A modal control scheme for rotating disc systems is developed based upon the finite-dimensional sub-system model including a few lower backward travelling waves important to the disc response. For the single discrete sensor and actuator system, a polynomial equation, which determines the closed-loop system poles, is derived and the spillover effect is analysed, providing a sufficient condition for stability. Finally, simulation studies are performed to show the effectiveness of the travelling wave control scheme proposed.
Get full access to this article
View all access options for this article.
References
1.
EllisR. W.MoteC. D.A feedback vibration controller for circular saws. Trans. ASME, J. Dynamic Systems, Measmt and Control, 1979, 101, 44–49.
2.
RadcliffeC. J.MoteC. D.Identification and control of rotating disk vibration. Trans. ASME, J. Dynamic Systems, Measmt and Control, 1983, 105, 39–45.
3.
MoteC. D.JrRahimiA.Real time vibration control of rotating circular plates by temperature control and system identification. Trans. ASME, J. Dynamic Systems, Measmt and Control, 1984, 106, 123–128.
4.
IwanW. D.StahlK. J.The response of an elastic disk with a moving mass system. Trans. ASME, J. Appl. Mech., 1973, 40, 445–451.
5.
IwanW. D.MoellerT. L.The stability of a spinning elastic disk with a transverse load system. Trans. ASME, J. Appl. Mech., 1976, 45, 485–490.
6.
ChoH. S.ChoY. J.Suboptimal controller design for active control of circular saw vibrations. Optimal Control Applic. Meth., 1981, 2, 299–310.
7.
BalasM. J.Feedback control of the flexible system. IEEE Trans. Autom. Control, 1978, 1, AC-23(5), 673–679.
8.
BalasM. J.Modal control of the flexible dynamic systems. SIAM J. Control Optimization, 1978, 16(3), 450–462.
9.
GibsonJ. S.A note on stabilization of infinite dimensional linear oscillators by compact linear feedback. SIAM J. Control Optimization, 1980, 18,(3), 311–316.
10.
MoteC. D.Stability of circular plates subjected to moving loads. J. Franklin Inst., 1970, 290(4), 329–344.
11.
MoteC. D.JrHolyenS.Confirmation of the critical speed theory for symmetrical circular saws. Trans. ASME, J. Engng Industry, 1975, 97(3), 1112–1118.
12.
CurtainR. F.Pole assignment for distributed systems by finite dimensional control. Automatica, 1985, 21(1), 57–67.
13.
CurtainR. F.PritchardA. J.Infinite dimensional linear system theoryLecture notes in control and identification sciences, Vol. 8, 1978. (Springer-Verlag).
14.
CurtainR. F.PritchardA. J.Functional analysis in modern applied mathematics, 1977 (Academic Press).
15.
KatoT.Perturbation theory of linear operators, 1966 (Springer-Verlag, New York).
16.
CarrierG. F.KrookM.PearsonC. E.Functions of a complex variable, 1966, pp. 60–61 (McGraw-Hill, New York).
17.
KwakernaakH.SivanR.Linear optimal control systems, 1972 (John Wiley, New York).
18.
ByunS. W.LeeC. W.Pole assignment in rotating disk vibration control using complex modal state feedback. To be published in J. Mech. Systems and Signal Processing, 1988.
