A base-isolation system was developed for earthquake protection of low-rise structures. The system incorporates spherical supports for the base, a specially designed spring-cam system to keep the base supported under normal conditions, and moves for the duration of the earthquake under the constraint of a spring with optimized stiffness characteristics. The dynamic behaviour of a three-story concrete structure with and without the base isolation subjected to the Taft and El Centro earthquake loads was investigated. The results indicated that the absolute peak acceleration and displacement as well as shear forces decreased significantly with the application of a base isolation system, and it is possible to achieve 87 to 94% reduction in the maximum accelerations and transmitted forces. The movement of the base relative to the ground was less than 0.15 m in the optimized system, and the springs were not fully compressed at any time during application of the earthquake loads. The maximum induced vertical forces as a result of the spherical base support were found to be less than 1.5 % of the weight of the structure. Since the system performance is highly dependent on the rapid unlocking of the cams in the event of a seismic disturbance, careful consideration should be given to the optimal design of the spring-cam system.
AlmazanJ. L.De la LleraJ. C., and InaudiJ.C., 1998. “Modeling Aspects of Structures Isolated With the Frictional Pendulum System”, Earthquake Engineering and Structural Dynamics, Vol. 27, No. 8, pp. 845–867.
2.
FujitaS.FuruyaO., and FujitaT., 1994. “Dynamic Tests on High Damping Rubber Damper for Vibration Control of Tall Buildings”, FA2–3; First World Conference on Structural Control, Los Angeles, California, USA.
3.
JahilalP. and UtkuS., 1998. “Active Control In Passively Base Isolated Buildings Subjected to Lower Power Excitations”, Computers and Structures, Vol. 66, No. 2-3, pp. 211–224.
4.
JamgidR.S. and KellyI.M., 2001. “Base Isolation for Near-Fault Motions”, Earthquake Engineering and Structural DynamicsVol. 30, No. 5, pp. 691–707.
5.
KaplanH. and SeiregA., 2000. “A Computer Controlled System for Earthquake Protection of Structures”, International Journal of Computer Applications in Technology, Vol.13,No.1–2, pp. 25–41.
6.
KaplanH. and SeiregA., 2001. “Optimal Design of a Base Isolated System for a High-Rise Steel Structure”, Earthquake Engineering and Structural Dynamics, Vol. 30, No. 2, pp. 287–302.
7.
KaplanH., 2002. “A Computer Controlled System for Earthquake Protection of Structures”, Ph.D. Dissertation, University of Wisconsin-Madison, Madison, Wisconsin, USA, 519 p.
8.
KaplamH. and SeiregA., 2002. “A Base Isolation system for Bridges Subjected to Seismic Disturbances”, Earthquake Engineering and Structural Dynamics, Vol. 31, No. 5, pp. 1093–1112.
9.
KareemA., 1994. “The Next Generation of Tuned Liquid Dampers”, First World Conference on Structural Control, Los Angeles, California, USA.
10.
KoikeY. and MurataT., 1994. ‘Development of V-Shaped Hybrid Mass Damper and its Applications to High-Rise Buildings’First World Conference on Structural Control, Los Angeles, California, USA.
11.
KurodaT. and SarutaM., 1989. “Verification Studies on Base Isolation Systems by Full Scale Buildings”, In Seismic, Shock and Vibration Isolation, ChungH. and FujitaT. (eds), Vol. 181, ASME, New York pp. 1–8
12.
LinT.W., and HoneC.C., 1993. “Base Isolation by Free Rolling Rods Under Basement”, Earthquake Engineering and Structural DynamicsVol. 22, No. 3, pp. 261–274.
13.
LinT.W.ChernC.C., and HoneC.C., 1995. “Experimental Study of Base Isolation by Free Rolling Rods”, Earthquake Engineering and Structural DynamicsVol. 24, No. 12, pp. 1645–1650.
14.
Matlab Version 5 User's Guide, 2001. Prentice Hall, Englewood Cliffs, New Jersey.
15.
MaranoG.C. and GrecoR., 2003. “Efficiency of Base Isolation Systems in Structural Seismic Protection and Energetic Assessment”, Earthquake Engineering and Structural DynamicsVol. 32, No. 10, pp. 1505–1531.
16.
MatheuE. E.SinghM.P., and BeatheC., 1998. “Output-Feedback Sliding-Mode Control with Generalized Sliding Surface for Civil Structures under Earthquake Excitation”, Earthquake Engineering and Structural Dynamics, Vol. 27, No. 3, pp. 259–282.
17.
MayesR.L.JonesR.BukleG., and EeriM., 1990. “Impediments to the Implementation of Seismic Isolation”, Earthquake Spectra, Earthquake Engineering Research Institute, Vol. 6, No.2, pp. 245–263.
18.
MostaghelN. and DavisT., 1997. “Representations of Coulomb Friction for Dynamic Analysis”, Earthquake Engineering and Structural Dynamics, Vol. 26, No. 5, pp. 541–548.
19.
SamaliB.WuY.M., and LiJ., 2003. “Shake Table Tests on Mass Eccentric Model with Base Isolation”, Earthquake Engineering and Structural DynamicsVol. 32, No. 9, pp. 1353–1372.
20.
SeiregA., 1998. “Friction and Lubrication m Mechanical Design”, Mercel Dekker, New York, NY.
21.
ShingP. B.DixonM. E.KermicheN.SuR., and FrangopolM., 1996. “Control of Building Vibrations with Active/Passive Devices”, Earthquake Engineering and Structural Dynamics, Vol. 25, No. 10, pp. 1019–1039.
22.
SymansM.D., 2002. “Base Isolation and Supplemental Damping Systems for Seismic Protection of Wood Structures: Literature Review”, Earthquake Spectra, Earthquake Engineering Research Institute, Vol. 18, No. 3, pp. 549.
23.
TzanS. R. and PandelidesC.P., 1994. “Hybrid Structural Control Using Viscoelastic Dampers and Active Control Systems”, Earthquake Engineering and Structural/DynamicsVol. 23, No. 12, pp. 1369–1388.
24.
WangY. P. and LiuC. J., 1994. “Active Control of Sliding Structures under Strong Earthquakes”, FP1–23; First World Conference on Structural Control, Los Angeles, California USA.
25.
WangY. P. and ReinhjornA. M., 1989. “Motion Control of Sliding Isolated Structure”, In Seismic, Shock and Vibration Isolation, ChungH. and FujitaT. (eds), Vol. 181, ASME, New York.
26.
YangY.B. and HuangW. H., 1998. “Equipment-Structure Interaction Considering the Effect of Torsion and Base Isolation”, Earthquake Engineering and Structural DynamicsVol. 27, No. 2, pp. 155–171.
27.
YoussefN.NuttallBRahmanA., and HataO., 1994. “Passive Control of the Los Angeles City Hall”, FP2–54; First World Conference on Structural Control, Los Angeles, California, USA.
28.
ZhaoB.LuX.WuM., and MeiZ., 2000. “Sliding Mode Control of Buildings with Base-Isolation Hybrid Protective System”, Earthquake Engineering and Structural DynamicsVol. 29, No. 3, pp. 315–326.
29.
ZhouQ. and LuX., 1998. “Dynamic Analysis on Structures Base Isolated by A Ball System with Restoring Property”, Earthquake Engineering and Structural Dynamics, Vol. 27, No. 8, pp. 773–791.
