Two conditions for minimal wear of the front wheel tyres are defined. Methods to comply with these conditions through the design parameters of the steering axle are stated. An optimization of the steering axle parameters of a concrete agricultural tractor was performed using the formulated conditions. An experimental corroboration was finally carried out.
KnorozV. I.Work of the automobile tire (in Russian), 1975 (Avtotransizdad, Moscow).
2.
TroizkiiV. P.Reduction of the wear and tear of the front axle tires of an automobile by rational correlation between the deviation angles of the wheels in urban conditions (in Russian). PhD thesis, Moscow, 1983.
3.
GoughV. E.Practical tyre research. SAE Trans., 1956, 64, 313–318.
4.
HasselgruberH.Verhalteneines Kraftfahrzeugens bei Kurvenfahrt. Automobiltechnische Z., 1965, 7.
ChudakovE. A.Selected works, Vol. 1, Theory of the automobile (in Russian), 1961 (Academy of Science of USSR, Moscow).
7.
BalabinI. V.About the influence of the wheel camber on the tire wear in cornering conditions (in Russian). Avto. Prom. Moscow, 1979, 9.
8.
KragelskiiI. V., et al. Fatigue mechanism and short method for an analytical assessment of the surface wear caused by friction during the slip (in Russian), 1967 (Academy of Science of USSR, Moscow).
9.
LiubenovS., et al. Steering front axle of a wheeled tractor with variable assembly wheel angles and king-pin angles (in Bulgarian). Author's certificate N 35791/1982.
