With the many different lubricants available for similar purposes today, the choice that the engineer must make is often based on arbitrary assumptions or confined to personal experience. In the present paper, the authors present a new technique of determining the suitability of potential lubricants for the deep drawing process. The technique is also applicable to many metal forming processes where lubricant selection is critical to the success of the operation.
KrimJ.Friction at the atomic scaleScient. Am., October 1996, 48–56.
2.
BoydM. R.An investigation of the friction and lubrication effects in the deep drawing process through simulative and empirical testing. DPhil thesis, University of Ulster, 1996.
3.
WilsonW. R. D.Mixed lubrication in metal forming processesAdvd Technol. Plasticity, 1990, 4, 1667–1676.
LinJ. F.Friction in deep drawing of aluminium sheetWear, 1992, 156, 189–199.
6.
MahdavianS. M.ShaoZ. M.Isoviscous hydrodynamic lubrication of deep drawing and its comparison with experimentJ. Tribology, 1993, 115, 111–118.
7.
Deep drawing and pressing: some faults and defects; causes and remedies. In Sheet Metal Industries Yearbook, 1994, Ch. 3, Part 1, pp. 223–224 (Redhill International Business and Technical Magazines).
8.
PaulS. J.Kinetic friction of lubricated contacts in the deep drawing process. DPhil thesis, University of Ulster, 1997.
9.
MarquardtD. W.An algorithm for least squares estimation of non-linear parametersJ. Soc. Ind. Appl. Math., 1963, 2, 431–441.
