Attenuating Railway Track Vibration by Rail Absorber for Noise Reduction

Abstract

A promising means to increase the decay rate of vibration along the rail is using a rail absorber for noise reduction. Compound track models with the tuned rail absorber are used for investigation of the performance of the absorber on vibration reduction. Through analysis of the track dynamics with the rail absorber some guidelines are given on selection of the types and parameters for the rail absorber. It is found that a large active mass used in the absorber is beneficial to increase the decay rate of rail vibration. The effectiveness of the piecewise continuous absorber is moderate compared with the discrete absorber installed in the middle of sleeper span or at a sleeper. The most effective installation position for the discrete absorber is in the middle of sleeper span. Over high or over low loss factor of the damping material used in the absorber may degrade the vibration reduction performance.

Keywords

rail damper tuned absorber rolling noise railway track

Get full access to this article

View all access options for this article.

References

Remington

P.J.

, Wheel/rail rolling noise I: Theoretical analysis, Journal of the Acoustical Society of America 81 (1987) 1805–1823.

Remington

P.J.

, Wheel/rail rolling noise, II: Validation of the theory. Journal of the Acoustical Society of America 81 (1987) 1824–1832.

Thompson

D.J.

, Wheel–rail noise generation, part I: Introduction and interaction model, Journal of Sound and Vibration 161 (1993) 387–400.

Thompson

D.J.

Hemsworth

Vincent

, Experimental validation of the TWINS prediction program for rolling noise, part 1: Description of the model and method. Journal of Sound and Vibration, Journal of Sound and Vibration 193 (1996) 123–135.

Thompson

D.J.

Fodiman

Mahé

, Experimental validation of the TWINS prediction program for rolling noise, part 2: Results, Journal of Sound and Vibration 193 (1996) 137–147.

Jones

C.J.C.

Thompson

D.J.

Diehl

R.J.

, The use of decay rates to analyse the performance of railway track in rolling noise generation, Journal of Sound and Vibration 293 (2006) 485–495.

Thompson

D.J.

Gautier

P-E

, Review of research into wheel/rail rolling noise reduction, Proc. IMechE Part F: J. Rail and Rapid Transit 220 (2006) 385–408.

Thompson

D.J.

Jones

C.J.C.

T.X.

de France

, The influence of the non-linear stiffness behaviour of rail pads on the track component of rolling noise, Proc. IMechE Part F: J. Rail and Rapid Transit 213 (1999) 233–241.

Vincent

Bouvet

Thompson

D.J.

Gautier

P.E.

, Theoretical optimization of track components to reduce rolling noise, Journal of Sound and Vibration 193 (1996) 161–171.

10.

Thompson

D.J.

Jones

C.J.C.

Waters

T.P.

Farrington

, A tuned damping device for reducing noise from railway track, Applied Acoustics 68 (2007) 43–57.

11.

T. X.

, On the railway track dynamics with rail vibration absorber for noise reduction, Journal of Sound and Vibration 309(3–5), 2008, 739–755.

12.

Thompson

D.J.

Janssens

M.H.A.

, TWINS: Track-wheel interaction noise software, theoretical manual (version 2.4), TNO Institute of Applied Physics Report TPD-HAG-RPT-93-0214, Delft, 1997.