotic analysis, adaptive mutation grey wolf optimizer, and KELM, Complexity 2020 (2020), 1–20.

19.

Lin

, Comparison of electrical quantity characteristics with or without neural point on load side of 1400 MVA nuclear power turbo-generator, Electric Power Components and Systems 47(1–2) (2019), 141–152, doi:10.1080/15325008.2019.1576243.

20.

Xiaojie

Xunwen

Xianhui

Ying

Peng

, Impact of negative sequence current on electromagnetic torque in nuclear power and large size turbo-generators, IEEJ Transactions on Electrical and Electronic Engineering 16 (2021), 1298–1309, doi:10.1002/tee.23428.

21.

Xiaojie

Xunwen

Ying

Xianhui

and Peng

, Harmonic electromagnetic torque analysis of turbo-generators by a novel lumped magnetic parameter method and finite element method, Electric Power Components and Systems 0(0) (2021), 1–13, doi:10.1080/15325008.2021.1943065.

22.

Zhang

Z.B.

Fang

and Gao

, Multiple-vector model predictive power control for grid-tied wind turbine system with enhanced steady-state control performance, IEEE Transactions on Industrial Electronics 64(8) (2017), 6287–6298, doi:10.1109/TIE.2017.2682000.

23.

Wang

, Electromagnetic torque analysis of hydrogenerator based on fundamental electric quantity characteristics, Journal of Heilongjiang University of Science and Technology 33(2) (2023), 233–239.

24.

Wang

, Influence of negative sequence and zero sequence current on electromagnetic torque of pumped storage motor, Journal of Heilongjiang University of Science and Technology 33(3) (2023), 432–438.