Sage Journals: Discover world-class research

Abstract

Nickel plating is used on the surface of rolling rolls in paper mills, and it is important to monitor the thickness of the nickel plating. In this research, the electromagnetic inspection method for the thickness of the nickel plating using the difference in electromagnetic properties between the nickel and the base material of S25C steel is proposed. On the other hand, the detection signal is also affected by the changing distance (lift-off: L_o) between the proposed electromagnetic sensor and the nickel plating. In this paper, by measuring the magnetic field in two directions of the electromagnetic sensor, it is shown that both the thickness of the nickel plating and the lift-off (L_o) are evaluated.

Keywords

Nickel plating thickness evaluation lift-off electromagnetic field analysis

Get full access to this article

View all access options for this article.

References

Gotoh

Matsuoka

and Takahashi

, Measurement of thickness of nickel-layer on steel using electromagnetic method, IEEE Trans. on Magn.43 (2007), 2752–2754.

Staudt

G.E.

, Examination of uncertainty in plate thickness measurement by X-ray fluorescence spectrometry, AMP J Technol.3 (1993), 85–97.

Yoshinaga

Gotoh

Onita

Horino

and Misaka

, Proposed method for simultaneous inspection of lift-off and surface-hardened depth in induction-hardened steel plate using electromagnetic properties, Sensors and Materials34 (2022), 1007–1016.

Nakata

Kawase

and Nakano

, Improvement of measuring accuracy of magnetic field strength in single sheet testers by using two H coils, IEEE Trans. on Magn.23 (1987), 2596–2598.

Simultaneous electromagnetic evaluation method for surface thickness of nickel layer and lift-off on nickel coating steel by alternating magnetic field

Abstract

Keywords

Get full access to this article

References