Use of Stiffness of Hot-Mix Asphalt as a Simple Performance Test

Abstract

The objective was to determine whether the stiffness of a mix could be used as a simple performance test (SPT) parameter to complement the Superpave® volumetric mix design. This was investigated by a statistical analysis of the strength of the correlation between different mixture stiffness parameters and field performance (rutting, thermal, and fatigue cracking). A total of 30 mixtures were tested with laboratory-fabricated specimens. The studied stiffness parameters were compressive dynamic (complex) modulus |E*|, simple shear tester (SST) shear (complex) modulus |G*|, and dynamic elastic modulus E_d, obtained from ultrasonic wave propagation. Also, computed stiffness factors |E*|/sin ϕ and |G*|/sin ϕ for rutting and |E*|sin ϕ for cracking were studied as analogous to the Superpave binder specification. Research indicated that the correlation to rutting varied based on test temperature and frequency; it peaked at 54.4°C and 5 Hz. At peak conditions, |E*|/sin ϕ had better statistical correlation to rutting than |E*|, but correlations reversed at lower frequencies. Although |E*| and |G*| had similar correlation to rutting, analysis of test data indicated that the SST shear testing gave lower stiffness values and higher phase-angle values than the compressive dynamic modulus testing, even when Poisson’s ratio effects were considered. This was especially true at high temperatures. Because of these and other reasons, the dynamic modulus |E*| was recommended as the SPT parameter for rutting as well as for fatigue cracking. None of the studied parameters turned out to be adequate performance indicators for thermal cracking.

Get full access to this article

View all access options for this article.

References

Andrei

, Witczak

, and Mirza

M. W.

. Development of Revised Predictive Model for the Dynamic (Complex) Modulus of Asphalt Mixtures: Development of the 2002 Guide for the Design of New and Rehabilitated Pavement Structures. NCHRP 1-37A, Interim Team Technical Report. Department of Civil Engineering, University of Maryland, College Park, 1999.

Bonnaure

, Guest

, Gravois

, and Uge

. A New Method of Predicting the Stiffness of Asphalt Paving Mixtures. Journal of the Association of Asphalt Paving Technologists, Vol. 46, 1977, pp. 64–104.

Bahia

H. U.

, and Anderson

D. A.

. SHRP Binder Rheological Parameters: Why Are They Required and How Do They Compare with Conventional Properties? Presented at 74th Annual Meeting of the Transportation Research Board, Washington, D.C., 1995.

Krautkrämer

, and Krautkrämer

. Ultrasonic Testing of Materials. Part A, 4th fully revised ed. Springer Verlag, Berlin, 1990, pp. 1–153.

Pellinen

, and Witczak

M. W.

Assessing the Ultrasonic Pulse Velocity Technique for Measuring the Elastic Modulus of Asphalt Concrete, Superpave Support and Performance Models Management. NCHRP 9-19, Technical Team Report. Department of Civil Engineering, University of Maryland, College Park, 1999.

Saarela

Asfalttipäällysteiden Tutkimusohjelma. ASTO 1987–1992 [Asphalt Pavements Research Program. ASTO 1987-1992]. Loppura-portti, Technical Research Centre of Finland, Road, Traffic and Geotechnical Laboratory, Espoo, 1993.

Doubbaneh

Comportement Mechanique des Enrobes Bitumineux des ‘Petites’ aux ‘Grandes’ Deformations. Grade de Docteur, l’Institute National des Sciences Appliquees De Lyon, Laboratoire Géomatériaux du Département de Génie Civil, Lyon, France, 1995.

Pellinen

Investigation of the Use of Dynamic Modulus As an Indicator of Hot-Mix Asphalt Performance. Ph.D. dissertation. Arizona State University, Tempe, 2001.

Witczak

M. W.

, and Pellinen

T. E.

. E^*-Dynamic Complex Modulus and E_d-Dynamic Pulse Wave Velocity Tests. Superpave Support and Performance Models Management. NCHRP-9-19, Task-C Simple Performance Test, MnRoad Experiment, ALF Experiment, and WesTrack Experiment, Team Reports SPT-MN-2(J-K), SPT-ALF-2(J-K), and SPT-WST-2(J-K). Department of Civil and Environmental Engineering, Arizona State University, Tempe, 1999.

10.

Witczak

M. W.

, and Bonaquist

R. F.

. G^*-Simple Shear Tests (SST), Superpave Support and Performance Models Management. NCHRP-9-19, Task-C Simple Performance Test, MnRoad Experiment, ALF Experiment, and WesTrack Experiment, Team Reports SPT-MN-2(F), SPT-ALF-2(F), and SPT-WST-2(F). Department of Civil and Environmental Engineering, Arizona State University, Tempe, 1999.

11.

Huang

Pavement Analysis and Design. Prentice Hall, Englewood Cliffs, N.J., 1993.

12.

Witczak

M. W.

, et al. Development of the 2002 Design Guide for New and Rehabilitated Flexible Pavements. NCHRP 1-37A, Interteam Technical Report. Arizona State University, Tempe, 2002.