Tests on twenty-one concrete filled steel tubes to investigate the influence of compaction methods on the strength of concrete filled steel tubular members are reported. Two parameters were investigated, including slenderness ratio and load eccentricity. It was found that better compaction of concrete resulted in higher values of the ultimate strength of concrete filled steel tubular members. The tests show the importance of good concrete compaction for concrete filled steel tubes.
ASCCS Seminar (1997), “Concrete Filled Steel Tubes — A Comparison of International Codes and Practices”, Innsbruck, September.
2.
VirdiK.S. and DowlingP.J., “Bond Strength in Concrete Filled Steel Tubes”, IABSE Proceeding P-33/80, pp. 125–139.
3.
MorishitaY.TomiiM. and YoshimuraK. (1979), “Experimental Studies on Bond Strength in Concrete Filled Circular Steel Tubular Columns Subjected to Axial Loads”, Transactions of Japan Concrete Institute, 351–358.
4.
MorishitaY.TomiiM. and YoshimuraK. (1979), “Experimental Studies on Bond Strength in Concrete Filled Square and Octagonal Steel Tubular Columns Subjected to Axial Loads”, Transactions of Japan Concrete Institute, 359–366.
5.
MorishitaY. and TomiiM. (1982), “Experimental Studies on Bond Strength between Square Steel Tube and Encased Concrete Core under Cyclic Shearing Force and Constant Axial Force”, Transactions of Japan Concrete Institute, 4, 363–370.
6.
TomiiM.YoshimuraK. and MorishitaY. (1980), “A Method of Improving Bond Strength in between Steel Tube and Concrete Core Cast in Circular Steel Tubular Columns”, Transactions of Japan Concrete Institute, 2, 319–326.
7.
TomiiM.YoshimuraK. and MorishitaY. (1980), “A Method of Improving Bond Strength in between Steel Tube and Concrete Core Cast in Square and Octagonal Steel Tubular Columns”, Transactions of Japan Concrete Institute, 2, 327–334.
8.
KhalilH.S.KarimN. and HassanA. (1994), “Push-Out Resistance of Concrete Filled Tubes”, in Proc. of the International Conference on Steel-Concrete Composite Structures, Slovakia, pp. 360–360.
9.
DL/T5085–1999 (1999), Design code for steel-concrete composite structures, Beijing, Chinese Electricity Press.
