If chip seals are constructed properly, they are a cost-effective means of extending the useable life of hot-mix asphalt pavements. Over the years, chip seals have been criticized because they sometimes do not perform as expected. This paper discusses the steps necessary to build chip seals that perform well, including project selection, specifications, material quality, and construction methods.
Get full access to this article
View all access options for this article.
References
1.
WoodT. J., and OlsonR. C.Rebirth of Chip Sealing in Minnesota. In Transportation Research Record: Journal of the Transportation Research Board, No. 1989, Vol. 1, Transportation Research Board of the National Academies, Washington D.C., 2007, pp. 260–264.
2.
TestaD. M.The Road to Pavement Preservation: The Kansas Department of Transportation Way. TR News, No. 247, Nov. 2006, pp. 11–18.
3.
WatsonM.Effect of Surface Treatment Timing on Low Temperature Properties of Asphalt Binders and Mixtures. MS thesis. University of Minnesota, Minneapolis, Apr. 2008.
4.
Special Provision No. 2356: Bituminous Seal Coat. In Special Provisions for Construction, Minnesota Department of Transportation, St. Paul, 2008, pp. 241–245.
5.
McLeodN. W.A General Method of Design for Seal Coats and Surface Treatments. Journal of the Association of Asphalt Paving Technologists, Vol. 38, 1969, pp. 537–629.
6.
WoodT. J., JanischD., and GaillardF.Minnesota Seal Coat Handbook, revised ed. Minnesota Local Road Research Board, Minnesota Department of Transportation, St. Paul, 2006.
