The Stringer System — A Truss Model of Membrane Shells for Analysis and Design of Boundary Conditions

Abstract

This paper deals with the problem: What sort of boundary conditions are to be prescribed on the edge of a shell that is to be in a statically determinate membrane state? Triangulated single layer trusses have been suggested as a model for membrane shells by (Calladine 1983) and have been investigated by (Szabo and Tarnai 1992). However, these efforts have not solved the problem completely.

The paper presents a triangular single layer truss system – the stringer system – which differs from the above mentioned models in two ways:

the systematic topology makes it relatively simple to control whether or not the system is statically and geometrically/kinematically determinate,

the geometry corresponds to the curvature of the considered surface and ensures that the system can be applied as a valid static and geometric model for the membrane shell.

In most cases, the stringer system regarded as a static model of membrane shells leads to the same results as the theory of partial differential equations, as investigated by (Tarnai 1980a, 1981, 1983). However, some new boundary conditions for shells with positive and zero Gaussian curvature have been found and the types of supports and the connection between statical and geometrical determinacy have been further generalised.

The paper is based on parts of the Ph.D. Thesis by (Almegaard 2003).

Get full access to this article

View all access options for this article.

References

Almegaard

(2003). Skalkonstruktioner — metoder til afklaring of sammenhængene mellem form, stabilitet, stivhed og understøtningsforhold. Ph.D. thesis, Royal Academy of Fine Arts, School of Architecture, Copenhagen, 2002. By og Byg. (In Danish).

Calladine

C. R.

(1978). Buckminster Fuller's ‘Tensegrity’ structures and Clerk Maxwell's rules for the construction of stiff frames. International Journal of Solids and Structures, 14(2), 161–172.

Calladine

C. R.

(1983). Theory of shell structures. Cambridge: Cambridge University Press.

Cauchy

A. L.

(1813). Sur les polygones et le polyédres. J. de I'École Polytechnique, XVIe Cahier IX, 87–89.

Feilberg Hansen

(1988). Regulære skivekonstruktioner (Rapport 189). Lyngby: Danmarks Tekniske Højskole, Instituttet for Husbygning. (In Danish).

Maxwell

J. C.

(1864): On the calculation of the equilibrium and stiffness of frames. Philosophical Magazine, Vol.27, 294 (paper XXVI in Collected Papers, Cambridge 1890).

Szabœ

Tarnai

(1992) Rigidity of the Truss Model of Membrane Shells, Proceedings. IASS-CSCE International Congress 1992. Toronto, Vol. 2, 438–449.

Tarnai

(1980a). Existence and uniqueness criteria of the membrane state of shells. I. Hyperbolic shells. Acta Technica Academiae Scientiarum Hungaricae, 91(1–2), 81–110.

Tarnai

(1980b). Simultaneous static and kinematic indeterminacy of space trusses with cyclic symmetry. International Journal of Solids and Structures 16(4), 347–359.

10.

Tarnai

(1981). Existence and uniqueness of criteria of the membrane state of shells. II. Parabolic shells. Acta Technica Academiae Scientiarum Hungaricae 92(1–2), 67–88.

11.

Tarnai

(1983). Existence and uniqueness of criteria of the membrane state of shells. III. Elliptic shells. Acta Technica Academiae Scientiarum Hungaricae 96(1–4), 59–85.

12.

Tarnai

(1993). Criteria of the states of membrane stress and membrane deformation of shells. Proceeding, IASS-Symposium 1993. Istanbul, Turkiye. Mimar Sinan University, 315–322.