Failure mechanisms of the head-tape interface during head stepping in a linear tape drive

Abstract

Improving the performance of computer tape drives is an ongoing process. The magnetic and tribological performance of metal particle (MP) tape during head stepping was evaluated in a commercial linear tape drive. Head output and head-tape interface friction were monitored during short-pass (10m) shuttling tests with stepping of the head. The test without stepping showed no signs of failure. To evaluate the effect of stepping on the head-tape interface, three different kinds of stepping test, namely normal stepping, reverse stepping and normal stepping with inverted drive, were performed. All these tests with head stepping failed far sooner than the test without stepping. Non-parallelism between the head and tape surfaces caused a reduction in hydrodynamic air bearing pressure. Less spacing between the lower tape edge and the head resulted in high wear of the lower edge of the tape and outer outrigger surfaces of the head. Additional sliding in a direction orthogonal to the tape motion from head stepping aggravated the friction and wear of the lower tape edge. The inability of the drive to overcome this high friction ultimately resulted in failure. On the head surface, different kinds of debris were found, and unsymmetrical debris distribution was observed. Some manufacturing improvements are presented to prolong drive durability.

Keywords

magnetic tape tribology head stepping linear tape drive non-parallelism of head

Get full access to this article

View all access options for this article.

References

Bhushan

Tribology and Mechanics of Magnetic Storage Devices, 2nd edition, 1996, p. 53 (Springer-Verlag, New York).

Bhushan

Patton

S. T.

Tribology in ultra-high density tape drive systems: State of the art and future challenges

IEEE Trans. Magn., 1998, 34, 1883–1888.

Luitjens

S. B.

Rijckaert

A. M. A.

The history of consumer magnetic video tape recording, from a rarity to mass product

J. Magn. and Magn. Mater., 1999, 193, 17–23.

Topoleski

J. J.

Bhushan

Magnetic and tribological evaluation of MP and ME tapes in a linear tape drive

Proc. Instn Mech. Engrs, Part J, Journal of Engineering Tribology, 2001, 215, 157–171.

Scott

W. W.

Bhushan

Loose debris and head stain generation and pole tip recession in modern tape drives: A critical review (invited)

J. Inf. Stor. Proc. Syst., 2000, 2, 221–254.

Kattner

Bhushan

Analysis of stain formation and wear mechanisms of MR heads and MP tape in a linear tape drive

J. Inf. Storage Proc. Syst., 2000, 2, 193–205.

Bhushan

Mechanics and Reliability of Flexible Magnetic Media, 2nd edition (Springer-Verlag, New York).

Hunter

S. J.

Bhushan

Debris propensity of magnetic metal particle tapes

J. Inf. Storage Proc. Syst., 2001, 3, 143–159.

Bhushan

Mokashi

P. S.

Effect of cycling on debris propensity in a linear tape transport

J. Inf. Storage Proc. Syst., 2001, 3, 267–275.

10.

Scott

W. W.

Bhushan

Measurement and prediction of tape cupping under mechanical and hygrothermal loads and its influence on debris generation in linear tape drives

ASME J. Tribol., (in press).

11.

Scott

W. W.

Bhushan

Pole tip recession in linear tape heads: Measurement technique and influence of head materials, tape speed, and tape tension

Proc. Instn Mech. Engrs, Part J, Journal of Engineering Tribology, 1999, 213, 139–150.

12.

Quantum DLT University Handbook, 1997 (Quantum Corporation, Milpitas, California).