Experimental investigations of rotating flow instabilities in the last stage of a low-pressure model steam turbine during windage

Abstract

Abstract

Experimental investigations on two different three-stage low-pressure (LP) model turbines operated on steam during windage are presented. At very low flows, strain gauges identified that the two turbines exhibit different dynamic stress characteristics of the last-stage rotor blades. The first turbine experienced the highest vibrations from aerodynamic excitations at the resonant frequency of the second mode in a narrow operating range around 13 per cent of the design flow, whereas the second turbine experienced no resonance up to the fourth mode and has the highest dynamic loading at zero flow.

Specially developed high-response total pressure probes have been used to determine the cause of the aerodynamic excitation from traverses of the unsteady pressure field at three planes in the last stage. The experimental data for both turbines show that unsteady pressure disturbances steadily grow when the flow is reduced below 25 per cent of design flow and that the excitations are strongest in the axial gap between the guide vane and the rotor of the last stage near the outer casing. Detailed analysis shows that high-amplitude disturbances occur at distinct frequencies and that these rotate in the circumferential direction at a fraction of the rotor speed. Comparison of the pressure signals measured at two circumferential locations on the casing of the second turbine confirmed the characteristic frequency pattern to be a so called ‘rotating instability’. This unsteady phenomenon arising from the tip leakage flow has previously been observed in axial flow fans and compressors and is demonstrated for the first time here in a turbine operating at very low flow rates.