Simple Approach to Estimation of Pavement Structural Capacity

Abstract

The use of the falling weight deflectometer (FWD) as a tool for investigating the structural strength of flexible and rigid pavements is now common. The backcalculation of layer moduli is the primary technique for data interpretation. This technique is cumbersome and expensive to apply to low-volume roads. A simple way of relating the FWD surface deflections to the performance of pavement structures, expressed by the structural number (SN), is presented. The technique is proposed as an alternative to existing methods in Louisiana using Dynaflect data. The relationship was deduced by statistical analysis, using the data collected at the Louisiana Transportation Research Center Pavement Research Facility. The study found that the correlation between the SN and the FWD deflections is satisfactory. Two different relationships are recommended for flexible and semirigid pavements. Both relationships can be applied in a pavement management environment because they allow evaluation of the required thickness for the asphalt overlay. It was found that the structural layer coefficients must be assigned functions of the laboratory moduli determined by the indirect tensile test, not functions of the backcalculated moduli.

Get full access to this article

View all access options for this article.

References

AASHTO Guide for Design of Pavement Structures. American Association of State Highway and Transportation Officials, Washington, D.C., 1993, Chapter II.

Til

, McCullough

B. F.

, Vallerga

B. A.

, and Hicks

R. G.

. NCHRP Report 128: Evaluation of AASHTO Interim Guides for Design of Pavement Structures. TRB, National Research Council, Washington, D.C., 1972.

Witczak

, and Yoder

E. J.

. Principles of Pavement Design, 2nd ed. John Wiley and Sons, New York, 1975.

Paterson

W. O.

Road Deterioration and Maintenance Effects: Models for Planning and Management—HDM III. The World Bank, Washington, D.C., 1987, pp. 135–147.

Temple

W. H.

, and Carpenter

W. C.

. Implementation of the New AASHTO Pavement Design Procedure in Louisiana. Final Report. LTRC, Baton Rouge, Louisiana, 1990.

Bohn

, Ullitz

, Stubstad

, and Sorensen

. Danish Experiments with the French Falling Weight Deflectometer. Proc., 3rd International Conference on the Structural Design of Asphalt Pavements, Vol. 1, University of Michigan, Ann Arbor, 1972.

Tholen

Falling Weight Deflectometer KUAB 50. Proc., International Symposium on Bearing Capacity of Roads and Airfields, The Norwegian Institute of Technology, Trondheim, Norway, 1982, pp. 446–150.

Haas

, Hudson

W. H.

, and Zaniewski

. Modern Pavement Management. Krieger Publishing Company, Malabar, Fla., 1994.

Crovetti

J. A.

, Shahin

M. Y.

, and Touma

B. E.

. Comparison of Two Falling Weight Deflectometer Devices, Dynatest 8000 and KUAB 2m-FWD. Nondestructive Testing of Pavements and Backcalculation of Moduli, ASTM STP 1026, Vol. 1, American Society for Testing and Materials, Philadelphia, Pa., 1989.

10.

Shahin

M. Y.

Pavement Management for Airports, Roads and Parking Lots. Chapman and Hall, New York, 1994.

11.

Ullitz

Pavement Analysis. Elsevier, New York, 1987.

12.

Kim

Y. R.

, Hibbs

B. O.

, and Lee

Y.-C.

. Temperature Correction of Deflections and Backcalculated Asphalt Concrete Moduli. In Transportation Research Record 1473, TRB, National Research Council, Washington D.C., 1995, pp. 55–62.

13.

SHRP Procedure for Temperature Correction of Maximum Deflections. Protocol P-654. Strategic Highway Research Program, National Research Council, Washington, D.C., 1993.

14.

Johnson

A. M.

, and Baus

R. L.

. Alternative Method for Temperature Correction of Backcalculated Equivalent Pavement Moduli. In Transportation Research Record 1335, TRB, National Research Council, Washington, D.C., 1992.

15.

Jameson

G. W.

Development of Procedures to Predict Structural Number and Subgrade Strength from Falling Weight Deflectometer Deflections, 1993.

16.

Jameson

G. W.

Development of Philippines Asphalt Overlay Procedures—Pavement Management System. Technical Assistance Project TA 1426-PHI. Asian Development Bank, 1992.

17.

Rohde

G. T.

Determining Pavement Structural Number from FWD Testing. In Transportation Research Record 1448, TRB, National Research Council, Washington, D.C., 1994, pp. 61–68.

18.

King

, Gillespie

, and Crosby

. Construction and Comparison of Louisiana’s Conventional and Alternative Base Courses Under Accelerated Loading. LTRC Report 93-IALF, Interim Draft. Louisiana Transportation Research Center, Baton Rouge, 1996.

19.

Manual for FWD Testing in the Long-Term Pavement Performance Program. Protocol P-661. Strategic Highway Research Program, National Research Council, Washington, D.C., 1993.

20.

Scullion

, and Michalak

. MODULUS 4.0, User’s Manual. Report FHWA/TX-88/1123-4. Texas Transportation Institute, Texas A&M University, College Station, 1991.

21.

Roberts

F. L.

, and Wedgeworth

J. B.

. Analysis and Evaluation of Methods for Backcalculations of M_R Values. Report 263, Vol. 1., LTRC, Baton Rouge, La., 1992.

22.

Newcomb

D. E.

Comparison of Field and Laboratory Estimated Resilient Moduli of Pavement Materials. Proc., Association of Asphalt Paving Technologists, Vol. 56, 1987, pp. 91–110.

23.

Lytton, Germann, and Chou. PASELS—Determination of Asphaltic Concrete Pavement Properties by Nondestructive Testing. Appendix H. Texas Transportation Institute, College Station, Tex., 1990.

24.

SHRP’s Layer Moduli Backcalculation Procedure. Protocol P-655. Strategic Highway Research Program, National Research Council, Washington D. C., 1993.

25.

Rada

G. R.

, Witczak

M. W.

, and Rabinow

S. D.

. Comparison of AASHTO Structural Evaluation Techniques Using Nondestructive Deflection Testing. In Transportation Research Record 1207, TRB, National Research Council, Washington, D.C., 1988, pp. 134-144.