Paper 16: The Utilization of Research Data in Heat-Exchanger Design

Saunders O. A. ‘Engineering and the sciences’. Chart. Mech. Engr 1962 9, 261.

de Malherbe M. C. Ogorkiewicz R. M. ‘Design studies to aid the teaching of synthesis’, Chart. Mech. Engr 1962 9, 317.

Saunders O. A. ‘Some reflections on progress in engineering heat transfer’, Int. Heat Transfer Conf. 1961 Boulder, Colorado.

Diaguila A. J. Livingood J. N. B. ‘Rapid determination of core dimensions of crossflow gas-to-gas heat exchanger’, Tech. Notes nat. adv. Comm. Aero., Wash. No. 3891, 1956 (December).

Eckert E. R. G. Diaguila A. J. ‘Method of calculating core dimensions of crossflow heat exchanger with prescribed gas flows and inlet and exit states’, Tech. Notes nat. adv. Comm. Aero., Wash. No. 3655, 1956 (April).

Eckert E. R. G. Irvine T. F. ‘Selection of optimum configurations for a heat exchanger with one dominating film resistance’, Tech. Notes nat. adv. Comm. Aero., Wash. No. 3713, 1956 (June).

Fairall R. S. ‘A new method of heat exchanger design with specified inlet and outlet conditions’, Trans. Amer. Soc. mech. Engrs 1958 80, 601.

Fax D. H. Mills R. R. ‘Generalized optimal heat exchanger design’, Trans. Amer. Soc. mech. Engrs 1957 79, 653.

Hendry W. B. ‘A systematic approach to the design of compact heat exchangers’, Amer. Soc. mech. Engrs Preprint 59-A-193, 1959.

Jenssen S. K. ‘Assessment of heat exchanger data’, 3rd Nat. Heat Transfer Conf. Connecticut 1959, 195.

Lykondis P. S. Shastri M. R. ‘Determination of core dimensions of crossflow gas-to-gas heat exchangers’, 3rd Nat. Heat Transfer Conf. Connecticut 1959, 177.

Schmidt E. ‘The design of contra-flow heat exchangers’, Proc. Instn mech. Engrs, Lond. 1948 159, 351.

Snell R. J. V. ‘The solution to the dimensions of corrugation-type heat exchangers’, Int. Dev. Heat Transfer 1961, Part I, 110.

Kays W. M. London A. L. Compact heat exchangers 1958 (McGraw-Hill Book Co., New York, London, Toronto).

Koch R. ‘Druckverlust und Wärmeübergang bei verwirbelter Strömung’, VDI-Forschungsheft 469, 1958.

Fishenden M. Saunders O. A. An introduction to heat transfer 1950, 132 (Oxford University Press).

Clauser F. H. ‘The turbulent boundary layer’. Adv. appl. Mech. 1956, IV.

Laufer J. ‘Investigation of turbulent flow in a two-dimensional channel’, Tech. note Nat. Adv. comm. Aero., Wash. No. 1053, 1951.

Corrsin S. and Uberoi M. ‘Extended applications of the hot-wire anemometer’, Tech. Note Nat. Adv. comm. Aero., Wash. No. 1865, 1949.

Yung Lee Private communication, April 1964.

Schlichting H. Boundary layer theory 1955 (Pergamon Press, London).