Modelling lubricated revolute joints in multibody mechanical systems

Abstract

This work deals with the modelling of lubricated revolute joints in multibody mechanical systems. In most machines and mechanisms, the joints are designed to operate with some lubricant fluid. The high pressures generated in the lubricant fluid act to keep the journal and the bearing apart. Moreover, the thin film formed by lubricant reduces friction and wear, provides load capacity and adds damping to dissipate undesirable mechanical vibrations. In the dynamic analysis of journal-bearings, the hydrodynamic forces, which include both squeeze and wedge effects, produced by the lubricant fluid oppose the journal motion. These forces are obtained by integrating the pressure distribution evaluated with the aid of Reynolds' equation written for the dynamic regime. The hydrodynamic forces are nonlinear functions of journal centre position and velocity relative to the bearing centre. In a simple way, the hydrodynamic forces built up by the lubricant fluid are evaluated from the state of variable of the system and included into the equations of motion of the mechanical system. Results for an elementary slider-crank mechanism, in which a lubricated revolute joint connects the connecting rod and slider, are used to discuss the assumptions and procedures adopted.

Keywords

lubricated joints dynamic journal-bearings multibody mechanical systems

Get full access to this article

View all access options for this article.

References

Haines

R. S.

Survey: 2-dimensional motion and impact at revolute joints

Mech. Machine Theory, 1980, 15, 361–370.

Ravn

A continuous analysis method for planar multibody systems with joint clearance

Multibody System Dynam., 1998, 2, 1–24.

Schwab

A. L.

Dynamics of flexible multibody systems, small vibrations superimposed on a general rigid body motion. PhD thesis, Delft University of Technology, 2002.

Flores

Ambrósio

Claro

J. C.

Dynamic analysis for planar multibody mechanical systems with real joints. Proceedings of ECCOMAS Thematic Conference on Advances in Computational Multibody Dynamics 2003 (Edited by Ambrósio

), Lisbon, Portugal July 1-4, 2003, p. 26.

Alshaer

B. J.

Lankarani

H. M.

Formulation of dynamic loads generated by lubricated journal bearings. Proceedings of DETC'01, ASME 2001, Design Engineering Technical Conferences and Computers and Information in Engineering Conference, Pittsburg, PA, September 9–12, 2001, p. 8.

Nikravesh

P. E.

Computer-Aided Analysis of Mechanical Systems, 1988 (Prentice-Hall, Englewood Cliffs, NJ).

Baumgarte

Stabilization of constraints and integrals of motion in dynamical systems

Comput. Meth. Appl. Mech. Eng., 1972, 1, 1–16.

Shampine

Gordon

Computer Solution of Ordinary Differential Equations: the Initial Value Problem, 1975 (Freeman, San Francisco, CA).

Pinkus

Sternlicht

S. A.

Theory of Hydrodynamic Lubrication, 1961 (McGraw-Hill, New York).

10.

Hamrock

B. J.

Fundamentals of Fluid Film Lubrication, 1994 (McGraw-Hill, New York).

11.

Phelan

R. M.

Fundamentals of Mechanical Design, 3rd edn, 1970 (McGraw-Hill, New York).

12.

Rahnejat

Multi-body dynamics: Historical evolution and application

Proc. Instn Mech. Engrs, Part C: J. Mechanical Engineering Science, 2000, Vol. 214(C1), (Special Millennium Issue), 149–173.