An experimental investigation of various materials on thrust washer bearing operation

Abstract

Abstract

The current research experimentally quantifies and maps the behaviour of various thrust washer configurations under various conditions. The bearings are tested at controlled loads and speeds for a governed period of time (up to 14 h) or until failure. The experimental results show that at some loads and speeds the bearing operates with a near full hydrodynamic film and under more harsh conditions it operates in the boundary lubrication regime. The experimental results indicate that coatings enhance performance by decreasing friction and thus decreasing the heat generated. By decreasing the generated heat, the physical mechanisms of thermoelastic instability and thermoviscous distress are less likely to occur. Using bronze will decrease the friction between the bearings, although it may also decrease the life of the bearing. However, using more than one round washer appears to not significantly benefit washer-bearing performance.