Scale Model Investigation on the Influence of Boundary Conditions on the Airborne Sound Insulation of Lightweight Double Walls

Abstract

Sound reduction index measurements were performed inside a 1:10 scale model of two adjoining rooms of a test facility in an acoustic laboratory, with the aim of investigating the influence of the boundary conditions on the acoustic performance of lightweight double walls. The model was built entirely of polymethyl methacrylate (PMMA). The specimen double walls were built using the same acrylic material. At first, measurements were performed on a single homogeneous panel, in order to check the reliability of the whole procedure and the repeatability of the measurements. A good correspondence was found between theoretically calculated values and measured values of the sound reduction index above the critical frequency. A second set of measurements was carried out on model double walls comprising two leaves, connected to each other only by a border frame running along the whole wall perimeter. It was found that the effect of the border frame is a reduction of the performance of the double wall, to under that of a single plate with the same total surface mass. A third set of measurements was carried out inserting vertical studs to connect the two leaves. It was found that the presence of the studs causes a general decrease of the sound reduction index values and a decomposition of the critical frequency. A fourth set of measurements was carried out on the same double wall using border frames made of different materials. The experimental results show that damped materials (wood, rubber) give a better performance than rigid materials (acrylic, aluminium).

Get full access to this article

View all access options for this article.

References

Fausti

Pompoli

, and Smith

, An intercomparison of laboratory measurements of airborne sound insulation of lightweight plasterboard walls, J. Building Acoust. , 6(2), 127–140 (1999).

Price

A.J.

, and Crocker

M.J.

, Sound transmission through double panels using statistical energy analysis, J. Acoust. Soc. Am. , 47, 683–693 (1970).

Elmallawany

, Criticism of statistical energy analysis for the calculation of sound insulation – Part 2: Double partitions, Appl. Acoust. , 13, 33–41 (1980).

Brekke

, Calculation methods for the transmission loss of single, double and triple partitions, Appl. Acoust. , 14, 225–240 (1981).

Craik

R.J.M.

, Sound transmission through buildings using statistical energy analysis , Gower, London (1996).

Craik

R.J.M.

, and Smith

R.S.

, Sound transmission through double leaf lightweight partitions – Part I: Airborne sound, Appl. Acoust. , 61, 223–245 (2000).

Craik

R.J.M.

, and Smith

R.S.

, Sound transmission through lightweight parallel plates – Part II: Structure-borne sound, Appl. Acoust. , 61, 247–269 (2000).

ISO 140-1, Acoustics – Measurements of sound insulation in buildings and of buildings elements. Part 1: Requirements of laboratory test facilities with suppressed flanking transmission.

Rife

D.D.

, MLSSA Reference manual vr.10.0A , DRA Laboratories, Sterling, VA (1996).

10.

Cremer

, and Muller

H.A.

, Principles and applications of room acoustics , Applied Science Publishers, London (1982).

11.

ISO 140-3, Acoustics – Measurements of sound insulation in buildings and of buildings elements. Part 3: Laboratory measurements of airborne sound insulation of building elements.

12.

Oldham

D.J.

, and Shen

, A scale model investigation of sound radiation from building elements, J. Sound Vib. , 91(3), 331–350 (1983).

13.

ISO 9613-1, Acoustics – Attenuation of sound during propagation outdoors. Part 1: Calculation of the absorption of sound by the atmosphere.

14.

Pr EN 12354-1, Building Acoustics – Estimation of acoustic performance of buildings from the performance of products. Part 1: Airborne sound insulation between rooms.

15.

Norton

M. P.

, Fundamentals of noise and vibration analysis for engineers , Cambridge University Press, Cambridge (1989).

16.

ISO 717-1, Acoustics – Rating of sound insulation in buildings and of buildings elements. Part 1: Airborne sound insulation in buildings and of interior buildings elements.