GuptaP. K.ColemanR. L.PanC. H. T.Ambient edge correction for the locally incompressible narrow-groove theory. Trans. ASME, J. Lubric. Technol., April 1974, 284.
2.
ElrodH. G.Some refinements of the theory of the viscous screw pump. Trans. ASME, J. Lubric. Technol., July 1967, 291.
3.
MurataS.MiyakeY.KawabataN.Exact two-dimensional theory of spherical spiral groove bearings. Trans. ASME, J. Lubric. Technol., October 1980, 430.
4.
MohrG. A.BroomN. D.A finite element lubrication model. Fourth International Conference on Finite element methods, Melbourne, August 1982.
5.
BookerJ. F.HeubnerK. H.Application of FEM to lubrication. Trans. ASME, J. Lubric. Technol., 1972, 313.
6.
TayalS. P. et al. FEA of elliptical bearings lubricated by a non-Newtonian fluid. Wear, 1982, 80, 71.
7.
BootsmaJ.The effect of viscosity variation with temperature on the performance of spiral groove bearings. Trans. ASME, 1969, 12, 287.
8.
DewarD. M.The development of a design procedure for grease and oil lubricated spiral groove bearings. PhD thesis, Mechanical Engineering Department, Southampton University, April 1972.
9.
MolyneauxA. K.The design of lubricant recirculating hydrodynamic spiral groove bearings using grease lubricants. PhD thesis, Mechanical Engineering Department, Southampton University, July 1983.
10.
DewarD. M.An analysis of grease and oil lubricated spiral groove bearings. ASLE-ASME Joint Lubrication Conference, ASME paper 73-Lub-20, Atlanta, Ga., October 1973.
11.
HamrockB. J.FlemingD. P.Optimisation of self acting herringbone grooved journal bearings for maximum radial load capacity. Fifth International Gas Bearing Symposium, Southampton University, March 1971.
12.
FlemingD. P.HamrockB. J.Optimisation of self acting herringbone grooved journal bearings for maximum stability. Sixth International Gas Bearing Symposium, Southampton University, March 1974.
13.
DewarD. M.The development of a design procedure for grease and oil lubricated spiral groove bearings. Science Research Council (SRC) report, April 1972.
