Effect of Hydrostatic Pressure on the Direct-Stress Fatigue Strength of an Alloy Steel

Abstract

This paper describes tests in which specimens are subjected to cyclically varying direct stress, that is, in ‘push-pull’ with additional tensile and compressive mean stress, both at atmospheric pressure and also while the material is subjected to ambient fluid pressure of the order 3000 atm (20 ton/in²); for this work a novel testing machine was developed.

The results of tests at atmospheric pressure are in good agreement with earlier tests and show that the range of direct stress leading to fatigue failure is a continuous function over the range of mean stress used. When fluid pressure of 20 ton/in² is superimposed on the stress system, the range of reversed stress required to cause fatigue failure is increased by a small, but definite, amount. For the tensile mean stress values investigated the fatigue limit appears to have been raised until it coincides with the range of stress required to cause ‘gross yielding’ with a reduction in area greater than that which occurs in a static tension test at atmospheric pressure. For the compressive mean stress values investigated, fatigue failure has been entirely eliminated.

Get full access to this article

View all access options for this article.

References

Morrison

J. L. M.

Crossland

Parry

J. S. C.

1956 Proc. Instn mech. Engrs, Lond., vol. 170, p. 697, ‘Fatigue Under Triaxial Stress: Development of a Testing Machine and Preliminary Results’.

Crossland

1956 Internat. Conf. Fatigue of Metals, ‘Effect of Large Hydrostatic Pressures on the Torsional Fatigue Strength of an Alloy Steel’ (Instn Mech. Engrs, London).

Parry

J. S. C.

1956 Internat. Conf. Fatigue of Metals, ‘Further Results of Fatigue Under Triaxial Stress’ (Instn Mech. Engrs, London).

Forrest

P. G.

Tapsell

H. T.

1952 Engineering, Lond., vol. 173, p. 757, ‘Correlation of Fatigue Strength in Bending and Direct Stress’.

Chodorowski

W. T.

1956 Internat. Conf. Fatigue of Metals, ‘Fatigue Strength in Shear of an Alloy Steel’ (Instn Mech. Engrs, London).

O'Connor

H. C.

Morrison

J. L. M.

1956 Internat. Conf. Fatigue of Metals, ‘The Effect of Mean Stress on the Push-pull Fatigue Properties of an Alloy Steel’ (Instn Mech. Engrs, London).

Aughtie

1931 Phil. Mag., Series 7, vol. 2, p. 517, ‘A Source of Mechanical Vibration for Experimental Purposes’.

Cox

H. L.

Coleman

E. P.

1950 J. R. Aero. Soc., vol. 54, p. 1, ‘A Note on Repeated Loading Tests on Components and Complete Structures’.

Roberts

M. H.

1952 Metallurgia, vol. 46, p. 107, ‘Precise Measurement of Fatigue Load’.

10.

White

D. J.

1958 Ph.D. thesis University of Bristol, ‘The Effect of Hydrostatic Pressure on the Direct-stress Fatigue Strength of an Alloy Steel’.

11.

Haigh

B. P.

1915 Rep. Brit. Ass., p. 163, ‘The Endurance of Metals Under Alternating Stresses’.

12.

Gough

H. J.

1933 Proc. Amer. Soc. Test. Mater., vol. 33, part II, p. 71, ‘Crystalline Structure in Relation to Failure of Metals—Especially by Fatigue’.