University Research in Engineering and Its Application with Particular Reference to Thermo-Fluid-Dynamics

Postgraduate training in the United Kingdom—6, Engineering and Technology 1969 (Royal Society, London).

‘Interim report of the working group on manpower parameters for scientific growth’, Cmnd. 3102 1966 (H.M.S.O.).

‘The flow into employment of scientists, engineers and technologists’, Cmnd. 3760 1968 (H.M.S.O.).

Horlock J. H. ‘The manufacture of glass cloth/resin blades for an axial flow compressor’, Jl R. aeronaut. Soc. 1954 58 (434).

Kruger R. A. Horlock J. H. Marsh H. ‘The performance of a cascade fitted with blown flaps’, Aero. Res. Council. C.P. No. 526 1959.

Clark E. L. Ordway D. G. ‘An experimental study of jet-flap compressor blades’, J. AeroSpace Sci. 1959 26, 11.

Horlock J. H. ‘A note on the suppression of rotating stall’, Aero. Res. Coun. Rept No. 17, 810 1956.

Pearson H. Unpublished report.

Squire H. B. Winter K. G. ‘The secondary flow in a cascade of aerofoils in a non-uniform stream’, J. aeronaut. Sci. 1951 (April).

Hawthorne W. R. ‘Secondary circulation in fluid flow’, Proc. R. Soc. A 1951 206.

Preston J. H. ‘The determination of turbulent skin friction by means of pitot tabes’, Jl R. aeronaut. Soc. 1954 58 (518), 109.

Gearhart W. S. Henderson R. E. Mcmahon J. F. Horlock J. H. ‘Quasi-steady design of a compressor or pump stage for minimum fluctuating lift’, Paper 68-WA/FE-12, J. Engng Pwr 1970.

Horlock J. H. ‘Fluctuating lift forces on aerofoils moving through transverse and chordwise gusts’, J. Basic Engng, Trans. Am. Soc. mech. Engrs 1968 4 (Series D), 494.

Keenan J. H. Keyes F. G. Thermodynamic properties of steam 1936 (Wiley, New York, and Chapman & Hall, London).

Haywood R. W. (Ed.). Thermodynamic tables and other data 1955 (Cambridge University Press).

Callendar H. L. Properties of steam 1920 (Arnold, London).

Horlock J. H. ‘Some approximate equations for the properties of steam at moderately high pressures’, Proc. Vth Int. Cong. Properties of Steam, 1956 (July); see also Proc. Instn mech. Engrs 1959 173 (No. 33), 773.

Hoadley D. Ph.D. thesis, Cambridge University, 1970.

Stratford B. ‘The use of boundary layer techniques to calculate the blockage from the annulus boundary layers in a compressor’, A.S.M.E. Paper 67-WA/GT-7, 1967.

Horlock J. H. ‘Boundary layer problems in axial flow turbomachines’, in Flow research on blading 1970 (Elsevier Press).

Gregory-Smith D. G. Marsh H. ‘Annulus wall boundary layers in turbomachines’, Cambridge University Engineering Department Report UCT/3, 1967.

Thomson A. S. T. Scott A. H. Mcbroom H. L. ‘Hydraulic jacking of journal bearings’, The Engineer 1966, 462.

Eliasson E. T. ‘Hydraulic jacking of journal bearings’, Ph.D. thesis, Glasgow University, 1967.

Horlock J. H. ‘An analysis of the hydraulic jacking of journal bearings’, 1970 (to be published).

Horlock J. H. ‘The flow in manifolds with open and closed ends’, Jl R. aeronaut. Soc. 1956 60, 749.

Silver R. S. ‘An approach to a general theory of surface condensers’, Proc. Instn mech. Engrs 1963–64 178 (Pt 1), 339.

Horlock J. H. ‘A rapid method for calculating the “off-design” performance of compressors and turbines’, Aeronaut. Q. 1958 9, 346.

Hill P. G. ‘Aerodynamic and thermodynamic effects of coolant injection on axial compressors’, Aeronaut. Q. 1963 14, 331.

Stenning A. H. Plourde G. A. ‘The attenuation of circumferential inlet distortion in multi-stage axial compressors’, A.I.A.A. Paper No. 67-415, 1967.

Head M. R. Horlock J. H. ‘Some considerations of the power required for suction where boundary layer control is used to obtain low drag’, unpublished Cambridge University Report, 1958.

Horlock J. H. ‘The relative importance of engine specific weight and fuel consumption in the economics of aircraft operation’, Aero. Res. Coun. Rept No. 29862 1968.

Haywood R. W. ‘Steam cycle calculations for supercritical pressures’, 1957 (unpublished).

Weir C. D. ‘Optimization of heater enthalpy rises in feed-heating trains’, Proc. Instn mech. Engrs 1960 174, 769; see also communication by Haywood, R. W., p. 784.

Weaving J. H. ‘Two-strokes and turbines’, Proc. Auto. Div. Instn mech. Engrs 1968–69 183 (Pt 2A).

Hodskinson M. G. Ph.D. thesis, Liverpool University, 196.

Pollard D. Horlock J. H. ‘A theoretical investigation of the effect of change in axial velocity on the potential flow through a cascade of aerofoils’, Aero. Res. Coun. C.P. No. 619 1963.

‘Members of the N.A.C.A.’, J. Engng Pwr 1961 219, 269.

Carter A. D. S. ‘Blade profiles for axial flow fans, pumps, compressors, etc.’, Proc. Instn mech. Engrs 1961 175, 41.