Numerous recent studies focus on modelling the lubricant flow in macro-textured configurations, using the Navier-Stokes, Stokes, and Reynolds equations. Several of these studies show that important, lift generating inertia effects are present in textured configurations, and conclude that Reynolds assumptions do not hold true for such contacts. A similar analysis is performed in this paper, for parallel sliders of infinite width, but with quite different conclusions. Two main observations are made based on the results presented herein: (a) inertia effects cannot be analysed by single texture cell models - for example, in the case of partial inlet texturing, inertia shows a clear negative influence, contradicting the previously reported lift generating effects; (b) the validity of Reynolds equation in textured sliders cannot be decided by the Reynolds number (Re) alone, and the texture aspect ratio (λ) has an equally important influence on Reynolds equation validity. Finally, charts presenting the relative difference between Reynolds and Navier-Stokes solutions in terms of λ and Re are discussed.
RightmireG. K.BillR. G.AndersonH. G.‘On the flow perturbations and friction reduction introduced by surface dimples. In Proceedings of the 14th Leeds-Lyon Symposium on Tribology, 1987, pp. 139–143.
2.
EtsionI.KligermanY.HalperinG.‘Analytical and experimental investigation of laser-textured mechanical face seals’STLE Tribol. Trans.42 (1999): 511–516
BuscagliaG. C.CiupercaI.JaiM.‘The effect of periodic textures on the static characteristics of thrust bearings’ASME J. Tribol.127 (2005): 899–902
9.
AusasR.RagotP.LeivaJ.JaiM.BayadaG.BuscagliaG. C.‘The impact of the cavitation model in the analysis of microtextured lubricated journal bearings’ASME J. Tribol.129 (2007): 868–875
10.
DobricaM. B.FillonM.PascoviciM. D.CiconeT.‘Texturing effects in plane-inclined sliders. In the STLEASME Internation Joint Tribology Conference, IJTC2007-44258, CD, San Diego, USA, 22–24 October 2007, pp. 1–3.
11.
ArghirM.RoucouN.HeleneM.FreneJ.‘Theoretical analysis of the incompressible laminar flow in a macro-roughness cell’ASME J. Tribol.125 (2003): 309–318
12.
SahlinF.GlavatskihS. B.AlmqvistT.LarssonR.‘Two-dimensional CFD-analysis of micro-patterned surfaces in hydrodynamic lubrication’ASME J. Tribol.127 (2005): 96–102
13.
KrakerA.OstayenR. A. J.BeekA.RixenD. J.‘A multiscale method modelling surface texture effects’ASME J. Tribol.129 (2007): 221–230
14.
LiJ.ChenH.‘Evaluation on applicability of reynolds equation for squared transverse roughness compared to CFD’ASME J. Tribol.129 (2007): 963–967
15.
DobricaM. B.FillonM.‘Reynolds’ model suitability in simulating rayleigh step bearing thermohydro-dynamic problems’STLE Tribol. Trans.48 (2005): 522–530
16.
WangX.KatoK.AdachiK.AizawaK.‘The effect of laser texturing of SiC surface on the critical load for the transition of water lubrication mode from hydrodynamic to mixed’Tribol. Int.34 (2001): 703–711
17.
WangX.KatoK.AdachiK.AizawaK.‘Loads carrying capacity map for the surface texture design of sic thrust bearing sliding in water’Tribol. Int.36 (2003): 189–197
PetterssonU.JacobsonS.‘Influence of surface texture on boundary lubricated sliding contacts’Tribol. Int.36 (2003): 857–864
20.
SiripuramR. B.StephensL.S.‘Effect of deterministic asperity geometry on hydrodynamic lubrication’ASME J. Tribol.126 (2004): 527–534
21.
VenkatesanS.StephensL.S. ‘Surface textures for enhanced lubrication: fabrication and characterization techniques’ (2005)
22.
GlavatskihS. B.McCarthyD. M. C.SherringtonI.‘Hydrodynamic performance of a thrust bearing with micropatterned pads’STLE Tribol. Trans.48 (2005): 492–498
23.
KovalchekoA.AjayiO.ErdemirA.FenskeG.EtsionI.‘The effect of laser surface texturing on transitions in lubrication regimes during unidirectional sliding contact’Tribol. Int.38 (2005): 219–225
24.
MourierL.MazuyerD.LubrechtA. A.DonnetC.‘Transient increase of film thickness in micro-textured EHL contacts’Tribol. Int.39 (2006): 1745–1756
25.
AnderssonP.KoskinenJ.VarjusS.GerbigY.HaefkeH.GeorgiouS.ZhmuddB.BussW.‘Microlubrication effect by laser-textured steel surfaces’Wear262 (2007): 369–379
26.
KřupkaI.HartlM.‘The effect of surface texturing on thin EHD lubrication films’Tribol. Int.40 (2007): 1100–1110
27.
CostaH. L.HutchingsI. M.‘Hydrodynamic lubrication of textured steel surfaces under reciprocating sliding conditions’Tribol. Int.40 (2007): 1227–1238
28.
MarianV. G.KilianM.ScholzW.‘Theoretical and experimental analysis of partially textured thrust bearing with square dimples’Proc. IMechE, Part J: J. Engineering Tribology221 (2007): 771–778
29.
FeldmanY.KligermanY.EtsionI.HaberS.‘The validity of the reynolds equation in modelling hydrostatic effects in gas lubricated textured parallel surfaces’ASME J. Tribol.128 (2006): 345–350
30.
ArghirM.AlsayedA.NicolasD.‘The finite volume solution of the reynolds equation of lubrication with film discontinuities’Int. J. Mech. Sci.44 (2002): 2119–2132
31.
DobricaM. B.FillonM.‘Thermohydrodynamic behavior of a slider pocket bearing’ASME J. Tribol.128 (2006): 312–318
