The basic requirements in the design of bearing testing-machines are examined and the advantages and disadvantages of different general arrangements discussed. Particular attention is given to the subject of friction measurement in bearings. Additional factors arising in the design of a machine for dynamically loaded bearings are considered.
Get full access to this article
View all access options for this article.
References
1.
KettleboroughC. F.DudleyB. R.BaildonE.‘Michell bearing lubrication’, Proc. Instn mech. Engrs1955169, 746.
2.
VinnicombeG. A.‘Factors affecting the hydrodynamic lubrication of parallel surface thrust bearings’1965, Ph.D. thesis, University of Wales.
3.
JohnstonR. C. R.KettleboroughC. F.‘An experimental investigation into stepped thrust-bearings’, Proc. Instn mech. Engrs1956170, 511.
4.
NealP. B.‘Film lubrication of plane-faced thrust pads’, Proc. Instn mech. Engrs Lub. and Wear Conf.1963, Paper 6.
5.
WoolacottR. G.NEL Rep. No. 194, 1965.
6.
ColeJ. A. Discussion on (8).
7.
FoggA.WebberJ. S.‘The influence of some design factors on the characteristics of ball-bearings and roller-bearings at high speeds’, Proc. Instn mech. Engrs1955169, 716.
8.
DavisA. J.KrokT. V.‘Sleeve bearings—Development of a testing-machine’, Proc. Instn mech. Engrs171, 943.
9.
Engineering Sciences Data Item No. 67021, 1967, ‘The design of crossed flexure pivots’.
10.
DowsonD.HudsonJ. D.HunterB.MarchC. N.‘An experimental investigation of the thermal equilibrium of steadily loaded journal bearings’, Instn mech. Engrs Symposium, Nottingham, 1966.
11.
ShawkiG. S. A.FreemanP.‘Journal bearing performance under sinusoidally alternating and fluctuating loads’, Proc. Instn mech Engrs1955169, 689.
12.
CorneliusE. A.BartenE. H.‘Lagerprufmaschine für verschiedene Belastungsarten’, V.D.I. Zeitschrift193983, 1219.
13.
PigottR. J. S, ‘Universal bearing tester’, Trans. A.S.M.E.195779, 1269.
14.
CampbellJ.LoveP. P.MartinF. A.RafiqueS. O.‘Bearings for reciprocating machinery: a review of the present state of knowledge’, Proc. Instn mech. Engrs Conf. Lub. and Wear1967 Paper 4.
15.
WilliamsM. R.‘The design and development of a big-end bearing test machine’, 1965, M.Eng. thesis, University of Sheffield.
16.
BlountE. A.‘Design factors influencing the fatigue resistance of connecting rod big-end bearings’, Proc. Instn mech. Engrs1961175, 513.
